Preview

Lamotrigine Orodispersible Tablets Lab Report

Better Essays
Open Document
Open Document
3245 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Lamotrigine Orodispersible Tablets Lab Report
Formulation of Lamotrigine Orodispersible Tablets by Using New Generation Superdisintegrants

B.Ramu 1*, N.Ramakrishna 2, B.Shivashanker3
1,3 K.V.K College Of Pharmacy , Department Of Pharmaceutics,JNTUH Hyderabad India. 2 Avanthi institute of pharmaceutical sciences,department of pharmaceutics Bandameedi.ramu@gmail.com ABSTRACT
In the present work, an attempt has been made to develop fast disintegrating tablets of Lamotrigine. New generation super disintegrates Solutab, Explotab and Polyplasdone XL was selected as super disintegrates. All the formulations were prepared by direct compression method using 6mm punch on 8 station rotary tablet punching machine. The blend of all the formulations
…show more content…
Methodology:
Tablet formulation:
Formulation of Lamotrigine Dispersible Tablet by Direct- Compression 7:
Composition of preliminary trials for Lamotrigine Dispersible Tablet by direct compression is shown in table 6.1. All the ingredients were weighed. Required quantity of drug and excipient mixed thoroughly in a polybag. The blend is compressed using rotary tablet machine-10 station with 6mm flat punch, B tooling. Each tablet contains 2.5 mg Lamotrigine and other pharmaceutical ingredients .

Table 1. Formulation of Lamotrigine oro dispersible tablets
INGREDIENT F1 F2 F3 F4 F5 F6 F7 F8 F9 F10 F11 F12
Lamotrigine 2.5 2.5 2.5 2.5 2.5 2.5 2.5 2.5 2.5 2.5 2.5 2.5
Solutab 5 10 15 20
Explotab 5 10 15
…show more content…
New generation super disintegrates Solutab, Explotab and Polyplasdone XL was selected as super disintegrates. All the formulations were prepared by direct compression method. The blend of all the formulations showed god flow properties such as angle of repose, bulk density, tapped density. The prepared tablets were shown good post compression parameters and they passed all the quality control evaluation parameters as per I.P limits. Among all the formulations F4 formulation showed maximum % drug release i.e., 97.54 % in 10 min hence it is considered as optimized formulation. The f4 formulation contains Solutab as super disintegrate in the concentration of 20 mg.F8 formulation also showed maximum percentage drug release i.e., 101.8% in 10 min ,it contains Explotab as super disintegrate in the concentration of 20

You May Also Find These Documents Helpful

  • Good Essays

    The purpose of this experiment is to investigate the composition of compounds in Panacetin. Generally, it is made up of sucrose, aspirin and an unknown component, either acetanilide or phenacetin. SinceBy using different techniques, such as filtration, extraction, and evaporation, those three components have been isolated out, which is based on varies solubility and acid-based properties. The percentage of composition of Panacetin are also found, which is based on the mass of three dried components.…

    • 674 Words
    • 3 Pages
    Good Essays
  • Powerful Essays

    Aspirin, Caffeine and Salicylamide were extracted from an over-the-counter pain reliever (BC Powder). These components were separated by manipulating their solubilities by adjusting the acidity and basicity of the solution. By doing this, the three components were forced into conjugate acid (or base) forms, causing selective solubility in either an aqueous or organic solvent. These layers were then separated by use of a separation funnel. Once separated, the components extracted were characterized by measuring the melting point and performing a TLC analysis. Also, the recovered aspirin from the first part of the experiment was recrystallized and compared to that of the isolated aspirin.…

    • 1653 Words
    • 7 Pages
    Powerful Essays
  • Good Essays

    The acetaminophen (0.5395g) was crushed and added to a conical vial and was mixed with 2ml of methanol then shaken and let to sit till the undissolved particles settled to the bottom and transferred the liquid into a centrifuge tube using a filter-tip pipet. Repeating the process with an additional 2mL of methanol. The solvent was then centrifuged for 3 minutes until the mixture had settled into a supernatant liquid layer and a solid layer. Then in a prepared alumina column with 0.5 mL g of alumina 2mL of methanol was added to column and then the solution containing the drug. Followed by 1 mL of methanol through the top of the alumina. Half of the solution was then transferred into a small container. The remaining solvent was then evaporated in a preheated 50 C water bath and gentle air stream until 1 mL was left. The remaining solvent was then added and evaporated completely.…

    • 783 Words
    • 4 Pages
    Good Essays
  • Powerful Essays

    Panacetin Lab Report

    • 1439 Words
    • 6 Pages

    The second experiment of the semester focuses on separating and identifying the components of Panacetin, which is a common medication that relieves pain. The label reveals that Panacetin is composed of sucrose (10%), aspirin (40%), and Tylenol (50%). Although this information is reported, the true composition of Panacetin is questionable. While sucrose and aspirin are present in Panacetin, Tylenol may be replaced by an unknown component (acetanilide or phenacetin). Separation of the components of a sample of Panacetin may prove valuable in identification of the unknown component, as well as the true percent composition of each component of Panacetin.…

    • 1439 Words
    • 6 Pages
    Powerful Essays
  • Satisfactory Essays

    In this lab we separated components of a simulated preparation, panacetin and making use of its acid base properties. To obtain such a pure compound, the compound we want must be separated from its other natural components, which can be done by manipulating physical and chemical properties. Panacetin contains sucrose, aspirin and an unknown which can be acetanilide or phenacetin in which phenacetin was created and weighed.…

    • 479 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    The purpose of this experiment is to investigate the composition of a simulated pharmaceutical preparation Panacetin, a proposed type of pain-killer. Panacetin is typically made up of sucrose, aspirin, and acetaminophen, but the third component in this experiment is unknown. The unknown component is suspected to be a chemical relative of acetaminophen, either acetanilide or phenacetin. Using techniques such as extraction, evaporation, and filtration, the three components will be isolated based on their solubilities and acid-base properties. The percent composition of Panacetin will also be deduced based on the masses of the three dried components; this is done to verify the composition attained is consistent with those listed on the preparations label. As a result of this investigation, my teammates and I allowed the Panacetin to undergo gravity filtration and separation techniques in order to identify whether there are any discrepancies in the components of the Panacetin. Furthermore, recrystallization and purification methods were used to determine if the unknown substance were similar in properties to either of the suspected unknown substances by comparing factors such as melting points to the chemical properties of phenactin and acetanilide. The results were as expected, based on the molecular weights and ratios of each separated chemicals, as well as the boiling point of the unknown it was determined that these ranges were close enough to indicate that the label is reasonably accurate in its composition. To add on however the identity of the unknown component differed from what the label indicated. In the end, the percentage composition attained based on our observations and yield confirmed that indeed the chemical composition of Panacetin were as indicated on the preparations label. The identity of the unknown component however suggested that the preparation did not contain acetaminophen as indicated, but instead was consistent with the chemical properties…

    • 305 Words
    • 2 Pages
    Good Essays
  • Good Essays

    Pre-Lab: Analgesic drugs are known for reducing pain, while antiseptic drugs reduce symptoms such as fevers and swelling. However, some of these drugs can reduce both illnesses. To obtain a pure compound in these drugs, the scientist needs to separate the desired compound by taking advantage of the different physical and chemical properties. Such as; different boiling points, melting points and their solubility properties. To do this a chemist can also asses the differences between acidic and basic substances when they are added to water soluble mixtures. Within this current experiment I will asses the pharmaceutical preparation of Panacetin, by using it 's solubility along with other organic molecules. We know that Panacetin is made up of sucrose, aspirin and some other unknown substance. We know the substance has to be Phenacetin or Acetanilide. To help solidify our reasoning, we need a % recovery of 8-12% sucrose, 35-45% aspirin and 45-55% unknown.…

    • 1948 Words
    • 56 Pages
    Good Essays
  • Better Essays

    A water bath was heated to about 70 degrees Celsius. One unknown tablet was weighed and then crushed…

    • 1180 Words
    • 4 Pages
    Better Essays
  • Good Essays

    Enabling mighty competition between commonplace drug treatments and patent-expired fashioned brands is relevant to decreasing pharmaceutical charges and stimulating innovation. However, this mentioned, there are numerous troubling problems surrounding general medicines because of the convenient access to an abundance of illegal generics on the internet breaking the patent ownership and the unregulated companies that produce and supply them. At the same time familiar medicines will have to be approved identical types of depended on drugs, providing the equal fine, safety and efficacy because the normal, that is commonly no longer the case. A conventional drug must endure strict scrutiny before it is licensed and given market approval with the aid of countrywide medicines authorities. In brief, common medicines will have to comply with the same strict standards of great, safety and efficacy as usual pharmaceutical…

    • 490 Words
    • 2 Pages
    Good Essays
  • Good Essays

    Tlc questions

    • 567 Words
    • 3 Pages

    8. A 50/50 mixture of dichloromethane and ethanol was added to the crushed analgesic tablets to fully dissolve the tablets because the whole tablet will not dissolve as it contained not only the analgesic, but also binders, buffering agents and other components that would not make the tablet to fully dissolve in just a polar solvent.…

    • 567 Words
    • 3 Pages
    Good Essays
  • Better Essays

    In this experiment, several analgesics were analyzed by Thin Layer Chromatography (TLC) and the composition of an unknown tablet was identified. We define chromatography as the separation of two or more compounds or ions by their molecular interactions by either a moving or a stationary phase.1 There are different types of chromatography: Thin Layer Chromatography (TLC), Gas Liquid Chromatography (GC), and Column Chromatography (CC). All of which there two phases: mobile and stationary. Phases can be a solid and a liquid, a liquid and a liquid, a gas and a solid, or a gas and a liquid. The stationary phase is also known as the absorbent. Greater affinity, or attraction, for the mobile phases will move faster and conversely for stationary phases.2 Running a solvent past the absorbent complex in order to remove analytes from the absorbent is known as elution. This process aids in determining affinity.3 The most polar compound is always the absorbent; however, the polarity of the compounds in the mixture in addition to the solvents found in the mixture differs in polarities.…

    • 842 Words
    • 4 Pages
    Better Essays
  • Better Essays

    Titration Lab

    • 2835 Words
    • 12 Pages

    The purpose of the lab is to determine the mass of the ‘active ingredient’ in a commercial ASA tablet.…

    • 2835 Words
    • 12 Pages
    Better Essays
  • Better Essays

    The purpose of this lab is to investigate the composition of a compound suspected to be Panacetin, a type of pain-killer. Panacetin is typically made up of sucrose, aspirin, and acetaminophen, but the third component in this experiment is unknown. The unknown component is suspected to be a chemical relative of acetaminophen, either acetanilide or phenacetin. Using techniques such as extraction, evaporation, and filtration, the three components will be isolated based on their solubilities and acid-base properties. Then, the percent composition of Panacetin can be deduced based on the masses of the three dried components. The compounds being studied are as follows:…

    • 1212 Words
    • 5 Pages
    Better Essays
  • Good Essays

    Crime Scene Report

    • 423 Words
    • 2 Pages

    Gas Chromatogram (GC) and mass spectrum was used for further analysis, in order to find out what exactly was this drug, and find its mixtures and compounds.…

    • 423 Words
    • 2 Pages
    Good Essays
  • Good Essays

    The global market for bone and joints ingredients is growing rapidly due to rising use of these ingredients in different parts of the world. Increase in ageing population is considered as one the major driving factors for the market. Due to weakening of bone and joints, diminished functions and movements, ageing makes body more prone to bone fractures, arthritis, back and neck pain, osteoporosis and injuries. The number of aged people over 60 years or over are expected to double in the next 50 years, thereby increasing demand for these ingredients in the market. Despite the benefits of bone and joint health ingredients, the growing concerns for fatal diseases, such as cancer and heart, are some of the major restraints for the market. On the other hand, introduction of various pills which reduces the inflammation of joint and may cure the symptoms of arthritis acts as a challenge for the market. In addition, many stringent laws, regulations and procedural formalities that are imposed on the vendors are also posing challenge for the market.…

    • 477 Words
    • 2 Pages
    Good Essays