Writing an Organic Chemistry Lab Report Components of a Laboratory Notebook The following components should be contained for each experiment‚ along with any additional material required by your instructor. • Title and date • Introduction (purpose‚ reaction) • Physical data (including calculations) • Procedure outline • Data and observations • Discussion of results (conclusions) Prelab Title and Date Give the title of the experiment and the date on which
Premium Chemistry
The lab was to include a purpose‚ procedure‚ data/observations‚ all reactions and side reactions written out with qualitative data beneath each product and reactant except H20‚ and a summary. The purpose of this experiment is to observe the qualitative aspects of a series of reactions involving copper. Procedure 1.Measure about 1g of solid copper. 2.Place Cu in Erlenmeyer flask and place flask under fume hood. 3.Add dropwise 15M HNO3 until solid copper is completely reacted. 4.Place flask
Premium Solid Crystal Liquid
Example lab report of Synthesis of potassium tris (oxalato) ferrate (III) trihydrate Posted by Nurul Yunaliyana Experiment 5: Synthesis of potassium tris (oxalato) ferrate (III) trihydrate Purpose: to synthesis potassium tris (oxalato) ferrate (III) trihydrate ‚K3 [Fe (C2O4)3].3H2O. Introduction: Ferrous ammonium sulfate‚ Fe(NH4)2(SO4)2.6H2O is dissolved in a slightly acid solution‚ excess oxalic acid‚ H2C2O4‚ is added and the following reaction takes place: Fe(NH4)2(SO4)2.6H2O + H2C3O4
Premium Chemistry Iron Ammonia
ESTIMATION OF IRON IN IRON ORE-SPECTROPHOTOMETRIC METHOD By: Taylor Villari Experiment conducted on 7/22/13 Components of each test tube examined in the spectrophotometer Trial | Volume of Iron solution (mL) | Micrograms of Iron | Volume of 10% sodium acetate | Volume of 0.1% o-phenanthroline | Volume of water (mL) | 1(blank) | 0.0 | 0.0 | 1.0 mL | 1.0 mL | 8.0 mL | 2 | 1.0 mL | 10 | 1.0 mL | 1.0 mL | 7.0 mL | 3 | 3.0 mL | 30 | 1.0 mL | 1.0 mL | 5.0 mL | 4 | 5.0 mL | 50 | 1.0 mL
Premium Spectroscopy Water Laboratory glassware
October 13‚ 2012 Needle through a Balloon Pre-Lab Preparations: Purpose: The purpose of this experiment is to see if the balloon pops when pierced with a wooden skewer or a sharp pin. Hypothesis: If we lubricate the skewer with petroleum jelly‚ then it should go through the balloon without popping. Hypothesis for the 2nd part of the Lab: If we cover the side of the balloon with cellophane tape‚ then it will not pop when pierced with the pin. Materials: • Balloons • Long wooden
Premium Hypothesis Observation Stanford prison experiment
| The Chemistry of Natural Waters | Chem 111 Sec 104 | | Hyunjung Hwang | 11/6/2012 | TA: Sarah Boehm‚ Group members: Rachel Hoffman‚ Dan Hirt | Introduction Water hardness is a major part of overall water quality that affects many industrial and domestic water users. Water is considered hard when there are high concentrations of the divalent cations Magnesium and Calcium; water hardness is considered as the sum of both the calcium and magnesium concentrations and expressed as
Premium Water Calcium Hard water
Discussion: The experiment lacked a proper control - While the experiment could not answer the research question‚ this does not disprove the possibility for the choice of bread to affect blood glucose levels; the obtained results were simply not sufficient to prove a connection. This might be due to several reasons‚ but as the experiment lacked a control subject which the other values could have been compared to‚ the results are completely unusable. However‚ there is no consistency in the results
Premium Scientific method Psychology Research
The purpose of this lab was to model the significant differences in density that oceans experience when glaciers and polar ice caps melt. It demonstrated that the variation in density greatly affects salt water. I discovered that the increase in freshwater causes a decrease in density. I made three claims. First‚ the higher the salinity of the water is‚ the denser it will be. This was shown in my data by the fact that‚ with 0mL of fresh water‚ the density was 1.108 g/mL For every milliliter of fresh
Premium Global warming Climate change Water
Regents Chemistry Quarter 1 Midterm Review 1. The percent by mass of oxygen in Na2SO4 (formula mass = 142) is closest to 1) 11% 3) 45% 2) 22% 4) 64% 2. Given the unbalanced equation: __Al(s) + __O2(g) → __Al2O3(s) 3. 4. 5. 6. 7. balance the equation using smallest whole number coefficients. The percent by mass of aluminum in Al2O3 is approximately 1) 18.9 3) 47.1 2) 35.4 4) 52.9 What is the approximate percent composition by mass of CaBr2 (formula mass = 200)
Premium Water Ideal gas law Melting point
– Separating Sand & Salt Purpose: The purpose of this experiment is to separate a mixture of sand and salt. Materials: Small beaker Electric balance Sand Salt Water Graduated cylinder Stirring rod Filter paper Flask Rubber policeman Wash bottle Funnel Bunsen burner complete with rubber tubing and a source of gas Hot hands Insulator pad Ring stand complete with a ring Wire gauze Striker Pre-lab Questions: 1. Water will be useful in separating the salt and sand because salt is soluble in water‚
Premium Evaporation Water Laboratory equipment