# Cellular Respiration Lab Report

Satisfactory Essays
306 Words
Grammar
Plagiarism
Writing
Score
Cellular Respiration Lab Report
Measuring the rate of cellular respiration in yeast within different types of sugar
Aim/Reasearch Question: How can the rate of cellular respiration be measured to find out if sucrose, dextrose, lactose, or maltose lets the yeast to respire more than others.
Hypothesis: I think, dextrose yeast solution will respire the most number of bubbles because it is the simplest sugar to break.
Materials:
* Knut * Dropper * Graduated cylinder (100ml) * Warm water * Yeast Solution * Sucrose * Dextrose * Lactose * Maltose
Variables:
Independent Variables: * The type of sugar
Dependent Variables: * The number of bubbles counted as output
Controlled Variables: * Amount of sugar * Amount of yeast
…show more content…
Prep the yeast solutions in 500ml beakers by adding the wild yeast powder and water in the beaker. (Repeat this step with four other 500ml beakers) 2. Add sucrose to one beaker filled with yeast, add maltose with the other, add lactose with another, and finally, add dextrose to the last one. 3. Put in sucrose-yeast solution with the dropper and rinse off any excess yeast that is on the outside of the dropper 4. Prepare as shown in the diagram below : |

5.) Record how many bubbles come out after 5 minutes
6.) Repeat steps 2-5 with maltose yeast solution (not sucrose yeast solution)
7.) Repeat steps 2-5 with lactose yeast solution (not sucrose yeast solution)
8.) Repeat steps 2-5 with destrose yeast solution (not sucrose yeast solution)

Table 1 : Number of bubbles released from yeasts with different sugars after 5 minutes | Dextrose-yeast solution | Sucrose-yeast solution | Maltose-yeast solution | Lactose-yeast solution | Number of bubbles released after 5 min | | | | |

Conclusion: ____________________________________________________________

____________________________________________________________

## You May Also Find These Documents Helpful

• Satisfactory Essays

4. If the yeasts metabolism was slowed down, the product would stop rising. This could be done by using the variables, light and temperature. Both of these variables would affect the product from rising.…

• 413 Words
• 2 Pages
Satisfactory Essays
• Satisfactory Essays

Bring 5 quarts of water to boil and dissolve the sugar in the water. Remove from heat and add frozen concentrate. Add additional water to make five gallons and pour into secondary. Add remaining ingredients except yeast. Cover with cloth fastened with rubber band and set aside 12 hours. after cooling to proper yeast temperature, add activated yeast and recover with…

• 434 Words
• 2 Pages
Satisfactory Essays
• Better Essays

Figure 1. The rate of cellular respiration over time in the carbohydrate compounds glucose, fructose, lactose, galactose, sucrose, honey, and water. The final absorbance rates for glucose was 1.8, fructose 1.7, lactose 0.6, galactose 0.6, sucrose 1.5, honey 1.6, and water 0.6.…

• 1719 Words
• 7 Pages
Better Essays
• Satisfactory Essays

The purpose of this lab is to answer the research question: “Does the concentration of sucrose affect the rate of cellular respiration in yeast?” What do you think?…

• 310 Words
• 2 Pages
Satisfactory Essays
• Good Essays

4. After rinsing graduated cylinder measure 10 mL lemon juice and add that to 40 mL of distilled water. Then pour this solution into the final clean beaker…

• 1094 Words
• 5 Pages
Good Essays
• Good Essays

For unit 7.3 the experiment needed 2 microfuge tubes one labeled "L" for lactose and the other labeled "M" for maltose. The experiment also called for a total of 3 clean plastic pipettes. With one pipette add milk up to the 0.5 line of the lactose tube. With the second clean pipette add maltose solution up to the 0.5 line of the maltose tube. With the third clean pipette, add lactase solution to each tube, until the level of mixture in each tube comes up to the 1.0 line of the tube. Place both tubes in the 40 degrees celsius water bath and incubate them for 10 minutes. The other thing needed is glucose strips. After the tubes have been incubated for 10 minutes, place a glucose strip in each tube for one second. Let it sit for thirty seconds, then compare to the chart provided. For unit 7.4 the experiment called for two microfuge tubes. One labeled "control" and label another one "EDTA". Add 1.25 mL of EDTA to the EDTA tube, add 1.25mL of distilled water to the control tube. Add 3 drops of milk to each tube, invert the tube and let sit for 1 minute. Then add 3 drops of lactase solution to each tube. Then place both tubes in the 40 degrees celsius water bath and leave them for 10 minutes. After the 10 minutes are up, place the glucose strip in each tube and let the strips sit for 30 seconds. Then compare to the charts provided.…

• 542 Words
• 3 Pages
Good Essays
• Better Essays

Part B: To investigate whether yeast has the ability to ferment other sugars and artificial sweeteners and how lactase influences their ability to use lactose as a food source.…

• 788 Words
• 4 Pages
Better Essays
• Better Essays

A solution of yeast and glucose was prepared with different concentration of enzymes. In All the tubes water, 0.3M glucose and yeast was placed; with the exception of some tubes in which 0.2M MgSo4 and 2.5mL and 1.4ML 0.2 NaF was placed respectively. In another tube was placed both MgSO4 and NaF. The different solutions were prepared and placed in separate tubes for the experiment. A 45oC water bath was setup to be used for the fermentation process.…

• 1006 Words
• 5 Pages
Better Essays
• Good Essays

The two types of fermentation that are well known are alcoholic fermentation as well as lactic acid fermentation. Fermentation is vital for many organisms, such as yeast and bacteria, because it allows them to obtain energy required to carry on life processes. Alcoholic fermentation is especially important for human beings, as it is used to produce alcoholic beverages, bread, and many other everyday items that are consumed (Alba-Lois, 2010). On the other hand, lactic acid is a waste product of certain bacteria (Lactobacillales), which is utilized to create many dairy products such as yogurt and cheese. In addition, humans can resort to lactic acid fermentation when oxygen is limited, so it is used as an extra source to obtain oxygen. In our experiment we will be using yeast, a single-celled organism that utilizes sugar as a food source, and it produces energy substances through the breakdown of sugar molecules. Specifically, the type of sugar as a source of food, impacts the speed of fermentation in yeast. In this lab, we will calculate the rate of fermentation in yeast with different solutions of sugar, such as sucrose, fructose, and lactose with glucose being the control. It is important to humans that the yeast uses the best sugar source during fermentation, as it creates important everyday items we consume like bread, alcohol, and…

• 452 Words
• 2 Pages
Good Essays
• Powerful Essays

In this experiment yeast ferment sugars anaerobically. When yeast ferments the sugars anaerobically, however, CO2 production will cause a change in the weight of the sugar/yeast-solution. This raises a further question: What is the effect of different kinds of sugars on the fermentation process of yeast? The fermentation process was followed at a constant temperature and four different types of sugars were used. By measuring the release of carbon dioxide, we could see what type of sugar had the biggest effect on the fermentation process of yeast, which resulted in Sacharose.…

• 1136 Words
• 5 Pages
Powerful Essays
• Satisfactory Essays

What sugar will get the most rise out of yeast, so you can get the best bread or baked goods possible. Sugar when mixed with yeast and water will produce carbon dioxide. The carbon dioxide from the yeast sugar and warm water will make the balloon on top of the water bottle blow up. I hypothesize that brown sugar will make the balloon blow up the most…

• 382 Words
• 2 Pages
Satisfactory Essays
• Better Essays

If substrate concentrations are changed, then as the concentration increase, the rate of anaerobic reaction will also increase, because the increase of the reactant concentration means there are more reactant particles, and there is a greater chance for these particles to collide and let reaction happen.…

• 876 Words
• 4 Pages
Better Essays
• Good Essays

The rate of fermentation is faster when there is more sucrose concentration because it means there is more glucose, which in return means more carbon dioxide production. The sucrose concentrations were 0%, 1%, 5%, and 10%. The 0% sucrose concentration is just normal, plain water. Yeast, a single celled eukaryotic fungi, was put into the solutions. It uses fermentation to make more carbon dioxide and alcohol. In the 0% solution, no carbon dioxide had been produced. At the start, the depth of the carbon dioxide bubbles were 0.5cm and at 20 minutes, it went down to 0.1 cm. The balloon inflation also increased. At the start obviously the balloon is deflated which every four of the balloons are. But in the 0% tube there was a human error. While…

• 753 Words
• 4 Pages
Good Essays
• Good Essays

Water is not fermented.” The outcome of my experiment did not support my hypothesis. The results showed glucose did ferment the easiest, but it was followed by sucrose as opposed to fructose, fructose was after sucrose then the starch. Luckily, my test control did work as expected. This experiment proved that yeast depends on glucose as its’ main source of energy. This happens when glucose is reduced to pyruvate which leads to the fermentation of carbon dioxide and ethanol.…

• 641 Words
• 3 Pages
Good Essays
• Good Essays

When we experimented we set out all of our materials. Our materials were a fermentation bottle, one rubber stopper, one bubbler, one measuring beaker, 2 ml of yeast, 10 ml of warm water, and 30 ml of corn syrup. The first step we took was taking the measuring beaker, measuring 10 ml of warm water, and adding the 10 ml of warm water to the fermentation bottle. We then took the measuring beaker again, measured 2 ml of yeast, and added the 2ml of yeast to the warm water in the fermentation bottle. After that, we mixed both yeast and water gently until it was thoroughly dissolved. Then we took our measuring beaker again, measured 30 ml of corn syrup, and added the corn syrup to the mixture in the fermentation bottle. Soon after that, we swirled our mixture together. Then we put the rubber stopper on the fermentation bottle. We then took our bubbler and filled the bubbler with water until the water settled into the bottom and up to fill the two lines. We then inserted the bubbler…

• 483 Words
• 2 Pages
Good Essays