Abstract. This report is about how to standardize a Sodium Hydroxide (NaOH) solution by titrating it with pure sample of Potassium acid Phthalate (KHC8H4O4). This experiment has two sections. The first section is to standardize the Sodium Hydroxide by titration. Three sample of 0.7 – 0.9 g of solid KHP are place into each of the three numbered Erlenmeyer flasks. 50 ml of distilled water are added to each three of it from graduated cylinder and constantly shake it until the KHP solution are completely
Premium Sodium hydroxide Titration
molar enthalpy change of a neutralization reaction Principle H2SO4(aq)+2NaOH(aq)=Na2SO4(aq)+2H2O(l) The reaction is a exothermic reaction‚ when the heat released by it is absorbed by water‚ the temperature of the water increases. The heat produced by the reaction can be calculated if it is assumed that all the heat is absorbed by the water. Heat change of reaction=-heat change of water =-mH2O×cH2O×△TH2O As the water has gained the heat produced by the reaction‚ the heat change of reaction is negative
Free Thermodynamics Temperature Sodium hydroxide
the effect of concentration on the rate of a reaction Research question: To what extent does the concentration of hydrochloric acid affect the rate of the following reaction: 2 HCl(aq) + CaCO3(s) → CaCl2(aq) + H2O(l) + CO2(g) Data Collection and Processing: Table1: Different volumes of Co2 gas produced by Different concentrations of HCL acid. Volume of CO2gas formed from 5 different concentrations of HCL acid ±0.5ml 5 different concentrations of HCL acid (Mol) ±0.5ml Time (sec) ±0.1 0.25mol 0.50mol
Premium Chemical reaction Chemistry Chlorine
Calorimeter Determination of Reaction Enthalpy 9/11/2014 Introduction: A chemical reaction often indicated by a transfer of energy measured in heat. By measuring this heat transfer in a constant pressurized environment‚ the enthalpy of the reaction can be used to infer certain information about a specific reactions reactants and products. The transfer of heat from outside sources in would be described as an endothermic reaction. Contrary‚ when a reaction releases heat out to its surroundings
Premium Thermodynamics Energy Enthalpy
Enhtalpy change - Hess’ law Experiment #7 Date performed: March 4‚ 2014 Presented by: Sam Tabah(I.D.#1402433) & Giuliano Amato(I.D.#1328425) General Chemistry 202 Nya-05 (00006) Vanier college Part A. Objective: The objective of this lab was to determine the standard heat formation (∆H°F) of MgO‚ using a calorimeter and determining the enthalpy of two reactions. Applying Hess’ law we were able to determine the standard heat formation of MgO. Introduction
Free Thermodynamics Enthalpy Energy
Enthalpy of Displacement IB Topic: Energetics Assessment Criteria: DCP‚ CE DATA COLLECTION AND PROCESSING ASPECT MARKS AWARDED Recording raw data: Processing raw data: Presenting Proceeded data: TOTAL: CONCLUSION AND EVALUATION Conclusion Evaluation Improving the procedure TOTAL AIM: Experimentally determine the enthalpy change of the displacement reaction between zinc and copper sulphate. Zn (s) + CuSO4 (aq) Cu (s) + ZnSO4
Premium Thermodynamics Sulfuric acid Copper
A buffer is an aqueous solution that allows resistance to significant change in pH when small amounts of strong acids or base are added to it. (Boundless‚ 2015) This is usually formed when a weak acid is added to a salt of its conjugate base. (Chemicool.com‚ 2014) When an Alka Seltzer tablet is dissolved in water‚ a buffer is formed when the weak acid citric acid is present with sodium citrate (citrate ion) the conjugate base (Buffer Balancing Acts Buffers‚ 2009) "Na3C3H5O7 (aq) + 3 HCl (aq)
Premium Acid Chemistry Water
Zinc and Hydrochloric-Acid Written By Kahlil Zione Date:02/02/05 Abstract: We observed the reaction between zinc and hydrochloric acid and recorded it in a table and learned wether the percentage of zinc is effected by the amounts of both substances added to the solution. Introduction The purpose of this experiment is to determine if the amount of zinc and hydrochloric acid will effect the percentage of the zinc in the out coming solution. We are reacting zinc metal with hydrochloric
Premium Water Chemistry Chlorine
Aim During this experiment I will be investigating if heating limestone and changing the concentration of the acid will affect the rate of reaction. Preliminary work Before doing our main experiment‚ we will have to conduct another experiment‚ to see what concentration of acid we will have to use. We done this using 0.1M‚ 0.5M and 1M of Hydrochloric acid‚ and 0.1g of powdered limestone‚ we used powdered limestone‚ as it would be a fairer test‚ I think this as all the particles of limestone will
Premium Chemical reaction Heat Reaction rate
forms of dirt do not dissolve in water. Conversely‚ soap can suspend these in such a way that it can be discarded through its ability to act as an emulsifying agent. This emulsifying agent enables the dispersion of liquid into another immiscible liquid. In this manner‚ oil does not mix with water whereby able to induce dirt. 2. Raw materials and soap making Soap making requires two major raw materials: * Fats and oils Fats and oils are esters of fatty acids and glycerol. These are obtained
Premium Sodium hydroxide Soap Sodium chloride