Preview

physics lab

Satisfactory Essays
Open Document
Open Document
279 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
physics lab
Collision Impulse and Momentum
PH215L Physics 1 Lab
Lab#8
Lab Was Held: 3/20/14
Report Submit: 3/27/14
Professor List
Daniel Webster College

Table Of Contents

Introduction
Theoretical background
Equipment list
Procedure
Calculations and Results
Discussion
Conclusion

Introduction
In this lab we tested the duration of impact, the force of impact and the change of momentum of the particles involved in the collision all parameters which we can measure to describe the collision

Equipment list

1.2 meter track system
Force sensor
Motion sensor
Collision cart
Track system
Science workshop 750 interface
Triple beam balance
Accessory bracket\clamp
Block of wood

Procedure
1. Set up data center
2. Place cart 15 cm away from motion center
3. Hit stop after the cart bounces back
4. Record impulse and momentum using data center

Calculations and results

Discussion
The experiment was slightly flawed because of slow reaction times and not perfect equipment, with state of the art equipment it would have been 100% successful. Answer Questions

1. More momentum means more impulse
2. Because it takes time to record impulse
3. It would stop faster and there would be a sharper impulse curve
4. Because the slows down the forward momentum causeing less sevire injuries
5.

Conclusion

In this lab we found out that when the mass of an accelerating object hits a spring the is a rounded curve on the impulse graph. Average benefits from all welfare programs are about $9,000 per recipient. If you converted those programs to cash, it would be more than five times the amount needed to raise every household above the poverty line. We should streamline redundant programs to save money while getting the same or better value. They don’t need all of this money we should cut the amount we give them.

You May Also Find These Documents Helpful

  • Satisfactory Essays

    Chapter 18 Physics Lab

    • 343 Words
    • 2 Pages

    Fill out the tables below and check your work in the simulation. ( ½ pt each )…

    • 343 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    Physics Mastery Lab

    • 836 Words
    • 4 Pages

    In order for this equipment to assist one in measuring the speed of sound, the speaker and microphone are positioned inside the hollow tube with the speaker stationary at one end. The microphone is able to be moved and set a chosen distance from the speaker, from almost touching to 1 meter. The signal generator is connected to the speaker by a pair of wires. From this pair of wires, another pair of wires connects the signal generator to the frequency meter. A set of wires also run from the signal generator to the oscilloscope. A separate set of wires is connected from the oscilloscope to the microphone inside the tube. The set up of the equipment allows for the output of the signal meter to be read and measured by the frequency meter while being led to the speaker. This input causes the speaker to vibrate, which produces sound waves inside the tube. These sound waves, picked up by the microphone, are then sent to the oscilloscope as a signal. A pattern is displayed on the screen of the oscilloscope. With the signals in phase, the patterned displayed is a straight diagonal line. With…

    • 836 Words
    • 4 Pages
    Good Essays
  • Good Essays

    Science Lab

    • 562 Words
    • 3 Pages

    1. Be careful with copper (II) sulphate solution it is poisonous and corrosive. handle with care…

    • 562 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    Physics Lab Questions

    • 263 Words
    • 1 Page

    n a deep dive, a whale is appreciably compressed by the pressure of the surrounding water. What happens to the whale’s density? The whales density increases so its not compressed by the waters pressure.…

    • 263 Words
    • 1 Page
    Satisfactory Essays
  • Good Essays

    Physics Measurements

    • 391 Words
    • 2 Pages

    2). Make a table to record all of your data. Start measuring the diameter and circumferences of all your circular objects.…

    • 391 Words
    • 2 Pages
    Good Essays
  • Better Essays

    physics M & M lab

    • 835 Words
    • 4 Pages

    Introduction: Do you think you could measure the average thickness of a sample of M&Ms without directly measuring selected M&Ms? The answer is "yes," and in this activity you will make direct and indirect measurements of the thickness of M&Ms. You will compare the results and evaluate the reliability of each method of measurement. Be sure to view the tutorial on the proper use of the vernier caliper. Please re-visit the information on when to cite sources.…

    • 835 Words
    • 4 Pages
    Better Essays
  • Good Essays

    Physics Lab Report Impulse

    • 1163 Words
    • 5 Pages

    As the first lab of the Physics 2 curriculum, our class completed a lab experiment that introduced us students to a new concept that would be a foundation to the future topics that we learn in this class. In this lab activity, we used a lab cart on a flat track to compare the collision of the cart with a force sensor with and without the plunger during different trials. The materials that we would need for this activity are a lab cart on a flat track, a timer, a force sensor, and a Ti-Nspire Calculator. The Ti-Nspire Calculator was connected to the force sensor in order to track and create data that would be shown in graphs on the calculator. Because we had to compare the collision of the cart with the force sensor with and without the plunger, it would force us to run two trials in total (one run with the plunger, and one run without the plunger). Once all of the materials were prepared, I began with run one, which was with the plunger, and later run two, without the plunger.…

    • 1163 Words
    • 5 Pages
    Good Essays
  • Satisfactory Essays

    chemistry lab

    • 3757 Words
    • 34 Pages

    Regents Chemistry Quarter 1 Midterm Review 1. The percent by mass of oxygen in Na2SO4 (formula mass = 142) is closest to 1) 11% 3) 45% 2) 22% 4) 64% 2. Given the unbalanced equation: __Al(s) + __O2(g) → __Al2O3(s) 3. 4.…

    • 3757 Words
    • 34 Pages
    Satisfactory Essays
  • Satisfactory Essays

    Physics Lab Report

    • 349 Words
    • 3 Pages

    1. For the wavelength measurement of different colors in the Hydrogen spectrum done in the lab, tabulate your data recorded along with the wavelength calculations performed for all colors in the spectrum. (2 points)…

    • 349 Words
    • 3 Pages
    Satisfactory Essays
  • Good Essays

    physics

    • 549 Words
    • 3 Pages

    1. You rub balloons in your hair and then hang them like in the picture below. Explain why you think they move apart and what might affect how far apart they get.…

    • 549 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    Mathcounts

    • 543 Words
    • 3 Pages

    Respond quickly to changing fashions. Products are made to be used in a limited way.…

    • 543 Words
    • 3 Pages
    Satisfactory Essays
  • Satisfactory Essays

    physics

    • 274 Words
    • 2 Pages

    Using conservation of momentum we know the momentum before impact (collision) should be the same as the momentum after impact. Therefore:…

    • 274 Words
    • 2 Pages
    Satisfactory Essays
  • Powerful Essays

    Cart on an incline lab

    • 1526 Words
    • 6 Pages

    From all three graphs, it can be readily determined that the cart goes from a fast velocity-originating from the push start- to a slower one as the cart gets closer to the motion sensor and begins to change direction at the 3s mark. At…

    • 1526 Words
    • 6 Pages
    Powerful Essays
  • Good Essays

    Three Types Of Collisions

    • 888 Words
    • 4 Pages

    Collisions may involve many different qualities but momentum is a main aspect of a collision. There are three main types of collisions: elastic collisions, inelastic collisions, and completely inelastic collisions. All collisions involve momentum because momentum is conserved in all collisions. Momentum is also known as mass in motion and a vector. Momentum equals mass times velocity, which is found during a collision. Momentum is an important part during a collision because it determines the outcome of the collision depending on what is involved in the momentum.…

    • 888 Words
    • 4 Pages
    Good Essays
  • Satisfactory Essays

    Beam Experiment

    • 890 Words
    • 4 Pages

    Set up the beam AC with a span of 675mm (as shown in Figure 1).…

    • 890 Words
    • 4 Pages
    Satisfactory Essays