Transmission Dissection

ME112 Transmission Dissection Procedure

[pic][pic][pic][pic]
Remove the bolts from the top Here’s what you will see. Locate Using the punch, pound out the (Optional): Pound out the pin and cover of the transmission (they are the selector pin and its collar. cotter pin in the collar. If it falls remove the bar that prevents more only hand tightened). in the transmission, don’t worry. than one shift fork being selected.

[pic][pic][pic][pic]
Unscrew the shift lever (if attached) If the shaft seems stuck, remove Now remove the two shift forks. Unbolt the rear housing. and pull the shaft out the rear side the hex bolt and pull out the small of the transmission. spring and bullet used as a detent.

ME112 Transmission Dissection Procedure

[pic][pic][pic][pic]
Rotate the housing to expose shaft. Carefully pound out the shaft. Rotate the transmission upright Remove the cover to the input again and remove output shaft. shaft.

[pic][pic][pic][pic]
Remove the input shaft (you may Now remove the countershaft. The countershaft originally had Your complete disassembly. need to wiggle it as you pull it out). needle bearings and a thrust washer (these have been removed).

To reassemble, put the countershaft back in the transmission, reattach the input and output shafts and then replace the shaft on which the countershaft spins. If the input and output shaft are in place and you turn the transmission upside down, the countershaft should fall into place and the shaft should go in