"Lab report on water hardness" Essays and Research Papers

Sort By:
Satisfactory Essays
Good Essays
Better Essays
Powerful Essays
Best Essays
Page 4 of 50 - About 500 Essays
  • Good Essays

    Bohnenberger Professor Van Doorn ENVS 150-002 2 March 2015 Water Quality Lab Report Introduction: When people are asked about how water is characterized‚ they usually will think of saltwater‚ freshwater‚ safe-to-drink freshwater‚ and tap water. Only a few people understand that water and its quality are characterized in several other ways beyond salt‚ fresh‚ and tap water. In 1967‚ the Water Quality Act‚ which was an amendment of the Federal Water Pollution Control Act‚ was passed. The Act required

    Premium Water pollution Water quality

    • 847 Words
    • 3 Pages
    Good Essays
  • Better Essays

    Pond Water Lab Report

    • 1653 Words
    • 7 Pages

    Nitrate on Pond Water By Claudia Phillips September 6‚ 2014 Block Two INTRODUCTION This lab was designed to study and observe the effects of phosphate and nitrate applied to pond water (1). Phosphorous‚ commonly used in fertilizers‚ is a necessary and vital element for life but can enhance the effects of eutrophication (the over-enrichment of nutrients in water) (2). Nitrate is a common source of food for most algae‚ but too much can make living conditions in water harsh (3). They are

    Premium Water Eutrophication Nitrogen

    • 1653 Words
    • 7 Pages
    Better Essays
  • Good Essays

    Foul Water Lab Report

    • 743 Words
    • 3 Pages

    The intention of the “Foul Waterlab was to purify a sample of sewage water and conserve as much as possible. The water should be clean enough to wash your hands with. My hypothesis is that the water will be cleaner than the initial water sample‚ but not to the standard that I would wash my hands with. Significant terms to know include purification‚ filtration‚ adsorption‚ volume‚ clarity‚ dissolved‚ filtrate‚ impurities‚ pipette‚ clay triangle‚ funnel cone‚ iron ring‚ beaker‚ and Erlenmeyer flask

    Premium Water Water pollution Sewage treatment

    • 743 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Experiment # 4a Title: Determination of the Hardness of Water from a Waterfall Aim: To determine the molarity of EDTA and to determine the hardness of water by measuring the concentrations of calcium and magnesium in a water sample by titration. Abstract: The aim of this experiment was to determine the molarity of a sample of EDTA and then to use this sample to determine the hardness of a sample of water. This was done using a titrimetric method. This was standardized using calcium chloride.

    Premium Calcium Calcium carbonate Water

    • 1620 Words
    • 7 Pages
    Good Essays
  • Good Essays

    Steel Wool Scissors Ruler Lemon Juice Orange Juice Vinegar Distilled Water Four Small Bowls Thin Towel Tall plastic cup Graph Paper Procedure: Before beginning your experiment‚ make sure that the distilled water has been opened and exposed to the air for at least a few hours. This will allow it to absorb some carbon dioxide from the atmosphere and lower its pH from a level of about 7 to about 5.8. The distilled water will act as a model for "normal" rainwater‚ which has a pH of about

    Premium Water Distillation Laboratory glassware

    • 800 Words
    • 4 Pages
    Good Essays
  • Better Essays

    Water Analysis Lab Report Purpose: In this lab we will be testing a number of water samples. These water samples come from various water sources. Each of these water samples will undergo four different tests. The four tests include a pH test‚ a conductivity test‚ a total and phenolphthalein and alkalinity test‚ and a total hardness test. This lab requires comprehension of lab material and techniques learned in prior labs (Kippenhan‚ 2012). Procedure: Each

    Premium Water Water pollution Chemistry

    • 2379 Words
    • 10 Pages
    Better Essays
  • Satisfactory Essays

    Water Density Lab Report

    • 815 Words
    • 4 Pages

    purpose of this lab was to practice measuring the mass and volume of different samples and to calculate the density and specific gravity of those samples using the measurements. B. Equipment 1. Electronic balance- The electronic balance is a device used to measure the exact mass of an object 2. Graduated cylinder- The graduated cylinder is a tool used to measure the volume of a liquid 3. Pipets- Pipets are small tubes that suck up and contain liquids C. Technique 1. The water displacement technique

    Premium Chemistry Water Test method

    • 815 Words
    • 4 Pages
    Satisfactory Essays
  • Better Essays

    | The Chemistry of Natural Waters | Chem 111 Sec 104 | | Hyunjung Hwang | 11/6/2012 | TA: Sarah Boehm‚ Group members: Rachel Hoffman‚ Dan Hirt | Introduction Water hardness is a major part of overall water quality that affects many industrial and domestic water users. Water is considered hard when there are high concentrations of the divalent cations Magnesium and Calcium; water hardness is considered as the sum of both the calcium and magnesium concentrations and expressed as

    Premium Water Calcium Hard water

    • 2778 Words
    • 12 Pages
    Better Essays
  • Good Essays

    Water Quality Lab Report

    • 431 Words
    • 2 Pages

    Introduction: This lab investigates the question‚ what is the water quality of the U-High creek based on micro invertebrates found in the creek? There are many factors that affect the quality of water such as phosphorus and nitrogen levels‚ dissolved oxygen‚ and pH. Phosphorus and nitrogen in water can increase the growth of aquatic plants and algae‚ leading to the decomposition of dead plant material and the removal of dissolved oxygen from water. The total nitrogen concentrations for freshwater

    Premium Water Water pollution Oxygen

    • 431 Words
    • 2 Pages
    Good Essays
  • Satisfactory Essays

    1. Put your safety goggles and lab coat on. 2. Gather all the necessary materials in order to conduct this experiment such as boiled water‚ distilled water‚ calcium chloride‚ distilled water‚ glycerin‚ test tubes‚ nails‚ test tube rack‚ graduated cylinders‚ tongs‚ scoopula‚ erasable marker and parafilm. 3. With the erasable marker‚ label the ten test tubes from 1 to 10. 4. For Test Tube 1‚ drop an iron nail in it without adding anything else. Place the test tube into the to-be-heated rack (50⁰F)

    Premium Water Laboratory equipment Chemistry

    • 500 Words
    • 2 Pages
    Satisfactory Essays
Page 1 2 3 4 5 6 7 8 9 50