Preview

The Ford Pinto Case

Powerful Essays
Open Document
Open Document
9301 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
The Ford Pinto Case
THE FORD PINTO CASE:

THE VALUATION OF LIFE AS IT APPLIES

TO THE NEGLIGENCE-EFFICIENCY ARGUMENT

Christopher Leggett

Law & Valuation

Professor Palmiter

Spring, 1999

Abstract

Text of Paper

--------------------------------------------------------------------------------

Abstract

The cases involving the explosion of Ford Pinto's due to a defective fuel system design led to the debate of many issues, most centering around the use by Ford of a cost-benefit analysis and the ethics surrounding its decision not to upgrade the fuel system based on this analysis.

ISSUE

Should a risk/benefit analysis be used in situations where a defect in design or manufacturing could lead to death or seriously bodily harm, such as in the Ford Pinto situation?

RULE

There are arguments both for and against such an analysis. It is an economically efficient method which has been accepted by courts for numerous years, however, juries may not always agree, so companies should take this into account.

ANALYSIS

Although Ford had access to a new design which would decrease the possibility of the Ford Pinto from exploding, the company chose not to implement the design, which would have cost $11 per car, even though it had done an analysis showing that the new design would result in 180 less deaths. The company defended itself on the grounds that it used the accepted risk/benefit analysis to determine if the monetary costs of making the change were greater than the societal benefit. Based on the numbers Ford used, the cost would have been $137 million versus the $49.5 million price tag put on the deaths, injuries, and car damages, and thus Ford felt justified not implementing the design change. This risk/benefit analysis was created out of the development of product liability, culminating at Judge Learned Hand's BPL formula, where if the expected harm exceeded the cost to take the precaution, then the company must take the precaution, whereas if the

You May Also Find These Documents Helpful

  • Good Essays

    A product with a faulty design exposes its users to unnecessary risks, and products must be designed with all foreseeable uses in mind. Cars must be designed in view of the probability of accidents.…

    • 820 Words
    • 4 Pages
    Good Essays
  • Good Essays

    Ford Pinto Case Study

    • 537 Words
    • 3 Pages

    From reading the two assigned papers discussing the Ford Pinto fires, it is easy for someone to judge Gioia’s decisions as fallible before all the factors are in place. For example, the culture of the Ford motor company at the time, Gioa’s mental state. I believe he feels very responsible and that is why he wrote the paper and uses it as a living case study in his MBA classes.…

    • 537 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    Mgmt 301

    • 386 Words
    • 2 Pages

    The controversial numbers were those Ford used for the "benefit" half of the equation. It was estimated that making the change would result in a total of 180 less burn deaths, 180 less serious burn injuries, and 2,100 less burned vehicles. These estimates were multiplied by the unit cost figured by the National Highway Traffic Safety Administration. These figures were $200,000 per death, $67,000 per injury, and $700 per vehicle equating to the total "societal benefit" is $49.5 million. Since the benefit of $49.5 million was a lot less than the cost of $137 million, Ford felt justified in its decision not to alter the product design. The cost-benefit…

    • 386 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    Pinto Fires

    • 687 Words
    • 3 Pages

    b. If more time was taken to produce the car, the Pinto would have been a safer car…

    • 687 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Denny V Ford

    • 857 Words
    • 4 Pages

    Nancy approached a legal battle on three grounds. First, was a strict products liability. A manufacturer who places a product on the market in a defective condition is liable for injury which results from use of the product when the product is used for its intended or reasonably foreseeable purpose. In order for Nancy to use this claim the she had to prove by that Ford Motor Company placed the Bronco II on the market in a defective condition. According to the United States Second Circuit of appeals, “A product is defective if it is not reasonably safe. I instruct you that if the Bronco II, at the time it left the seller's hands, was so likely to be harmful to people that a reasonable manufacturer or person who had actual knowledge of its potential for producing injury would…

    • 857 Words
    • 4 Pages
    Good Essays
  • Good Essays

    Junk Van CAse

    • 594 Words
    • 2 Pages

    The problem presented in the 1-888-JUNK-VAN case involves the founder of the company Marcus Kingo trying to choose on the best information technology tool that would reduce order entry errors and allow his business to grow.…

    • 594 Words
    • 2 Pages
    Good Essays
  • Better Essays

    Ford Pinto Research Paper

    • 1124 Words
    • 5 Pages

    The Ford Pinto was first introduced to the North American market in 1970. The Pinto was introduced primarily to compete in the small car market with where Volkswagen dominated. The way the Ford Pinto was designed tragically left rear-ends accidents up in flames. This is because the gas tank was positioned in between the bumper and the axle. This was normal for small cars except the Pinto also had filler neck that was ripped out on impact which caused gas to spill out and eventually ignite. Ironically, years before, Arjay Miller, president of Ford at that time (1965), testified to Congress that Ford would lead the way with a fabric gas tank that would prevent fires in rear end accidents stating that the fabric gas tank “will be a feature you will see on our standard cars.”(Birch, 1994 p.16) Seven years later, a woman and her son were in one of these accidents. Sadly the woman died and the son was left with a scarred body. Ford upper…

    • 1124 Words
    • 5 Pages
    Better Essays
  • Good Essays

    Ford Pinto

    • 811 Words
    • 4 Pages

    The Ford Motor Company knowingly engineered the Ford Pinto with a design flaw in the placement of the gas tank and a design flaw in the connection of the fuel filler pipe. The Ford Pinto’s gas tank was placed immediately behind the rear axle of the vehicle instead of directly above it. There was only none inches between the gas tank and the axle and with bolts on the axle being in close proximity of the…

    • 811 Words
    • 4 Pages
    Good Essays
  • Good Essays

    The Pinto’s problems originated with placement of the gas tank. It was customary to place the gas tank between the rear axle and the bumper to give the vehicle more truck space. However, on the Pinto the gas tank was only nine inches away from the rear axle and on the rear axles transfer case were bolts that stuck out facing the rear bumper of the vehicle. When the Pinto was rear ended, the gas tank would be forced up to the rear axle, and the transfer case bolts would puncture the gas tank. Also the fuel filler pipe was poorly designed and could easily become detached in a rear end collision, causing gasoline to spill over the ground. This was the cause of the numerous large fires and the gas tank tendency to explode. Explosions of the gas tank occurred at any collision at or above thirty one miles per hour. The doors on the Pinto would tend to jam shut when rear ended at high speeds, causing victims to burn…

    • 1085 Words
    • 4 Pages
    Good Essays
  • Powerful Essays

    Ford Pinto Essay

    • 1402 Words
    • 6 Pages

    In 1978, the company recalled the Pintos in order to install a cheap baffle that would prevent the danger of rear-end collision fires from occurring, and that at that point, many people were still interested in purchasing Pintos (DeGeorge 299). However, this does not make Ford 's actions any more unethical. As Harvey Copp had noted, engineers and executives knew about the defect in the vehicle for years, and took no action even after people began to be injured (DeGeorge 299). It was only after it became less profitable for the company to avoid putting the baffle in, due to lawsuits and lost sales, that it finally took action to protect consumers, or even to admit that the Pinto posed a danger to them, and even this action had to be prompted by the American government (DeGeorge 299; Weinberg 45). Additionally, in 1978, not all consumers were aware of the Pinto 's danger, as some news programs like 60 Minutes had not yet reported on it; after they did so, the Pinto 's sales began to drop even further, creating a large number of long-term problems for Ford 's branding and profits (Weinberg 45). So, even though Ford had attempted to rectify its situation, it had to be forced into doing so by the government and consumers, and even the workers and shareholders that initially benefited from the Pinto ended up…

    • 1402 Words
    • 6 Pages
    Powerful Essays
  • Satisfactory Essays

    Ford Pinto Case

    • 422 Words
    • 2 Pages

    External social pressures play a big part in the decision reached about the Ford Motor Company. When you have highly respected individuals such as retired NASA engineer Dr. Leslie Ball say “The release to production of the Pinto was the most reprehensible decision in the history of American Engineering” (Newton, Ford, 2007, p. 1); there is cause for concern. There would be more social pressure today as opposed to the 70’s simply because of the availability of internet. There were a number of options that Ford had that would of prevented the deaths of so many people yet it was not done until eight years after the release of the first model. Lee Iacocca’s favorite saying was “Safety doesn’t sell cars (Newton, Ford, 2007, p. 1)”. Society today would not tolerate nor accept that kind of philosophy from corporations today. Ethically or morally is it right to put value on a human life as Ford did when doing their cost analysis.…

    • 422 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    It was further determined that when these elements are working together, they could have significant impact on reducing collisions. Alongside automakers, federal and local government agencies and other safety organizations agreed with the findings and began making changes. However, neither of the organizations would accept responsibility as to the cause of injuries or deaths due to the lingering liability issues. “If you don’t get into an accident you don’t have to worry about getting killed,” said Alex Haynes, an Executive Engineer for Vehicle Safety at Ford (Wetmore, 381). Many organizations continued to develop and push the three known elements to make driving a safer experience for…

    • 694 Words
    • 3 Pages
    Good Essays
  • Good Essays

    During this time the competition and pressure were intense. Wanting to be able to compete with the Japanese imports Ford created and rushed the production for their new Pinto. In making a reliable and safe car, production time usually last 43 months. The production for the pinto was finished in 25 months. The rush production and designed kept the price to sell less than $2,000. The test for rear end impact wasn’t tested until after it was produced and it failed. Ford Engineers knew that the testing for the rear end impact was a standard safety procedure. Engineers also knew of the major flaw on the car’s design. The fuel system was highly susceptible to rupturing and could lead to explosion. Because cars were already being assembled and wanting to meet the non-negotiable specifications set by Lee Iacocca Ford went ahead and released the car just to beat the competition. So the Ford Pinto went on sale with dangerous faults in the position of the fuel tank and the tendency for the fuel valve to leak in accidents if het from the rear (Leggett 1999). The car sold well, seven years after the release date through 1978 when it was finally recalled to have the baffle inserted. The cost benefit analysis demonstrated an abuse of utilitarian principles and the engineers were fully aware of the flaws yet the company continued to sell the car as it was with safety modifications. For $6.65 to $11 per car a baffle could’ve been placed between the bumper and gas tank and the Pinto would have compared to other cars of its class with respect to the danger of fire from rear end impact. Ford weighed the risk of harm and the overall cost of avoiding it. Did Ford put a price on human lives or was Ford trying to compete with foreign car companies to put an American vehicle made fuel efficient on the…

    • 903 Words
    • 4 Pages
    Good Essays
  • Good Essays

    Ford Pinto Case Brief

    • 407 Words
    • 2 Pages

    There was strong competition for Ford in the American small-car market from Volkswagen and several Japanese companies in the 1960’s. To fight the competition, Ford rushed its newest car the Pinto into production in much less time than it usually required to develop a car. The regular time to produce an automobile is 43 months; Ford took 25 months. Before production however, Ford engineers discovered a major flaw in the cars design. In nearly all rear-end crash test collisions, the Pinto's fuel system would rupture extremely easily. The technology was available to make the Pinto a safer vehicle. The best method for improving the safety of the Pinto was to line the gas tank with a rubber bladder. Ford alleged that it would cost $11 per car to add any sort of gas tank fire prevention device. Lee Iacocca, who was in charge of the development of the Pinto, had specifications for the design of the car that were uncompromisable. These specifications were that "the Pinto was not to weigh an ounce over 2,000 pounds and not cost a cent over $2,000." Any modifications, even if it did provided extra safety for the customer that brought the car closer to the Iacocca’s limits were rejected. A report was prepared for NHTSA by consultant; Eugene Trisko entitled "A National Survey of Motor Vehicle Fires." His report indicates that the Ford Motor Company makes 24 percent of the cars on the American road, yet these cars account for 42 percent of the collision-ruptured fuel tanks. Another staggering fact that was discovered was that a large and growing number of corpses taken from burned cars involved in rear-end crashes contained no cuts, bruises or broken bones. They clearly would have survived the accident unharmed if the cars had not caught fire. There was no single event that caused all of the deaths and injuries related to Pinto’s. Ford had many opportunities to limit the damage done by the faulty design of the Pinto. Engineers bowed to pressure from…

    • 407 Words
    • 2 Pages
    Good Essays
  • Good Essays

    Ford was primarily motivated by profit and market share, evidenced by their decision to not recall the car and choice to pay lawsuits instead of fixing the gas tank issue. Ford completely disregarded their responsibility to produce a safe product by foregoing the universal safety standards in order to increase profit – this action is not intrinsically valuable as it acts for the good of the company. If this maxim of foregoing car safety in order to increase profit was applied universally, there would be obvious contradiction from the employees of Ford who drove a pinto and would not agree to this rule. This contradiction implies that the maxim to forego safety standards in the interest of profit is not morally valid, and Ford using this maxim to make the decision to not recall the cars is morally…

    • 338 Words
    • 2 Pages
    Good Essays