Lab 2: The Chemistry of Life Name _____Aniqa Qureshi_ Insert the chemical symbol in the answer blank for each of the following elements. ___O______ 1. oxygen ___C______ 2. carbon ___K______ 3. potassium ___I______ 4. iodine ___H______ 5. hydrogen ___N______ 6. nitrogen ____Ca_____ 7. calcium ____Na_____ 8. sodium ____P_____ 9. phosphorus ____Mg_____ 10. magnesium ____Cl_____ 11. chloride ____Fe_____ 12. iron In the space below‚ list the chemicals (above) from the MOST
Premium Chemistry Chemical reaction DNA
to determine the molarity of NaOH‚ we rinsed a burette with about 5ml of water and another 5ml of NaOH to prepare it for the experiment. We then measured exactly 25ml of the prepared KHP from the previous part into a 250ml Erlenmeyer flask and added 2 drops of the indicator‚ phenolphthalein. Next we filled the burette with the approximately 0.1 M NaOH so that our initial volume will be 0.0mls. We then started our titration by carefully pouring a little amount of the base into the prepared 25ml of
Premium Acid dissociation constant Acetic acid Titration
The purpose of this lab was to see which solutions are soluble and which are not. We were able to see this by mixing certain solutions together and observing changes that occurred. The procedure for this experiment included a few different steps. The first steps were to add the nitrate solutions into the lettered parts of the 96-well plate. Once you were done with that‚ you were supposed to add the sodium solutions to the numbered parts of the 96-well plate‚ so that the solutions were added together
Premium Ion Solubility Chemistry
Chemistry 121 Colligative Properties Lab Demonstration of Selected Calculations from Choice I Determination of Kf for Naphthalene To determine the Kf for naphthalene‚ we need to find the difference in the freezing point of pure naphthalene and the solution of 1‚4-dichlorobenzene in naphthalene. Let’s say that we did this experiment‚ used 1.00 g 1‚4-dichlorobenzene in 10.00 g naphthalene‚ and found that the freezing temperature of pure naphthalene was 78.2°C‚ while that of the solution was 75
Premium Chemistry Atom Oxygen
macroscopic properties of five chemical systems at equilibrium 2. to observe shifts in equilibrium concentrations as stresses are applied to the systems 3. to observe a shift in equilibrium concentrations associated with changes in temperature 4. to explain the observations obtained by applying Le Chatelier’s principle Materials Required: See page 209 Heath Chemistry Laboratory Experiments Procedure: See pages 209-211 Heath Chemistry Laboratory Experiments Data and Observations:
Premium Chemistry Experiment Hypothesis
ATLANTIC COLLEGE CHEMISTRY DEPARTMENT (Written by Dr Geoffrey Neuss) CONTENTS Page Introduction 1 Assessment of Practical Work 3 Error and uncertainty 7 Significant figures 8 Title 1. Some common chemical reactions. 9 2. A traditional acid-alkali titration. 10 3. Analysis of aspirin tablets
Premium Titration Chemistry Assessment
October 13‚ 2012 Needle through a Balloon Pre-Lab Preparations: Purpose: The purpose of this experiment is to see if the balloon pops when pierced with a wooden skewer or a sharp pin. Hypothesis: If we lubricate the skewer with petroleum jelly‚ then it should go through the balloon without popping. Hypothesis for the 2nd part of the Lab: If we cover the side of the balloon with cellophane tape‚ then it will not pop when pierced with the pin. Materials: • Balloons • Long wooden
Premium Hypothesis Observation Stanford prison experiment
Jashandeep Gill Gammellos Chemistry Density is one of the fundamental principles of physics. Density is the reason why a plank of wood floats on water while a piece of metal several times smaller will sink. Density of an object is measured in g/cm³ or g/cc. The equation is D=M/V‚ D being the density of the object‚ M being the mass of the object‚ and V being the volume of the object. Mass is the space an object takes up. It is the amount of matter present in an object. Mass is measured using
Free Density Water Kilogram
Procedure Access the virtual lab and complete the experiments. Part One (Flame Test): 1. Create and complete a data table for Part One of the lab. It should include the name of the element (or unknown) examined and the color of the observed flame: Barium-green Calcium-red Sodium-yellow Rubidium-purple Potassium-blue Lithium-pink 2. Identify each unknown from Part One of the lab and briefly explain why you identified each unknown as you did.: Unknown 1-yellow. I think it is Sodium because
Premium Light Atom Color
Regents Chemistry Quarter 1 Midterm Review 1. The percent by mass of oxygen in Na2SO4 (formula mass = 142) is closest to 1) 11% 3) 45% 2) 22% 4) 64% 2. Given the unbalanced equation: __Al(s) + __O2(g) → __Al2O3(s) 3. 4. 5. 6. 7. balance the equation using smallest whole number coefficients. The percent by mass of aluminum in Al2O3 is approximately 1) 18.9 3) 47.1 2) 35.4 4) 52.9 What is the approximate percent composition by mass of CaBr2 (formula mass = 200)
Premium Water Ideal gas law Melting point