Percent Error occurs due to many factors. In this lab by the graph I can state that there was a 100% error in all three unknown substances‚ Pure Leaf Lemon Tea‚ Sprite‚ and Tree Ripe Lemonade. This could be a result of not having properly zeroed the scale or the scale glitching when it came to zeroing it‚ which would have added extra mass and skewed the results. Another factor that could have resulted in a high percent error would have been the scale itself glitching which would have caused the wrong
Premium
Abstract: All the materials were measured and weighed. It was found in the experiment that the yield of copper hydroxide in 40%. Introduction: The copper (II) sulphate is then placed in 100 mL of distilled water. Then 20 mL of CuSO4 is measured and placed 100 mL of distilled water. This can later be weighed to determine the mol of CuSO4 and the mol/L concentration. Then this was used to find out how many mL of 0.5 NaOH solution is needed to react completely with all the copper (II)
Premium Sodium hydroxide Mole Kilogram
Write the complete balanced equation for the reaction that occurred in this lab. Hint: H2CO3 is not a final product of the double-replacement reaction; it breaks down (decomposes) immediately into two products. (3 points) NaHCO3 + HCl → CO2 + H2O + NaCl 3. The NaHCO3 is the limiting reactant and the HCl is the excess reactant in this experiment. Determine the theoretical yield of the NaCl product‚ showing all of your work in the space below. (5 points)
Free Stoichiometry Yield Water
Ideally‚ the percent yield should be 100%‚ as this means that you have recovered 100% of that material. A yield over 100% would mean that the substance still has some traces of another material that is adding additional mass. Ex. The iron filings having some sand particles leftover. A yield under 100% would mean that some of the substance was not recovered‚ it could have been lost (spilled) or found in another substance (not separated completely). The percent yields may give some insight into what
Premium The Final Melting point Carbon
Percent Copper in Brass Background The scientific concepts involved in this lab include Spectroscopy‚ Beer’s law‚ Calibration curve‚ concentration‚ and electronic transitions. The main objective of this experiment is to see how the percent composition of brass can be determined to verify the properties influenced by copper and zinc. Brass is a generic term for alloys of copper and zinc. The main technique used in this experiment is Spectroscopy. The three equations used in this lab are: Y = mx
Premium Zinc Ammonia Sulfuric acid
Determining the Limiting Reactant and Percent Yield in a Precipitation Reaction Objectives: Observe the reaction between solutions of sodium carbonate and calcium chloride. Determine which of the reactants is the limiting reactant and which is the excess reactant. Determine the theoretical mass of precipitate that should form. Compare the actual mass with the theoretical mass of precipitate and calculate the percent yield. Materials: Balance 0.70 M sodium carbonate solution‚ Na2CO3(aq)
Premium
Determining the Limiting Reactant and Percent Yield in a Precipitate Reaction (SMG 6D) AP Chemistry One example of a double replacement (metathesis) reaction is the mixing of two solutions resulting in the formation of a precipitate. In solution chemistry‚ the term precipitate is used to describe a solid that forms when a positive ion (cation) and a negative ion (anion) are strongly attracted to one another. In this experiment‚ a precipitation reaction will be studied. Stoichiometry
Premium Sodium Stoichiometry Chemical reaction
In the data table above‚ the mass of penny‚ copper‚ and zinc was needed in order to determine the percent composition of copper and zinc. The mass of penny was taken on the scale in the beginning of the procedure before anything was done to the penny‚ and it was 2.51 grams. After the reaction with the hydrochloric acid and drying the copper‚ the mass is 0.35 grams. To get the mass of zinc‚ the mass of the penny was subtracted by the mass of copper. The mass of zinc is 2.16 grams. The penny is 14%
Premium Water Chemistry Oxygen
we can then calculate the water evolved. The first method we use to determine the percent composition is Gravimetric. With this method we use the mass of the reactant and the mass of the product. Another way to acquire the percent composition is by the Volumetric Method. This method requires measuring the water displaced by the O2 gas. If the experiment is done correctly‚ we should be able to calculate the percent composition of KClO3 by using both methods. Theory: This experiment requires us
Free Gas Pressure Chlorine
Percent Composition Report Hypothesis : By using seperation techniques properly‚ the 3 substance such as; water‚ sand‚ and salt can be seperated and the percent composition of each substance. Which will then be calculated theoritically and after comparison with the actual result‚ the accuracy of the 2 result can be found. Aim : The aim of this experiment is to compare the gravimetric result of the original mixture and the separated substance. The other objective is to calculate each percent
Premium Mathematics Mixture Analytical chemistry