Experiment 8 Colligative Properties Osmotic Pressure Category Experiments Labs Essays and Term Papers

  • Lab 1: Colligative Properties & Osmotic Pressure

    Ankur Sindhu Sep 20, 2011 CHEM 182-DL1 Prof.: Dr. Nidhal Marashi Lab 1: Colligative Properties & Osmotic Pressure Purpose: The purpose of this laboratory was to gain an understanding of the differences between the freezing points of pure solvent to that of a solvent in a solution...

    1698 Words | 6 Pages

  • Colligative Properties & Osmotic Pressure

    Colligative Properties & Osmotic Pressure (Lab – Chapter 13) Introduction: In this lab, we are going to observe the difference in freezing point between pure water and salt water. We will also observe the permeability of an egg shell membrane and dialysis tubing, acting in place of a human cell...

    792 Words | 6 Pages

  • Colligative Properties & Osmotic Pressure

    Title: Colligative Properties & Osmotic Pressure Background: Important terms to study from this lab assignment are colligative properties, membrane permeability and osmotic pressure. First, colligative properties are “those of a solution that depend solely on the number of solute particles present...

    1846 Words | 7 Pages

  • Lab Experiment 6 : Chemical and Physical Properties

    Lab Experiment 6 : Chemical and Physical Properties Lab Experiment 6 : Chemical and Physical Properties Purpose: The purpose of this lab is to test substances and to determine the physical and chemical properties of substances. Material matches, glassbeaker 100 mL, burner-fuel...

    1260 Words | 7 Pages

  • Experiment 8

    Purpose This experiment shows how different concentrations of acids and bases in a solution affect its pH level. When acids and bases are combined in a solution, they neutralize each other. This means that depending on the concentration of both acids and bases in a solution, the pH will vary. A neutral...

    555 Words | 3 Pages

  • Experiment 8

    Geiger Counter Experiments In this laboratory session, we will do different experiments with the Geiger Counter: determining the proper operating voltage, estimating the efficiency, and measuring the half-life of Ba137m . 1. Operating Voltage of the Geiger Counter First, we will measure the Geiger counter’s...

    1709 Words | 5 Pages

  • Experiment 8

    1st Year Laboratory Report NAME: GROUP NUMBER: EXPERIMENT NUMBER: DATE OF EXPERIMENT: DATE OF REPORT SUBMISSION: MARK/20(for demonstrators use only): Lab Report i- Introduction 1. Learning Outcomes The ability to work with a colleague to design and construct...

    1498 Words | 6 Pages

  • Experiment 8: Acetylsalicylic Acid Experiment

    Monica Perez Experiment 8: Acetylsalicylic Acid Experiment 01/25/2013 CHM Lab- 2211 Sec 0016 Instructor: Jennifer Reed Introduction: Commonly used as Aspirin, acetylsalicylic acid is an analgesic (pain reliever), which is one of the products of the esterification reaction between salicylic...

    1650 Words | 6 Pages

  • lab experiment

    Economic Resources Adapted from "Factors of Production" at http://www.landandfreedom.org/econ/econ2.htm and Intro to Business, 6e, by Dlabay, Burrow, and Eggland   Economists have long recognized three distinct types of economic resources that people use to create the things they want. Natural...

    969 Words | 4 Pages

  • Lab Experiment

    CHERYL LOW YI LIAN CHEE MAO HAN GROUP : GROUP 3 EXPERIMENT NO. : 2 EXPERIMENT TITLE: DETERMINATION OF THE ACTIVATION ENERGU FOR THE REACTION OF BROMIDE AND ...

    747 Words | 4 Pages

  • Lab Experiment

    LAB - 2 FREQUENCY MODULATION 2.1 OBJECTIVE In this lab, you will learn how to perform the Frequency modulation using IC 566 and to calculate the modulation index for various modulating voltages. 2.2 HARDWARE REQUIRED AFO, IC NE566, Resistors, Capacitor, CRO, Bread board and connecting wires, RPS 2...

    515 Words | 2 Pages

  • Colligative Properties Lab

    Colligative Properties 202-NYB-05 (Group 06.) By: Jordan Hribar 1034044 Partner: Anthony Cuillierier Teacher: Daniel Baril Experiment Done: February 23rd, 2011 Experiment Number 2. Introduction Some of the properties unique to solutions depend only on the number of dissolved...

    763 Words | 5 Pages

  • Experiment 4: Properties of Gases

    Report Submitted: June 21, 2013 Title: Properties of Gases Purpose: To analyze a few physical and chemical properties of gases as well as using those properties to identify the gases. Procedure: * For Hydrogen I placed a piece of Zn metal into a test tube with diluted HCl. * To produce oxygen...

    480 Words | 2 Pages

  • Experiment: Properties of Gasses

    Flyne Anderson Experiment done - 30 September 2012 Report submitted - 02 October 2012 Chemistry 111 - Experiment 4 : Properties of Gasses Purpose: The purpose of the experiment is to learn about the properties of gasses, and identify them by their physical and chemical properties by combining different...

    784 Words | 4 Pages

  • Experiment #8: Limiting Reactant

    Experiment #8: Limiting Reactant Abstract In chemical reactions, the significance of knowing the limiting reactant is high. In order to increase the percent yield of product, increasing the limiting reactant, possibly, is the most effective. In this experiment we were able to calculate limiting...

    1743 Words | 6 Pages

  • Experiment 1 Physics Lab

    Experiment 1: Error, Uncertainties and Measurements Laboratory Report Jan Luke Mendoza, Alexis Vienne Munar, Paula Murakami, Giorla Joanne Negre Department of Math and Physics College of Science, University of Santo Tomas Espana, Manila Abstract Throughout the experiment the main goal is...

    2045 Words | 9 Pages

  • lab experiment H

    Experiment H CHM 2330 Due date: February 5th, 2009 Date of submission: February 5th, 2009 Department of Chemistry University of Ottawa Objective: The objective in this experiment is to apply Raoult’s law and the relationship between vapour pressure and solvent...

    1550 Words | 13 Pages

  • Thermo Lab Experiment 1

    conductivity & one-dimensional heat conduction experiment was to identify three different metal specimens by comparing their experimentally determined thermal conductivities to known thermal conductivity values of existing metals. The second objective of the experiment was to establish a connection between the...

    2840 Words | 11 Pages

  • Lab Report Experiment 4

    water) 105°C (w/ water) 70°C Discussion The percent recovery of Benzoic Acid is way above 100%. This indicates that an error was performed during the experiment. Phthalic Acid melted just 20°C less than the standard melting point for Phthalic Acid. Naphthalene melted 10°C less and Benzoic Acid also did not...

    415 Words | 6 Pages

  • Lab Experiment 5

    Solids Purpose: The experiment will help determine two important physical properties, boiling and melting point, of liquids and solids. Procedure: Before starting the experiment I gathered all materials appropriate for the experiment and prepare a safe environment for my experiment. I record the boiling...

    492 Words | 2 Pages