Preview

Environmental Factors Influencing Amylase Enzyme Activity

Better Essays
Open Document
Open Document
2678 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Environmental Factors Influencing Amylase Enzyme Activity
Abstract: Enzymes are specific-type proteins that act as a catalyst by lowering the activation energy of a reaction. Each enzyme binds closely to the substrate; this greatly increases the reaction rate of the bounded substrate. Amylase enzyme, just like any other enzyme, has an optimum PH and temperature range in which it is most active, and in which the substrate binds most easily. The purpose of this experiment was to determine (1) the reaction rate of an amylase enzyme in starch and (2) the environmental factors that can affect the enzymatic activity. The hypothesis, in relation to the enzymatic activity by variables such as the substrate concentrations, temperature, PH and chemical interactions on the rate of reaction, stated the following scenarios: (1) If the substrate concentration is increased, then the enzymatic rate will increase (2) If the temperature is increased, then the enzymatic rate will also increase (3) If the PH level is increased, then the enzymatic rate will decrease. To test the effect of a substrate concentration on enzyme activity, the amylase enzymes were combined with a different substrate concentration (starch) and the rate of the reaction was determined with the aid of I2kI. If starch was detected, the solution turned to dark blue; if the starch was already broken down, then reaction stayed colorless. To test the optimal PH, the starch and a buffer were combined at a specific PH level and the rate of reaction was tested. To determine the optimal temperature of amylase enzyme, the solution and amylases enzyme were held at various temperatures and the rate of reaction was determined. The rate of reaction for amylase enzyme with less of the substrate concentration (1% starch) with concentration of 0.125% happened at a faster rate of only 20 seconds. The rate of reaction for amylase enzyme with the effect of varied PH occurred at a quicker rate with PH range of 5-6 close to neutral PH of 7.0 in less than 10 second.


References: • S. Shahriari, "Data on amylases”. Life Science Weekly 1 June 2010: 583. • Pfeiffer, J.: Enzymes, the Physics and Chemistry of Life, pg 171-173, Simon and Schuster, NY (1954) • Martinek, R.: Practical Clinical Enzymology: J. Am. Med. Tech., 31, 162 (1969). • Bennett, T. P., and Frieden, E.: Modern Topics in Biochemistry, pg. 43-45, Macmillan, London (1969).

You May Also Find These Documents Helpful

  • Good Essays

    2. Voet, D. and Voet, J. (2004). Biochemistry 3rd Ed. John Wiley & Sons, 6.3Bc p 139.…

    • 1380 Words
    • 6 Pages
    Good Essays
  • Powerful Essays

    Cox, Micheal M. Nelson, David L. 2008. Lehninger Principles of Biochemistry 5th Edition. USA. W H Freeman & Company…

    • 3513 Words
    • 15 Pages
    Powerful Essays
  • Good Essays

    Amylase Lab

    • 832 Words
    • 4 Pages

    In table 1 are the results for the bacterial amylase, what is depicted is the minutes passed and the number corresponding to the color most similar to the color chart provided by the lab manual. The results showed that the shade of yellow was lightest at 55 degrees. In table 2 the same information is recorded, showing once again the most activity at 55 degrees celsius. Picture 1 was taken by the group, showed the results of both the bacterial and fungal amylase and picture 2 shows the color chart referenced for the results of the charts. Graph 1 (bacterial) and graph 2 (fungal) represents the enzyme activity vs. change in temperature, they had similar results although the bacterial amylase had a higher activity…

    • 832 Words
    • 4 Pages
    Good Essays
  • Good Essays

    Potato Enzyme Lab

    • 622 Words
    • 3 Pages

    This was conducted through four different experiments. The first tested the effect of temperature on enzyme activity. The independent variable in the first experiment was the temperature of the solution of pH 7 buffer, potato juice, and the enzyme. The independent variable for the second experiment was the pH of the phosphate buffer. The independent variable for the third experiment was the enzyme concentration of the solution, and finally the independent variable of the fourth experiment was the substrate concentration.…

    • 622 Words
    • 3 Pages
    Good Essays
  • Better Essays

    The concept of this experiment was to analyze the enzyme Amylase and its environmental behavior. Amylase breaks down the biological macromolecule, carbohydrates, specifically starch into condensed subunits categorized as monosaccharaides or disaccharides. Two types of variables were human and fungal Amylase. Sum of six trials for both variables were conducted with two minutes intervals was measured for the duration. After every two minutes, the components were taken out of their controlled environment and joined with Iodine to observe visual change. The results gave supported facts that human amylase catalyzes at optimal level at forty-five degrees and fungal amylase at sixty degrees. At temperatures other than optimal for both observations concluded less progression to the visual change (Venturi, 2009).…

    • 1928 Words
    • 8 Pages
    Better Essays
  • Satisfactory Essays

    Biology 101 Lab Paper

    • 275 Words
    • 2 Pages

    * The objective of the experiment is to assess the effect of different pH conditions on enzyme activity.…

    • 275 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    Catalase Lab

    • 280 Words
    • 2 Pages

    From the graphs, it is evident that an increase in both catalase concentration and substrate concentration resulted in a higher rate of reaction or, as observed in the kPa graphs, a higher volume of O2(g) formed at the end of the 5 minute trial. Interestingly, it should also be noted, as it was mentioned in the Figure 2, that the trend for the 6mL of 3% H2O2(aq) was more of a linear trend than an exponential decay, steadily rising until the end of the 5 minute trial. From this, it can be inferred that this trial experienced a saturation point for the enzyme (catalase) to substrate (H2O2(aq)) concentration ratio. Thus, to truly understand this, the trial time period should be extended insofar that a declination in the rate of the reaction can be observed with multiple trials. If the trends of the independent trials coincide with one another, then it is plausible that a saturation point may have been a factor of the linear-like trend. This case will be further discussed in one of the five major factors that influence enzyme activity: enzyme concentration, substrate concentration, pH, metal salts, and temperature. Note that the data from the three latter variables were acquired from peers and will be used to support results.…

    • 280 Words
    • 2 Pages
    Good Essays
  • Powerful Essays

    Lab Report

    • 2214 Words
    • 9 Pages

    Hypothesis Enzymes must be kept at certain conditions to function at its optimum level. Indeed, factors that may cause the enzyme to denature are: pH, temperature, and salt concentrations. When an enzyme is denatured, it can no longer bind to the active site, and therefore cannot carry out its functions. Therefore, adding pH buffer to amylase will affect the enzyme’s function upon its addition to starch, which can be indicated by the iodine test. In fact, if the enzyme is denatured by the pH buffer, the iodine will turn blue-black when starch and enzyme solutions are added because the enzyme didn’t digest the starch. However, if the optimum pH is added…

    • 2214 Words
    • 9 Pages
    Powerful Essays
  • Good Essays

    Amylase Experiment

    • 607 Words
    • 3 Pages

    Throughout the course of this experiment, a number of results were recorded and data tables and graphs have been formed after testing the enzyme activity at the…

    • 607 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Bacillus Licheniformis

    • 307 Words
    • 2 Pages

    As time progressed and temperature increased, the solutions turned yellow, therefore, indicating that there is an absence of starch, as this was expected to happen in bacterial amylase. It fully hydrolyzed within 4 minutes at 85oC. Thus at the end of the reaction no starch should be present. However, this did not happen for fungal amylase. There was only slight color change at 85oC. We can come to a conclusion that an error occurred.…

    • 307 Words
    • 2 Pages
    Good Essays
  • Powerful Essays

    Four specific graphs were drawn to determine at which pH level and temperature was the optimum for the enzyme after the experiment. Although hypothesis that I made that it would work best under temperature near 40'' and at a pH of around 4, through my results the enzyme worked more efficiently under the temperature of 55''and pH level at 4.5. However, since the whole testing experimental was taken only once; we can not state that the result was precisely accurate. Introduction: The catalysts are the substance that speeds up chemical reactions in living organisms. The enzymes are the protein catalysts to lower the activation energy of a reactant. Enzymes are not able cause an inefficient reaction to occur and only able to increase the rate of biochemical reaction. The molecule that is reacting in enzymatic reaction is called a substrate. When an enzyme and substrate congregate together, then it forms an enzyme-substrate complex. As the enzyme works to accelerate the chemical reaction changes catalytic property and ultimately it decomposed.…

    • 1987 Words
    • 6 Pages
    Powerful Essays
  • Good Essays

    Digestion and Enzymes

    • 1310 Words
    • 6 Pages

    Many enzymes are specific for a certain substrate. For example, lipase is a specific enzyme for fat substrates and protease, a specific enzyme for protein substrates. In the same way amylase is a specific enzyme used for carbohydrate substrates. In our experiment, our substrate is starch and so our enzyme is amylase. I think that amylase will not work properly when heated at 10°C because enzymes need heat for the particles to gain kinetic energy and collide with each other. At10°C, enzymes don’t move as fast as they can if the temperature is increased, and thus the collision and the reaction don’t take place. However, if the temperature is increased over its optimal temperature then the enzymes become denatured. The breaking of a substrate happens, when a substrate molecule fits inside its specific enzyme molecule, so when an enzyme molecule becomes denatured, the 3D shape of the enzyme molecule changes and so the substrate can no longer inside the active site of the enzyme molecule due to its denatured shape.…

    • 1310 Words
    • 6 Pages
    Good Essays
  • Powerful Essays

    Enzyme Lab Report

    • 1403 Words
    • 6 Pages

    Pfeiffer, J.: Enzymes, the Physics and Chemistry of Life, pg 171-173, Simon and Schuster, NY (1954)…

    • 1403 Words
    • 6 Pages
    Powerful Essays
  • Good Essays

    The aim for this experiment is to investigate how the different buffer solutions work on the enzyme amylase. This will be investigated by using iodine and by timing the experiment using the colorimeter and the program Loggerlite.…

    • 1065 Words
    • 5 Pages
    Good Essays
  • Better Essays

    The purpose of this enzyme kinetic experiment was to observe the effect of temperature and pH on the reaction of barley alpha-amylase enzyme with starch substrate and establish the optimum temperature and pH for this reaction.…

    • 2093 Words
    • 9 Pages
    Better Essays