Melissa Carrithers AP Chemistry 12/17/14 Rate Law Determination Pre-Lab Purpose: The purpose of this lab is to observe the reaction between sodium hydroxide and crystal violet so that the order of the reaction could be determined along with the rate constant‚ k‚ and the half-life for this reaction. Hypothesis: If the reaction between crystal violet and sodium hydroxide reacts appropriately‚ then the order will be first order. Procedure: Mix 10 mL of sodium hydroxide and crystal violet solution
Premium Chemistry Rate equation
To investigate how does the concentration of Hydrochloric acid affect the rate of reaction? Outline I aim to discover how different concentrations of Hydrochloric acid influence the rates of reaction. In order to carry out this investigation I have decided to use marble chips‚ which I will vary the sizes as powder‚ small chips and large chips. I will also be changing the concentration‚ the different concentrations are as follows 0.2m‚ 0.5m‚ 1m‚ 1.5‚ 2m. I have chosen these concentrations as they
Premium Chemical reaction Hydrochloric acid Reaction rate
purpose of laboratory assignment 3 was to measure the rate at which a chemical reaction takes place. For the purpose of this lab we measured the rate a balanced oxidation/reduction reaction between iodine‚ hydrogen‚ and bromate ion occurs. The above reaction occurs slowly so we used a coupled iodine clock reaction to measure the rate of the oxidation/reduction reaction because it occurs much faster but is still dependent upon the other reaction. To accomplish this‚ two mixtures were prepared in separate
Premium Chemistry Chemical reaction Oxygen
graph‚ you can see that there is a relation between the rate of reaction and the surface area. The larger the surface are‚ the faster the rate of reaction seems to be. However‚ although the grain with the largest surface area (the smallest grain) reached the highest point within the shortest amount of time‚ its end result was still lower then the medium sized grain. The explanation for this result is relatively easy. The rate of a chemical reaction can be increased by increasing the size of the surface
Premium Chemical reaction Chemistry Reaction rate
Aim: To determine the rate law of chemical reactions Introduction: The aqueous solution of potassium peroxydisulphate can oxidize potassium iodide as follow: Equation: K S 0 (aq) + 2KI (aq)->2K S0 (aq)+I (aq) 2 2 8 2 4 2 KI(aq) +I (aq) -> KI (aq) 2 3 _________________________________________________ K S 0 (aq) +3KI(aq) -> 2K S0 (aq)+ KI (aq) 2 2 8 2 4 2 The rate law of this reaction can be represented as follow: Rate=k[S208 2-]^a [I-]^b When the concentration of peroxydisulphate ions
Premium Chemistry Chemical reaction
Investigate the effect of concentration on the rate of a reaction Research question: To what extent does the concentration of hydrochloric acid affect the rate of the following reaction: 2 HCl(aq) + CaCO3(s) → CaCl2(aq) + H2O(l) + CO2(g) Data Collection and Processing: Table1: Different volumes of Co2 gas produced by Different concentrations of HCL acid. Volume of CO2gas formed from 5 different concentrations of HCL acid ±0.5ml 5 different concentrations of HCL acid (Mol) ±0.5ml Time (sec) ±0
Premium Chemical reaction Chemistry Chlorine
An investigation in to the rate of reaction Plan: I am going to investigate the rate of reaction. The reaction I will be using is: Calcium Carbonate + Hydrochloric acid ---- Calcium Chloride + water + carbon dioxide. CaCO3 + 2HCl ---- CaCl +H2O + CO2 Measurements and Variables: The variables I have chosen to change is strength of the hydrochloric acid which will be 1 mole‚ 0.7 mole‚ 0.5 mole‚ 0.3 mole and 0.1 mole some variable I will not be using are temperature‚ mass‚ density. The measurements
Premium Chemical reaction Reaction rate Chemistry
Kinetics of the Persulfate – iodide Clock Reaction The purpose of this experiment is to determine the rate law and the activation energy for the reaction between persulfate ion‚ S2O82-‚ and iodide ion‚ I-: S2O82-(aq) + 2 I-(aq) 2 SO42-(aq) + I2(aq) The rate law can be written as Reaction rate = (1) Where m and n are the orders with respect to S2O82- and I-‚ respectively‚ and k is the rate constant. Determining the rate law involves determining the values of m and
Free Chemical reaction Chemical kinetics Chemistry
Title Experiment 17 Reaction Kinetics- Determination of the Activation Energy of the Reaction Between Oxalic Acid and Potassium Permanganate. Objective To determine the activation energy of the reaction between oxalic acid and potassium permanganate. Theory and Background Activation energy is the minimum amount of energy that is required to activate atoms or molecules to a condition in which they can undergo chemical transformation or physical transport. In terms of the transition-state
Free Chemical kinetics Chemical reaction Reaction rate
Abstract This experiment is to study the effect of temperature on the rate of reaction between potassium permanganate with oxalic acid. We used 2cm3 of 0.02M potassium permanganate and 4cm3 of 1M sulphuric acid into a test tube. In another test tube‚ we placed 2cm3 of oxalic acid. We placed the test tubes in a water bath at 40‚ 45‚ 50‚ 55 and 60oC respectively. When the solutions have attained these temperatures pour the oxalic acid into the acidified permanganate solution and recorded the time
Premium Chemical kinetics Reaction rate Chemical reaction