"Flame test your company has been contacted" Essays and Research Papers

Sort By:
Satisfactory Essays
Good Essays
Better Essays
Powerful Essays
Best Essays
Page 1 of 50 - About 500 Essays
  • Good Essays

    Flame Tests

    • 1163 Words
    • 5 Pages

    Flame Tests 12.01.2010 19.01.2010 Introduction The normal electron configuration of atoms or ions of an element is known as the “ground state”. In this most stable energy state‚ all electrons are in the lowest energy levels available. When atoms or ions in the ground state are heated to high temperatures‚ some electrons may absorb enough energy to allow them to “jump” to higher energy levels. The element is then said to be in the “excited state”. This excited configuration is unstable‚

    Premium Potassium Atom Photon

    • 1163 Words
    • 5 Pages
    Good Essays
  • Good Essays

    Flame Test

    • 865 Words
    • 4 Pages

    Discussion Questions 1. Why do different metals have different characteristic flame test colours? The photons emitted during the test precisely match the quantum energy difference between the excited state and the ground state. For different elements the spacing between the ground state and the higher energy levels is different. So different elements have different flame test colours. 2. Most salts contain a metal and a non-metal. Look at the compounds we tested and determine whether it is

    Premium Management Organization Education

    • 865 Words
    • 4 Pages
    Good Essays
  • Good Essays

    Flame Test

    • 895 Words
    • 4 Pages

    Title: Flame Test Aim: To determine the cation in each of the unknown substance X‚ Y and Z by observing the flame colour of different metal compounds. Introduction: A distinctive feature of many s-block metals is their ability to produce flame colours. At temperature of a Bunsen flame‚ a compound will decompose to give gaseous atoms of its constituent elements. When an electron in the gaseous atom absorbs energy from the flame‚ it will move from an orbital with lower energy to

    Premium Sodium chloride Flame test Potassium

    • 895 Words
    • 4 Pages
    Good Essays
  • Satisfactory Essays

    Flame Test

    • 451 Words
    • 2 Pages

    REPORT SHEET Date | 2.26.2013 | | Name | Tina Mwale | Flame Tests | | | Include the data sheet with this report sheet. 1. An AM radio station broadcasts at a wavelength of 0.500 kilometers. Microwaves can have a wavelength of 12 cm. A fire place can give off photons with a wavelength of 1.5 x 10-3 millimeters and the X-rays used in a dentist’s office have a wavelength of 2.1 x 10-11 meters. Ultraviolet rays‚ the ones that give you sunburn or fade the colors of clothes have

    Premium Light Electromagnetic radiation Wavelength

    • 451 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    Flame Test Lab

    • 660 Words
    • 3 Pages

    Flame Test Lab Question: When a compound is placed in the flame of a burner‚ what happens to the color of the flame? Hypothesis: When the compound is placed in the flame‚ the flame changes color depending on the chemical compound. When they’re heated‚ they gain energy and changed color sometimes. Safety Requirements for this Lab: Wear goggles at all times. If you want to remove them to write in your notebook you may sit at a table in the center of the room. When you sit down remove them

    Premium Chemical element Metal Chemical compound

    • 660 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Flame Test Experiment

    • 768 Words
    • 4 Pages

    Date: 20/03/13 Flame Test – Investigating Compounds Aims To identify the presence of a relatively small amount (ie low concentration) of a metal ion in a compound. Method 1. Clean a platinum or nichrome wire by dipping it into concentrated hydrochloric acid. 2. Hold the platinum or nichrome wire at the hottest or blue part of a non-luminous Bunsen flame. 3. Repeat until the wire does not produce any colour in the flame (note: do not touch the wire‚ as salt in sweat will produce

    Premium Metal Ion Ionic bond

    • 768 Words
    • 4 Pages
    Good Essays
  • Satisfactory Essays

    Flame Test Lab

    • 259 Words
    • 2 Pages

    I. Purpose: To observe the colors produced when compounds are introduced into a flame and the electrons become excited. To estimate the wavelength of light produced‚ then calculate the frequency and energy of the light II. Safety: Standard safety procedures III. Chemical Inventory: |Chemical Name: |Hazards: | |Lithium Chloride

    Premium Light Electromagnetic radiation Wavelength

    • 259 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    Flame Test Essay

    • 810 Words
    • 4 Pages

    Lab 1: Flame Test 11 Chemistry‚ university Preparation Conducted: September 20th‚ 2010 Purpose: To observe‚ and create a chart of the colours produced when solutions of known metal compounds are heated to high temperature. Question: What colours are produced when different metallic compounds are placed in a flame‚ and why this happens? Hypothesis/Prediction: Different salts will produce different colours when placed in a flame‚ due to the fact that each element has a different

    Premium Chemistry Light Potassium

    • 810 Words
    • 4 Pages
    Good Essays
  • Satisfactory Essays

    Flame Test Lab

    • 328 Words
    • 2 Pages

    Flame Test Lab Introduction/Purpose: When a certain amount of energy is supplied within an atom‚ the electrons of that atom begin to move up the levels of electron configuration. This level of energy is called a quantum. The object of this experiment was to examine the movement of electrons up and down energy levels through the use of given elemental substances. With heat supplying a large amount of energy‚ the properties of the elements caused them to give off a certain color or tone of

    Premium Chemistry Photon Atom

    • 328 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    Flame Test Lab

    • 738 Words
    • 3 Pages

    Flame Test Lab Period 2 Due: 10/19/11 Honors Chemistry Purpose/Objective: To observe the colors produced when elements are put into a flame and to prove when electrons jump down from higher layers they release energy in the form of light. Materials: CoCl2 Na2SO4 CaCl2 KCl SrCl2 CuCl2 LiCl Unknown A Unknown B Distilled H2O Q-tips Beaker Bunsen Burner Spectroscope Spot Plate Procedure: 1. Light the Bunsen Burner. 2. Fill a beaker

    Premium Energy Color Conservation of energy

    • 738 Words
    • 3 Pages
    Good Essays
Previous
Page 1 2 3 4 5 6 7 8 9 50