Preview

vehicle modification

Good Essays
Open Document
Open Document
1099 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
vehicle modification
(909)389-0444
(909)389-0439
WWW.BULLETPROOFSUSPENSION.NET

12" 04 to 08 Ford F-150 4WD
Hardware Kit
Cage/Steering Hardware Pkg.

Quantity
4
1
4
1
2
8

Size/ Discription
M18 X 1.5 X 150 Bolts-machined
1/2" X 4" Bolts
M18 Lock Nuts
1/2" Lock Nut
1/2" SAE Washers
Alignment Cams

A-Arm Pkg.

Quantity
2
2
2
2
4
2
8
4
4

Size/ Discription
3/4" X 5 1/2" Bolts
3/4" Lock Nuts
3/4" SAE Washers
1" Uni-balls
Mis-Alignment Adatpors 1 X 3/4"
Snap Rings
Bushings M02225
Sleeves 7/8 I.D.9/16 O.D. 2 1/2"
90 Zerks

UCA Drop Down Pkg.

Quantity
4
4
4
4
4
4
8
8
8

Size/ Discription
3/8" X 1 1/2" Bolts
1/2" X 1 1/2" Bolts
9/16" X 4" Bolts
3/8" Lock Nuts
1/2" Lock Nuts
9/16" Lock Nuts
3/8" SAE Washers
1/2" SAE Washers
9/16" SAE Washers

Coil Over Pkg.

Quantity
4
2
4
2
6
8
2
6

Size/ Discription
1/2" X 3" Bolts
3/4" X 5" Bolts
1/2" Lock Nuts
3/4" Lock Nuts
3/8" Lock Nuts
1/2" SAE Washers
3/4" SAE Washers
3/8" SAE Washers

Impact Bars Pkg.

Quantity

Size/ Discription

Check off Check off Check off Check off Check off 2
2
2
2
4
4

Sway Bar Drop Down Pkg.

Hardware Kit
Sway Bar Links

Steering Shaft w/ plastic heim
Hardware Kit
Steel Braided Brake Lines
Power Steering Hose
Sway Bar Links (4 1/2" long)
Clevis (4)

Quantity
4
4
8

5/8" X 3" Fine Bolts
9/16" X 1 1/2" Bolts
5/8" Nylon Jam Nuts
9/16" Lock Nuts
5/8" SAE Washers
9/16" SAE Washers
Size/ Discription
3/8" X 1 1/2" Bolts
3/8" Lock Nuts
3/8" SAE Washers

Check off continued
Quantity
4
4
4
4
4
8
4

Size/ Discription
1/2" Stover Nuts
1/2" SAE Washers
5/8" X 5/8" Heims
5/8" Jam Nuts
5/8" X 3" Bolts
5/8" SAE Washers
5/8" Stover Nuts

Check off Note: 4WD Your front driveshaft will need to be extended 1 ½”

1 Secure the rear tires.
2 Make sure the front tires and the steering wheel are straight.
3 Loosen the lug nuts on the front tires.
4 Raise vehicle

You May Also Find These Documents Helpful

  • Good Essays

    Nt1210 Lab 3.1.3

    • 427 Words
    • 2 Pages

    The calculations for the duplex #35 chain can be repeated for the single #35 chain. A 10.7” diameter and 0.375” pitch is necessary for a 90 tooth sprocket connected to the tire. A 2.29” diameter and 0.375” pitch is necessary for a 19 tooth sprocket connect to the output of the main shaft. This provides a 21.1% reduction between the two sprockets. The center-to-center distance is determined by the wheel base, resulting in C being 25”. Following equation (6), the chain length is 118…

    • 427 Words
    • 2 Pages
    Good Essays
  • Powerful Essays

    Jamie Howards is 25 years old and living in Springfield, Pennsylvania. The young artist is well-known in the art world for his large installation pieces, unlike many artists that paint portraits or sculpt small things. Jamie has achieved success and praises with his past work and now, he is working on his new art project: “Art for Clunkers”.…

    • 1428 Words
    • 6 Pages
    Powerful Essays
  • Satisfactory Essays

    Case Study Of Vehicle 2

    • 218 Words
    • 1 Page

    Driver of vehicle 1, Daysha Johnson, stated she was traveling south on North Tucker Boulevard passing Cole Street. Johnson stopped at the rear of vehicle 2 and looked down at her phone. Johnson stated she thought cars began to move so she proceeded south on North Tucker Boulevard where she struck the rear bumper of vehicle 2.…

    • 218 Words
    • 1 Page
    Satisfactory Essays
  • Good Essays

    Trophy Trucks are the fastest class of off-road racing vehicles which are designed and built to resemble modern pickup trucks. Although any truck that meets the safety standards can race the trophy truck class, they, for the most part, feature long travel suspensions and high power engines. They are intended for desert racing, and are not street legal. Trophy Trucks can reach speeds in excess of 135 miles per hour even over rough terrain. This puts them among the fastest off-road vehicles in the world. The trucks are most frequently associated with the Baja 1000 race, series that have featured trophy trucks including SCORE International, and Best In The Desert or BITD, in which they are referred to as "Trick Trucks".…

    • 306 Words
    • 2 Pages
    Good Essays
  • Good Essays

    * What is the optimal “one-price” policy for Sprongl’s rally tires if he sticks with his “base prices” for the entire year? (Assume his goal is to have no residual inventory and to maximize total revenue).…

    • 633 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Anytime Truck Repair

    • 1512 Words
    • 7 Pages

    Anytime Truck and Trailer Repair in Milan, IL is the reliable company that is always ready and available whenever you need an emergency trailer repair. Our reputable professionals have experience conducting a number of accurate repairs and they are also able to make your trailer look and perform like new. For a number of years we have specialized in repairing a variety of trailers and restoring them in such a way that you will be satisfied with the results. You will never have to worry about finding the right repair service that meets your needs. At Anytime Truck and Trailer Repair, you are guaranteed of having an excellent experience. By choosing our trailer repair service, you are getting solutions that go beyond your expectations.…

    • 1512 Words
    • 7 Pages
    Good Essays
  • Good Essays

    Can Car

    • 734 Words
    • 3 Pages

    The goal of the can car lab was to create a rubber band-powered car that demonstrates Newton’s laws, and conservation of energy. The advantages of having a heavy rolling can is that I would have a lot of rotational energy and momentum, the disadvantage is the car has more static inertia. If the car has more static inertia, then it will be harder for the can to roll backwards at the end of its run. The factors affecting the can’s net force (once the rubber band is unwound, but when the car still has momentum) are, force of gravity, normal force, KE, rubbing friction (into heat), the re-winding of the rubber band, wind, and air resistance. The force of gravity and support force cancel out, the wind almost cancels the air resistance against the can, and the KE is a greater force at this moment than the air resistance, re-winding (PEe), and the friction. At this moment the car is able to go forward. The PEe rewinding gets greater as the can moves due to the amount of force need to spin the rubber band increasing. Force car pushes on road, for road on car and the Force popsicle stick in on to the can lid, force can lid pushes out on the popsicle stick.…

    • 734 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    You as signing principal of California Limited Power of Attorney for Retrieval of Motor Vehicle Form are authorized to issue such document under the California Vehicle Code, Section 14600-14611, 34620-34624, and 9950-9955. You issue a limited power of attorney with natural termination in 30 days from the date of its issuance. Please provide motor vehicle particulars accurately as required in this form. You must review this document carefully to understand and accept the scopes of the powers allotted to the agent to possess, store, and transport a motor vehicle you own legally. You must notarize your signature and identity before a competent notary public in California State for its execution. You must complete this retrieval of motor vehicle limited…

    • 483 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    Super Car Research Paper

    • 351 Words
    • 2 Pages

    Those who are fans of Superman know he is one of the most desperate characters in the world of fiction. However, without the abilities, the god like Clark Kent is just an ordinary journalist of the Daily Planet who is not a threat to planet-smashing villains and needs a reliable way to travel.…

    • 351 Words
    • 2 Pages
    Good Essays
  • Satisfactory Essays

    Are you looking for the best muscle car in the market today? The muscle cars are not designed only to win races Muscle cars continues to aspire many Americans even today though they were made using primitive tools and inexperienced craftsman in the past. Therefore, if you are planning to get into the market of muscle cars you need to consider various factors as discussed below;…

    • 304 Words
    • 2 Pages
    Satisfactory Essays
  • Satisfactory Essays

    “my lug nuts require more torque then A Honda makes.” You should buy a muscle car over a tuner any day. You should buy a muscle car because you’ll get more respect the more fun to have and the costs less to fix up. Over all muscle cars are just a better car to have. Yes tuner cars in better gas mileage and they are lighter. But muscle cars have more power and are faster.…

    • 490 Words
    • 2 Pages
    Satisfactory Essays
  • Satisfactory Essays

    Fun Truck Accessories

    • 300 Words
    • 2 Pages

    Customize your truck with fun truck accessories. Choose something to suit your personality. Whether it's camo truck accessories, pink, animal print or something else, it's easy to give your vehicle a unique look. We also stock wonderful accessories for the car as well.…

    • 300 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    Body Modification

    • 1008 Words
    • 5 Pages

    In today’s society, people are significantly embracing the style of body modification. It appears that no matter where one is in the world, it is impossible to evade the reality of body art; the appearance of tattoos and piercings. It has become a fundamental part of our society. Appearance norms make people look similar and people break the rules and violate appearance expectations. Some of these deviants form deviant communities. These communities are driven by the need to achieve social cohesion and inclusion. There is much debate about why people modify, manipulate and mutilate their bodies involving tattoos and piercings. There are two main reasons that a functionalist would approach to understand this deviant behavior. First, tattoos and piercings give people a group membership in a deviant community, helping promote self identification. Second, Tattoos and piercings also serve as a boundary line to what is acceptable and what is not in our society. Although tattoos and piercings increase a person’s acceptance into a deviant community, it also, increases rejection in a conventional community. (Tepperman, 2010)…

    • 1008 Words
    • 5 Pages
    Good Essays
  • Good Essays

    Do you like to work with automobiles and modify them? Then becoming an automotive engineer is the perfect occupation for you. One example is if your car breaks down, you can fix it. This career is for me because I like to build and work on mechanical things. I am also interested in this career because I like to draw cars and draw designs for new ones. I believe that going to college plays a very important role in becoming a successful automotive engineer.…

    • 472 Words
    • 2 Pages
    Good Essays
  • Best Essays

    INDEX Sr. Particular Page No. No. 1 General Information 2 2 Production Department 12 3 Personal Department 21 4 Marketing Department 32 5 Finance Department 41 6 Future Plan 47 7 Conclusion 48 8 Suggestion 49 9.…

    • 2828 Words
    • 12 Pages
    Best Essays

Related Topics