Preview

Calorimetry Equations

Satisfactory Essays
Open Document
Open Document
257 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Calorimetry Equations
Calorimetry Equations
Monday, October 28, 2013
12:00 PM

TOOL BOX q=mc∆T Water sp. Heat

Calorimetry : the measurement of energy (calorie)

Calorimeter : tool used to measure energy by Measuring the change in temperature

Equation : q=mc∆T What is the difference between Calorimetry and Calorimeter?

Quantity of
Energy (Cal.)

Mass
(g)

Specific heat (given) (Cal/g)

Change in temperature (℃ )
(End-short)

What is the dance that we learned in class today about our new equation?

Name all the Specific heat type and what they vary? ( if that makes sense)

Specific heat • Unique to every substance • Amount of energy required to increase 1g of substance by 1℃

High specific heat • Needs large amount of energy to change temp ex. Water
Low specific heat • Changes temp. easily ex.metal

Summary:

In today's class we talked a about the equation(s) of calorimetry. Calorimetry is the measurement of energy , and Calorimeter Is a tool used to measure energy by measuring the change in temperature. We also learn about the Specific heat, high specific heat, and low specific heat. But the main thing is that the new equation we learn today is

q=mc∆T
.Calorimetry
Sunday, October 27, 2013
6:35 PM

Calorie : Unit of energy Metry : Measurement Calorimetry : • Measurement of energy Energy : The ability to do work
Types of Energy : Kinetic & Potential

Movement

Stored

Heat

Chemical

Energy Laws : Laws of thermodynamics 1st Law : Energy cannot be created or destroyed, only transferred, or transformed 2ed Law : When energy is transformed or transferred, it becomes less useful ( "Lost" as heat )

Energy : energy flows like water • From high to low

You May Also Find These Documents Helpful

  • Good Essays

    6.03 Calorimetry Lab

    • 529 Words
    • 3 Pages

    Approximately 40 mL of the ionized water was added to the 100 mL beaker, then in a 10-mL graduated cylinder, 5-mL of HCl was measured then added to the 100-mL beaker of water. The 100 mL beaker was then placed on the assembled ring stand.…

    • 529 Words
    • 3 Pages
    Good Essays
  • Good Essays

    6.03 Calorimetry Lab

    • 446 Words
    • 2 Pages

    In this lab, we dissolved a calcium-enriched tablet and participate the calcium ion as calcium carbonate. Our purpose is to determine the masses of calcium carbonate and calcium ion, to determine the mass percent of calcium ion in the tablet and to compare the masses and the percent with the listed tablet ingredients. This time we used a 150mL beaker, analytical balance, forceps, a 50mL graduated cylinder, a glass rod, beaker tongs, a hot plate, two 16 x 125-mm test tubes, centrifuge, a medicine dropper, a filter paper, a filter funnel, a 250-mL Erlenmeyer flask, a watch glass, a drying oven, a spatula and a red litmus paper. The chemicals we need were 20mL of 2.0M HCl, a calcium-enriched tablet and 25mL of 1.0M Na2CO3 solution.…

    • 446 Words
    • 2 Pages
    Good Essays
  • Better Essays

    6.03 Calorimetry Lab

    • 1068 Words
    • 5 Pages

    This buffering ability is achieved via the equilibrium between the acid and its conjugated base in the reaction.…

    • 1068 Words
    • 5 Pages
    Better Essays
  • Satisfactory Essays

    6.03 Calorimetry Lab

    • 301 Words
    • 2 Pages

    Figure 1: Titration curve of 0.160 grams of an unknown diprotic acid that was dissociated in distilled water. Shown is the pH versus the volume in milliliters of 0.1 M NaOH, a strong base, added to the solution. The initial pH reading of the solution was a pH of 2.60. Although the pH of the ½ equivalence point was unknown, it could be estimated by halving the volume of NaOH used at the first equivalence point. At the first equivalence point, 13.63 milliliters of NaOH had been added to the unknown acid solution.…

    • 301 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    6.03 Calorimetry Lab

    • 380 Words
    • 2 Pages

    Class average for a 80 and 120 drop count was recorded to be 0.041+/- 0.005 mL/drop. If a graduated cylinder is not available there is another way of adding more of the solution. The disposable pipet can transfer 0.5mL of the solution to the chemical reaction. When comparing a 10mL graduated cylinder, a 100mL beaker, and a 50mL graduated cylinder, the most precision peace of glass wear would be the 10 mL graduated cylinder with the true volume of water (calculated), class average, and uncertainties being 9.7896 +/- 0.05mL. The 50mL graduated cylinder comes in second place with a true volume of water(calculated), class average, and uncertainties being 50.0001 +/- 0.22mL. The third peace of glassware coming in as the least accurate would be the 100 mL beaker with a true volume of water(calculated), class average, and uncertainties being 59.9999 +/- 0.82mL.…

    • 380 Words
    • 2 Pages
    Good Essays
  • Good Essays

    6.03 Calorimetry Lab

    • 5075 Words
    • 21 Pages

    Your teacher will demonstrate for the class the reaction of metallic copper with concentrated nitric acid, HNO3. This must be done in the fume hood. (Caution: Avoid breathing poisonous gases. Avoid contact of skin with nitric acid. It burns skin and clothing.) One student will be asked to feel the side of the demonstration beaker and report to the group. The products formed are copper(II) nitrate solution, Cu(NO3)2(aq), and nitrogen dioxide gas, NO2(g).…

    • 5075 Words
    • 21 Pages
    Good Essays
  • Good Essays

    Start off by weighing two paracetamol tablets using some accurate scales. Record the mass down (1.15g). This had to be as accurate and precise as we could get it so we had the correct weight to start the experiment. Without this then the results we found at the end would not be accurate. A problem that could be faced with this is that the scales may not have been fully set to zero. Also it takes time for it to fully reach its weight on the reading so you may move them too quick before the right weight has been set.…

    • 1079 Words
    • 5 Pages
    Good Essays
  • Satisfactory Essays

    6.03 Calorimetry

    • 331 Words
    • 2 Pages

    In order to describe the molar volume of pure water the equation V_3=M_3⁄ρ_(3 ) is used, whereas those of sodium nitrate and the polyether compound poly(ethylene glycol) (PEG) are shown by V_1=V_(∅_1)^∞and V_1= V_(∅_2)^∞. In these two equations, V_(∅_1)^∞ and V_(∅_2)^∞ which are the apparent molar volumes at infinite dilution of sodium nitrate and poly(ethylene glycol), must be computed on the basis of data on apparent molal volume (V_∅). The following equation shows the relation of the V_∅ of a binary solution with density, Equation 1…

    • 331 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    6.03 Calorimetry Lab

    • 356 Words
    • 2 Pages

    Add 50 milliliters of the solution you want to test to the beaker and record its mass. The mass of the solution is equal to the total mass minus the mass of the beaker.…

    • 356 Words
    • 2 Pages
    Good Essays
  • Good Essays

    6.03 Calorimetry Lab

    • 992 Words
    • 4 Pages

    In the first process of the lab, you measure the mass of water transferred from a buret to a beaker, to determine the experimental mass of the water, and the volume of the water collected. We measured the temperature of the water so we could calculate the density of the water, which enabled us to calculate the actual volume of water, by using the density and the measured volume of water. To determine the percent error, we had to subtract the actual volume of water by the experimental volume of water transferred from the buret to the beaker, and then divided it by the actual volume and multiplied it by 100. In the second process, you perform the same steps you did for the buret, but instead, you use a 5.00mL or 10.00mL pipet. You repeated each…

    • 992 Words
    • 4 Pages
    Good Essays
  • Good Essays

    Chetos

    • 971 Words
    • 4 Pages

    The amount of heat needed to increase the temperature of an object exactly 1°C is the heat capacity of that object. The specific heat capacity of a substance is then the amount of heat it takes to raise the temperature of 1g of the substance1°C. Caliometry is the precise measurement of the heat flow into or out of a system for chemical and physical processes. Heat flow is measured in two common units, the calorie and the Joule. 1 calorie= 1 kilocalorie = 1000 calories. A calorimeter is the device used to measure the absorption or release of heat. In this lab, the water in aluminum can “calorimeter” gains the heat lost during the combustion of a Cheeto.…

    • 971 Words
    • 4 Pages
    Good Essays
  • Good Essays

    Cold Pack Essay

    • 377 Words
    • 2 Pages

    Finally, the heat change for the calorimeter (qcal) will equal the measure temperature change (ΔT) times the heat capacity of the calorimeter using the…

    • 377 Words
    • 2 Pages
    Good Essays
  • Good Essays

    3.03 Calorimetry Lab

    • 681 Words
    • 3 Pages

    One of the wonders of this planet is water. Water makes up 65% of humans, and 70% of the Earth. It is also common knowledge that humans cannot survive three days without it. Water is essential. If almost three-fourths of Earth is made up of water, why are there still so many people in the world suffering from a lack of it?…

    • 681 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Gummy Bear Experiment

    • 1159 Words
    • 5 Pages

    Briefly, we define the amount of heat and/or work using two units, the Joule (J), and the calorie. The Joule and the calorie are related as follows:…

    • 1159 Words
    • 5 Pages
    Good Essays
  • Better Essays

    | Introduction to the experiment - a brief outline and relevant theory for the experiment and calculation…

    • 1999 Words
    • 8 Pages
    Better Essays

Related Topics