Preview

Lab Report

Good Essays
Open Document
Open Document
1017 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Lab Report
Lab Report: Toothpickase and Enzymes

September 19, 2012

Olivia DePhillips
Lab Partner: Joy Morgan Meyers

Signature:

Introduction Enzymes are biological molecules that catalyze chemical reactions. In enzymatic reactions, the molecules at the beginning of the process, called substrates, are converted into different molecules, called products. Almost all chemical reactions in a biological cell need enzymes in order to occur at rates sufficient for life. Like all catalysts, enzymes work by lowering the activation energy for a reaction, thus dramatically increasing the rate of the reaction. As a result, products are formed faster and reactions reach their equilibrium state more rapidly. Most enzyme reaction rates are millions of times faster than those of comparable un-catalyzed reactions. As with all catalysts, enzymes are not consumed by the reactions they catalyze, nor do they alter the equilibrium of these reactions. However, enzymes do differ from most other catalysts in that they are highly specific for their substrates. Enzymes are known to catalyze about 4,000 biochemical reactions.
This activity/lab displays how enzymes work, and shows the effects of different substrate concentrations on the rate of enzyme activity. The toothpickase will break toothpicks as instructed, while the time keeper watches the clock. This breaking of toothpicks in a set amount of time represents how enzymes speed up reactions. We hypothesize that the toothpickase’s rate of activity will be higher when the toothpicks are more concentrated, as opposed to when they are less concentrated. If the toothpickase’s rate of activity is higher when the toothpicks are more concentrated, then enzymes work faster when substrates are more concentrated.

Materials 1. Two groups of 50 toothpicks, and one group of 35 toothpicks 2. One pencil per person 3. A watch or clock with easy access 4. One plastic bag 5. One lab packet per person 6. One calculator

You May Also Find These Documents Helpful

  • Powerful Essays

    Lab Report

    • 1310 Words
    • 6 Pages

    The cold pressor test is done by having the subject submerge their hands in a bucket of cold water to determine cardiovascular changes such as blood pressure and heart rate. For this experiment we wanted to know how long participant can keep their feet in the bucket of ice water before they experience any pain while looking at neutral and positive pictures and also rate the intensity of their pain. For this reason we hypothesized that, if participant submerged their feet in a bucket of water while looking at the positive stimulus, it would take them a long time to experience pain and will keep their feet in the bucket of ice for a long time than when participant are looking the neutral stimuli while they have their feet in the bucket of ice, we also hypothesized that heart rate will increase the longer participant keep their feet in the ice water. The null hypotheses was that, if participant submerge their feet in a bucket of water while looking at positive stimulus, it would take them the same amount of time to experience pain as when they are looking at the neutral stimulus and that heart rate will stay the same throughout the experiment…

    • 1310 Words
    • 6 Pages
    Powerful Essays
  • Good Essays

    Lab Report

    • 623 Words
    • 3 Pages

    The number of electrons forming a charge cloud around the nucleus is (pick one of the following) greater than; equal to; smaller than the number of protons in the nucleus of the atom.…

    • 623 Words
    • 3 Pages
    Good Essays
  • Good Essays

    lab report

    • 408 Words
    • 2 Pages

    The melting point of pure trimyristin is 55*to 56*C. The melting point recorded in this experiment is 49*C, giving the purity if the isolated trimyristin a classification of “poor”.…

    • 408 Words
    • 2 Pages
    Good Essays
  • Good Essays

    Lab Report

    • 1330 Words
    • 6 Pages

    The purpose of this lab is to investigate interference, otherwise known as the diffraction of light. A beam of light acts a wave, and we are able to use equations so calculate the wavelength of the light used. The diffraction of a straight edge demonstrates that light waves bend around straight edges, allowing light to enter an area of shadow. When waves are superposed, they reinforce each other when crests are in phase and cancel out when they are not in phase. An image projected by light waves shows this by producing concentric circles of light. When slits are used, the laser superposes itself and creates constructive interference. The resulting spots are measured to give data that allows one to find the wavelength using the equation λm = dsin θ. These diffraction and interference with such slits was successful because of low percent errors in the wavelengths calculated. Additionally, a diffraction gradient creates better-defined spots, and more accurate measurements, yielding the lowest uncertainties.…

    • 1330 Words
    • 6 Pages
    Good Essays
  • Satisfactory Essays

    Lab Report

    • 360 Words
    • 2 Pages

    Place 20.0 g of sucrose into a 250-mL Erlenmeyer flask, add 100 mL of water, and shake until sucrose is completely dissolved.…

    • 360 Words
    • 2 Pages
    Satisfactory Essays
  • Satisfactory Essays

    LAB REPORT

    • 401 Words
    • 3 Pages

    Learn to use trigonometry techniques programmed in EXCEL for calculating engineering type formulas to determine the altitude of an actual flight of a Level 2 rocket that the students have built in the Lab. A 2-angle (observer) technique will be used as taught in previous Lab to get the observed altitude.…

    • 401 Words
    • 3 Pages
    Satisfactory Essays
  • Better Essays

    Lab report

    • 979 Words
    • 4 Pages

    7) Begin the titration by twisting the lever on the side of the buret until small drops come out. Keep swirling the solution until a pink color is visible throughout from the phenolphthalein.…

    • 979 Words
    • 4 Pages
    Better Essays
  • Satisfactory Essays

    Lab Report

    • 487 Words
    • 2 Pages

    The mass of our beaker was 58.78g. Our piece of Zinc was massed at 1.24g. Therefore, the combined mass of the beaker and Zinc was 60.02g. After the reaction and heating, the combined mass of the Zinc Chloride and the beaker was 61.39g. We heated the substance again to remove any excess water. The combined mass of the beaker and Zinc Chloride was then 61.36g. To find the mass of the reacted Zinc Chloride we subtracted the mass of the beaker (58.78g) from the total and the mass of the Zinc Chloride came out to be 2.58g. Subtracting the mass of the Zinc (1.24g) from the Zinc Chloride mass, we found the mass of just the Chloride was 1.34g.…

    • 487 Words
    • 2 Pages
    Satisfactory Essays
  • Better Essays

    Catecholase Lab Report

    • 2324 Words
    • 10 Pages

    Enzymes are macromolecules that act as catalysts in living organisms by speeding up chemical reactions without being changed or destroyed by the reaction (Campbell and Reece, 2008). Enzymes are able to speed up the rate of a chemical reaction by decreasing the activation energy during the reaction (Garcia-Viloca et al., 2004). Activation energy is the lowest amount of energy needed to begin a chemical reaction (Campbell and Reece, 2008). Few biochemical reactions could take place quickly enough to satisfy the metabolic needs for living…

    • 2324 Words
    • 10 Pages
    Better Essays
  • Satisfactory Essays

    Lab Report

    • 641 Words
    • 3 Pages

    Ferrous ammonium sulfate, Fe(NH4)2(SO4)2.6H2O is dissolved in a slightly acid solution, excess oxalic acid, H2C2O4, is added and the following reaction takes place: Fe(NH4)2(SO4)2.6H2O + H2C3O4 FeC2O4(s) + H2SO4 + (NH4)2SO4 + 6H2O FeC2O4 is finely divided precipitate and tends to be colloidal. However, heating the solution causes it to coagulate and facilitates separating the precipitate from the solution. Potassium oxalate is added to the FeC2O4 precipitate, which produces a slightly basic solution for the oxidation of the ferrous ion to the ferric ion, by hydroxide, H2O2. The following reaction takes place: H2O + HO2- +2Fe2+ 2Fe3+ + 3OH- The OH- ion concentration of the solution is high enough so that some of the Fe3+ reacts with OH- to form ferric hydroxide(brown precipitate) as follows: Fe3+ + 3OH- Fe(OH)3 With the addition of more H2C2O4, the Fe(OH)3 dissolves and the soluble complex K3[fe(c2o4)3].3h20 is formed according to : 3k2C2O4 + 2Fe(OH)3 + 3H2C2O4 2K3[Fe(c2o4)3].3H20 + 3h2o Ethanol is added to the solution to cause the complex iron salt to precipitate.…

    • 641 Words
    • 3 Pages
    Satisfactory Essays
  • Good Essays

    Lab Report

    • 1339 Words
    • 6 Pages

    When a small compressive load is applied on an ideal column, it deflects laterally. And, when this load is removed, the column returns to its original position due to the elastic restoring forces. As the load is increased to a certain a value Pcr and then removed, the restoring forces are incapable to return the column to its original position but maintain equilibrium about the displaced lateral position. At this position there is displacement without the increase in the applied load. This critical load is termed as Buckling Load and this phenomenon is called as Buckling.…

    • 1339 Words
    • 6 Pages
    Good Essays
  • Good Essays

    Lab Report

    • 3011 Words
    • 13 Pages

    The three-phase induction motors could be categorized into two main types according to the different rotors: the squirrel-cage induction motors and the wound induction motors.…

    • 3011 Words
    • 13 Pages
    Good Essays
  • Powerful Essays

    lab report

    • 1416 Words
    • 6 Pages

    This experiment circles around with the Newton’s second condition of equilibrium in rotational motion. It describes by net torque acting on a body which is zero. The ability of the body to rotate in a certain direction is varied according on how much torque is applied. To prove that, a beam that is subjected to two forces is balanced by adjusting the perpendicular distances. When applied force is weight, modification in masses added is also done. Once equilibrium is achieved, or when the beam is not moving at a horizontal position, we can calculate for the unknown forces applied through the utilization of this principle.…

    • 1416 Words
    • 6 Pages
    Powerful Essays
  • Good Essays

    Enzymes are biological catalysts which speed up chemical reactions by lowering the activation energy, the energy required to break bonds. [1] Enzymes are also affected by factors such as temperature, cofactors, activators, inhibitors, and pH.…

    • 563 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    Lab Report

    • 862 Words
    • 4 Pages

    In this experiment, the mineral acid is added in excess to the calcium carbonate and the excess titrated against standard sodium hydroxide. This kind of titration is termed back titration. In this procedure, the analyte is consumed using excess titrant and the end…

    • 862 Words
    • 4 Pages
    Satisfactory Essays