week 1 ilab

Student Name ________________________________ Date 05/09/2013_____________
SEC572 Security Testing iLab Task 1 – Verify Connectivity between Router and Hosts

Complete the table below based on the dynamic routes displayed in the routing table:

Routing protocol Destination Network Metric Outbound Interface
R - RIP 192.168.100.0/24 1 Serial0/0
R- RIP 192.168.200.0/24 1 Serial0/1

• Select the Task 1 commands and output in the Virtual CLI using the mouse. Click on the Copy button. Use V to paste the commands into your Lab Document.

ISP_Router con0 is now available

Press RETURN to get started.

ISP_Router>
ISP_Router>
ISP_Router>
ISP_Router>
ISP_Router>enable
ISP_Router#show ip interface brief
Interface IP Address OK? Method Status
FastEthernet0/0 200.100.0.1 YES NVRAM up
FastEthernet1/0 200.100.40.1 YES NVRAM up
Serial0/0 200.100.10.1 YES NVRAM up
Serial0/1 200.100.20.1 YES NVRAM up
ISP_Router#show ip route
Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B - BGP D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2 E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2 * - candidate default

Gateway of last resort is not set
Displaying routing table from result of FLAN table

R 192.168.100.0/24 [120/1] via 00.100.10.2, Serial0/0
R 192.168.200.0/24 [120/1] via 00.100.20.2, Serial0/1
C 200.100.0.0/24 is directly connected, FastEthernet0/0
C 200.100.10.0/24 is directly connected, Serial0/0
C 200.100.20.0/24 is directly connected, Serial0/1
C 200.100.40.0/24 is directly connected, FastEthernet1/0
ISP_Router# ping 192.168.100.10

Type escape sequence to abort.
Sending 5 100-byte ICMP Echos to 192.168.100.10, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip