Fractional Distillation of an Ethanol- water Mixture Abstract The purpose of this experiment is to understand the process of distilling a solution. Thesolution of 50/50 ethanol-water was used in the experiment. Using fractional distillationapparatus ethanol-water mixture was separated. The fractional use of copper sponge wasused in distillation process which created the heat exchange area between the vapor of ethanol and liquid water. The fractional distillation process yield 9.5 ml of ethanol
Premium Distillation Water Evaporation
Steam Distillation Purpose: To use steam distillation to purify heat sensitive‚ natural products‚ like essential oils. Procedure Please refer to: Williamson‚ Macroscale &Microscale Organic Experiments 4th Ed.‚ pgs.98-109 Results Table 1.1: Steam distillation Drop # (every third drop) Temperature (ºC) Addition of 0.5 mL water 1 100.3 Water added 2 100.5 3 100.5 Water added 4 100.6 Water added 5 100.6 6 100.6 Water added 7 100.6 8 100.6 Water added 9 100.3 10 100.6
Premium Water Distillation Vapor pressure
Cheryl Baclit Chem 234 Experiment 4: Steam Distillation Introduction The purpose of this experiment is to extract Eugenol from Cloves using steam distillation as a purification technique and to transfer Eugenol from the aqueous phase to the MeCl2 phase. With steam distillation‚ the boiling point of a mixture of immiscible liquids is lower than the boiling points of the individual components. Water from the steam is one of the components of an immiscible liquid mixture. The vapor pressures of
Premium Water Distillation Laboratory glassware
The Extraction of Bio-ethanol from Apple (Malus domesticus) and Banana (Musa accuminata Colla) Peelings through the Process of Fermentation and Distillation Abstract Apple (Malus domesticus) and banana (Musa accuminata Colla) peelings are common household waste products. This study sought to extract bioethanol from these two peelings and to compare which sample can produce more bioethanol. About 400 grams of apple and banana peeling was obtained from the 1 kilogram bought from the supermarket
Premium Ethanol Ethanol fuel Sugar
observed to be around 87 to 89 degrees Celsius. It ranged from about 77 degrees in fraction 1 to about 89 degrees in the fraction 10. Next‚ the toluene stayed relatively the same temperature throughout the first 6 fractions at around 69 degrees and then drastically shot up to 100 degrees by the end of fraction 10. This is due to hexane having a lower boiling point and being able to steadily increase through each fraction evenly as temperature rises while the toluene‚ because of its higher boiling component
Premium Distillation
EXECUTIVE SUMMARY: The main objective of this project was to carry out a design on the Propane distillation column for a process that produces 1‚3 Butadiene. The raw materials used are Butane‚ Oxygen and Water and the process capacity is 100 000 tonnes per annum nominal. In the previous work it was stated that the plant is located in China. The main location of the plant is in the capital city of the Gansu Provence‚ Lanzhou. This was decided as the location over other provinces due to the excellent
Premium Distillation Chemical engineering
Distillation of Alcoholic Beverages Pamela Mallari*‚ Symon Manuel‚ Katherine Merene and Charlene Mondelo Department of Chemistry‚ University of Santo Tomas‚ Manila‚ Philippines Abstract Distillation is a physical process used to separate chemicals from a mixture by the difference in how easily they vaporize. This experiment aims to (1) compare the efficiency of simple and fractional distillation‚ (2) distill and calculate the % of ethanol and (3) determine the % loss in distillation. Two
Premium Distillation
plants. In this experiment‚ the essential oil eugenol was isolated from ground cloves using steam distillation techniques. Eugenol had a high boiling point‚ but it was isolated at a lower temperature by performing a co-distillation with water‚ a process known as steam distillation. This technique allowed the desired material to be distilled at a lower temperature than 100℃. The point of the steam distillation was to use an azeotrope to isolate the organic compound from a solid. The azeotrope was the
Premium Distillation
collected in 10ml fractions. Predict the poiling range of each fraction. Fractions vol. collected (ml) temp. oC(predicted) 1 10 78 2 20 78 3 30 78-100 4 40 100 5 50 100 For A compound = 78-82oC For B compound = 100oC 4. What is the mole fraction of each component if 3.9g of benzene(C6H6) is dissolved in 4.6g of toluene (C7H8) Mole of benzene=3.9g\(6*12+6)g\mol = 0.05 mol Moles of toluene=4.6g\(7*12+8)g\mol =0.05 mol Mole fraction of benzene=mole fraction of toluene = 0.05\(0
Premium Distillation Concentration Chemistry
Mona Vaidya 02/04/2014 CHE 317 Laboratory Experiment #1: Simple Distillation of Two Volatile Liquids Containing Non-Volatile Impurities Introduction: Simple distillation is a commonly used method to separate and purify the mixtures of organic liquids into their original components. Mixtures of two miscible liquids with two different boiling points were separated. Therefore‚ it can be said that the two organic compounds are separated by exploiting the different boiling temperatures of the liquids
Premium Distillation Evaporation Water