When Referring to Clocking

a) When reffering to clocking, the CSU/DSU is this piece of equipment. Data circuit-terminating equipment b) The software used by a router. Cisco IOS c) Dialup and ISDN are examples of these tyoes of networks. Circuit Switching d) Describes the timing between the router and the CSU/DSU. Synchronous e) Lost when a device is powered down or rebooted. Contents of RAM f) Wires or other media through which data is transmittied from one palce to another. Serial Link g) Connects LANs to WANs. Interface h) The physical connection point on networking devices where data enter and exit. Router i) A smaller, more compact physical interface specification. Smart serial interface j) A WAN link contracted for use by the customer. Leased line k) Frame relay and ATM are examples of these types of networks. Packet-switching l) When reffering to clocking the customer’s router, this piece of equipment is used. Data terminal equipment (DTE) m) A communication link that is outside the normal IP network, like a console cable or phone cal between to modems and the AUX port. Out-of-band Management n) A network that spans a large geographical network. Wide area network (WAN) o) A telecommunication path that sends one bit at a time. Serial interface p) The router port that connects a WAN. Bus q) A WAN service provider. Telephone company (Telco) r) Connects a router to the CSU/DSU. Serial cable s) The managerment port on a router. Console port t) Equipment that is located on the customer’s wiring closet and provies clocking signal to the router. CSU/DSU u) A general term that describes the measurement of a route. Metric v) If a device does not know how to get to a destination , it sends data to this device. Default gateway w) The number of bits per second that the service provider can accept and send to the customer. Clocking/clock rate x) Whet the WAN service provider calls your collection of