Tree Paper
Which is the correct symbol for the stalling speed or the minimum steady flight speed in a specified configuration?
C) VS1
Longitudinal dynamic instability in an airplane can be identified by
B) pitch oscillations becoming progressively steeper
True course measurements on a Sectional Aeronautical Chart should be made at a meridian near the midpoint of the course because the3
C) angles formed by lines of longitude and the course line vary from point to point.
Regulations which refer to "operate" relate to that person who
C) causes the aircraft to be used or authorizes its use
To act as pilot in command of an aircraft operated under 14 CFR part 91, a commercial pilot must have satisfactorily accomplished a flight review or completed a proficiency check within the preceding
C) 24 months
Each required flight crewmember is required to keep his or her shoulder harness fastened
A) during takeoff and landing, unless he or she is unable to perform required duties
To increase the rate of turn and at the same time decrease the radius, a pilot should
A) increase the bank and decrease airspeed.
Dashed lines on a Surface Analysis Chart, if depicted, indicate that the pressure gradient is
B) weak.
One of the most dangerous features of mountain waves is the turbulent areas in and
C) below rotor clouds.
Weather Advisory Broadcasts, including Severe Weather Forecast Alerts (AWW), Convective SIGMETs, and SIGMETs, are provided by
C) ARTCCs on all frequencies, except emergency, when any part of the area described is within 150 miles of the airspace under their jurisdiction.
Which is the best technique for minimizing the wing-load factor when flying in severe turbulence?
C) Set power and trim to obtain an airspeed at or below maneuvering speed, maintain wings level, and accept variations of airspeed and altitude.
The reason for variations in geometric pitch (twisting) along a propeller blade is that it
A) permits a relatively constant
C) VS1
Longitudinal dynamic instability in an airplane can be identified by
B) pitch oscillations becoming progressively steeper
True course measurements on a Sectional Aeronautical Chart should be made at a meridian near the midpoint of the course because the3
C) angles formed by lines of longitude and the course line vary from point to point.
Regulations which refer to "operate" relate to that person who
C) causes the aircraft to be used or authorizes its use
To act as pilot in command of an aircraft operated under 14 CFR part 91, a commercial pilot must have satisfactorily accomplished a flight review or completed a proficiency check within the preceding
C) 24 months
Each required flight crewmember is required to keep his or her shoulder harness fastened
A) during takeoff and landing, unless he or she is unable to perform required duties
To increase the rate of turn and at the same time decrease the radius, a pilot should
A) increase the bank and decrease airspeed.
Dashed lines on a Surface Analysis Chart, if depicted, indicate that the pressure gradient is
B) weak.
One of the most dangerous features of mountain waves is the turbulent areas in and
C) below rotor clouds.
Weather Advisory Broadcasts, including Severe Weather Forecast Alerts (AWW), Convective SIGMETs, and SIGMETs, are provided by
C) ARTCCs on all frequencies, except emergency, when any part of the area described is within 150 miles of the airspace under their jurisdiction.
Which is the best technique for minimizing the wing-load factor when flying in severe turbulence?
C) Set power and trim to obtain an airspeed at or below maneuvering speed, maintain wings level, and accept variations of airspeed and altitude.
The reason for variations in geometric pitch (twisting) along a propeller blade is that it
A) permits a relatively constant