Preview

Chapter 9 Review Questions

Powerful Essays
Open Document
Open Document
606 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Chapter 9 Review Questions
Chapter 9 Review Questions
1. What is magnetism?
2. Torque is ________.
3. A magnetic field is _________.
4. True or False: A permanent magnet is a piece of material that has been magnetized and can hold its magnetic strength for a reasonable length of time.
5. How is an electromagnet produced?
6. Which of the following produces the best electromagnet?
7. Unlike poles of a magnet _________each other and like poles_________ each other.
8. What part does polarity play in the operation of an electric motor?
9. What part of a motor produces an inductive magnetic field within itself to facilitate the rotating motion?
10. What part does the frequency of alternating current play in the operation of an electric motor?
11. What would be the speed of a two pole motor operating on a 120 Volts 60 Hz power supply?
12. What are the five types of single phase motors used in the industry?
13. Which of the following correctly lists the motor’s starting torque from lowest to highest?
14. Which of the following is a common use of a shaded-pole motor?
15. How does a shaded-pole motor operate?
16. How can a shaded-pole motor be reversed?
17. What determines the rotation of a shaded-pole motor?
18. Draw a diagram of a three-speed, shaded-pole motor.

19. What enables a split-phase motor to develop enough torque to begin rotation?
20. What removes the starting winding from the electrical circuit of an open type split phase motor once it reaches 75% of its operating speed?
21. What are the three probable areas of trouble in a split-phase motor?
22. What is the unit of measurement for the strength of a capacitor?
23. What is the purpose of a capacitor?
24. What is the difference between a running and a running and a starting capacitor?
25. List the five capacitor replacement rules.
26. Explain the operation of a permanent split-capacitor motor.
27. How are a PSC motor and a capacitor start capacitor-run motor similar?
28. What are the advantages

You May Also Find These Documents Helpful

  • Satisfactory Essays

    ABurnett Chpt12

    • 344 Words
    • 1 Page

    12. We may cause accelerated bearing failure if we attempt to operate the engine at 1500 rpm.…

    • 344 Words
    • 1 Page
    Satisfactory Essays
  • Good Essays

    3) When Stonehenge was built, the summer solstice Sun rose beside the Heel Stone (due to the precession of the equinoxes)…

    • 456 Words
    • 2 Pages
    Good Essays
  • Good Essays

    The Ramp PhET Lab

    • 687 Words
    • 4 Pages

    4. Before we add an applied force on the ramp, there is a force of ____________…

    • 687 Words
    • 4 Pages
    Good Essays
  • Good Essays

    Turbins assginmen

    • 376 Words
    • 2 Pages

    A. The position of the SLEP will vary with different loads to represent the decreased efficiency at loads away from max turbine efficiency.…

    • 376 Words
    • 2 Pages
    Good Essays
  • Good Essays

    A. If the North Pole exist B. The N-pole of the coil C. The N-S poles apply D. All of the above…

    • 692 Words
    • 3 Pages
    Good Essays
  • Good Essays

    physics

    • 5301 Words
    • 22 Pages

    d) Know and understand that if the resultant force acting on a stationary object is:…

    • 5301 Words
    • 22 Pages
    Good Essays
  • Good Essays

    Astrand-Rhythmic Testing

    • 739 Words
    • 3 Pages

    6. Adjust the work load to 100w and remain at the constant 60rpm for 6 minutes.…

    • 739 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Leading involves recognizing and communicating the need to change course and direction of the project, aligning people to this new direction, and motivating the team to overcome obstacles to achieve the new objectives. Managing is about formulating plans and objectives, designing procedures to achieve those objectives, monitoring progress, and taking corrective action. Managing is about putting out fires and maintaining the course. Leading is about change, and altering the course of a project.…

    • 946 Words
    • 4 Pages
    Good Essays
  • Powerful Essays

    Research

    • 2102 Words
    • 9 Pages

    Synchronous Motor Operation • • The squirrel-cage Amortisseur winding in the rotor produces Starting Torque and Accelerating Torque to bring the synchronous motor up to speed. When the motor speed reaches approximately 97% of nameplate RPM, the DC field current is applied to the rotor producing Pull-in Torque and the rotor will pull-in -step and “synchronize” with the rotating flux field in the stator. The motor will run at synchronous speed…

    • 2102 Words
    • 9 Pages
    Powerful Essays
  • Powerful Essays

    [6] Dr. Van Coller J.M., Variable Speed Drives for AC Machines-Elen7048, University of the Witwatersrand, 2012…

    • 3532 Words
    • 15 Pages
    Powerful Essays
  • Good Essays

    DC Motors

    • 2647 Words
    • 8 Pages

    A simple DC motor has a stationary set of magnets in the stator and an armature with coils around a soft iron core that concentrates the magnetic field. The ends of the coils are connected to a commutator. The commutator allows each armature coil to be energized in turn and connects the rotating coils with the external power supply through brushes. The total amount of current sent to the coil, the coil's size and its core dictate the strength of the electromagnetic field created. By turning on and off coils in sequence a rotating magnetic field can be created. These rotating magnetic fields interact with the magnetic fields of the magnets (permanent or electromagnets)…

    • 2647 Words
    • 8 Pages
    Good Essays
  • Powerful Essays

    Reservations

    • 8872 Words
    • 36 Pages

    General concepts of Rotating Electrical Machines: Electromagnetic torque, Reluctance torque, Constructional features of rotating electrical machines, Classifications of rotating electrical machines, Construction of DC machines, Principle of DC generator, Principle of DC motor, Lap winding, Wave winding, Electrical and mechanical degrees.…

    • 8872 Words
    • 36 Pages
    Powerful Essays
  • Good Essays

    References: [1] Theodore Wildi, Electrical Machines, Drives and Power Systems, sixth edition, Pearson Prentice Hall: Part 2. Electrical Machines and Transformers, pp.71-117…

    • 4399 Words
    • 30 Pages
    Good Essays
  • Powerful Essays

    Electrical Machine

    • 5769 Words
    • 24 Pages

    The windings used in rotating electrical machines can be classified as  Concentrated Windings • All the winding turns are wound together in series to form one multi-turn coil • All the turns have the same magnetic axis • Examples of concentrated winding are – field windings for salient-pole synchronous machines – D.C. machines – Primary and secondary windings of a transformer  Distributed Windings • All the winding turns are arranged in several full-pitch or…

    • 5769 Words
    • 24 Pages
    Powerful Essays
  • Better Essays

    Save Energy

    • 1927 Words
    • 8 Pages

    3. Blades attached to an alternator/generator experience the force of lift and begin to spin…

    • 1927 Words
    • 8 Pages
    Better Essays