Preview

SUBDIVISION VEHICLE ENTRY PASS USING RFID

Powerful Essays
Open Document
Open Document
3793 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
SUBDIVISION VEHICLE ENTRY PASS USING RFID
SUBDIVISION VEHICLE ENTRY PASS USING RFID

A Capstone Project Presented to
The Faculty of the College of Engineering and Computing Sciences
Batangas State University-JPLPC Campus
Malvar, Batangas

IN PARTIAL FULFILLMENT OF THE REQUIREMENTS FOR THE DEGREE OF BACHELOR OF INFORMATION TECHNOLOGY

APPROVAL SHEET In partial fulfillment of the requirement for Systems Analysis and Design. This thesis entitled “Subdivision Vehicle Entry Pass using RFID for the Department of Engineering and Computing Sciences ( CECS ) in Batangas State University JPLPC “ , has been prepared and submitted by Arnie Jane Ariza, Mea Joan Valiente and Ericson Vila. Accepted as partial fulfillment of the requirement for the degree of Bachelor of Science in Information Technology.

i
ACKNOWLEDGEMENT
The researchers would like to extend their deepest appreciation to God, for the encourage and strenght that serve as our inspiration in writing and accomplishingthe reasearch. To our beloved parents who always give us moral and financial support. To our classmates, friends and teachers who help and guide us to arrive at a successful project.
The Developers, AMA MFV EMV

ii

DEDICATION
The researchers would like to dedicate this Capstone Study:
First, to Almighty God who give us the strength of mind and knowledge.
To our parents, sisters and brothers who give us moral and financial support through and through, so that, this capstone study became possible.
To our friends and classmates who helped us.
And lastly, to our beloved teachers at Batangas State University who teach us, with arms wide open. The Developers, AMA MFV EMV

iii EXECUTIVE SUMMARY

The The Developers created Subdivision’s Vehicle Entry Pass using RFID as the final requirement of the subject, Systems Analysis and

You May Also Find These Documents Helpful

  • Good Essays

    Quad is a company which leases and services the plastic containers which are used from industries to grocers to transport the products. They are facing some difficulties with them supply chain and following processes for each container. SAVI proposes some new technologies to facilitate this tracking and the inventory management. So in my opinion, if I were SAVI, I would like to position the tracking technology to companies like Quad as a value-adding. The SAVI’s technologies will come for the other companies more like an advantage to improve their efficiency. Such technologies offer the possibilities to manage better the visibility of physical goods, to increase the supply chain efficiency and to facilitate the inventory’s management. The RFID technology adds value not only to the product but also to the QUAD Company. By using such service, they will increase the productivity and improve their products but also reduce the spendof-time. It is really a value—adding service. SAVI offers different kind of RFID tags: active or passive. The active tags are an evolution of the passive tags. They have the ability to transmit their location and other information like the time spending at the same place. Moreover they can be monitored by readers not far from them. So with all these capacities, it could be a great choice for QUAD to invest on this evolution. It will provide them more flexibility, give them the capacity to better organize them inventory and to improve the inventory…

    • 459 Words
    • 2 Pages
    Good Essays
  • Good Essays

    Cited: Atlas RFID Solutions website. (n.d.). Retrieved July 7, 2011, from Altas RFID Solutions: http://www.atlasrfidsolutions.com/Technology/RFIDvsBarcode.aspx…

    • 1119 Words
    • 5 Pages
    Good Essays
  • Better Essays

    Rfid Tags

    • 1620 Words
    • 7 Pages

    Over time, the ways products have been tracked through the supply chain have changed just as technology is constantly progressing. Yet, there are still constraints to improve the methods of tracking and shipping due to the lack of technology in these fields. Bar codes have helped but still need human interference. Many companies are starting to turn to radio frequency identification tags. RFID tags can help companies with tracking and shipment of any product and reduce time to improve customer satisfaction. (Wolff, 2001) Companies such as IBM who are producing the tags have started to think of ideas to revolutionize this plan. The RFID tags can help track products as they enter and leave warehouses, and can speed up the shipping process. They can be put into different products and even use them in such ways as at the grocery store instead of having cashiers and cash registers. (Wolff, 2001) The superstore, JC Penney, is interested in taking advancements with the RFID tags. These tags are programmable and cannot get damaged like barcodes can. In the 21st century, we are constantly moving forward with such innovations. The RFID tags are currently in use by some companies already, and being modified by others for their particular needs. These tags could open doors for many new inventions and help us progress into a faster-moving and progressing world.…

    • 1620 Words
    • 7 Pages
    Better Essays
  • Powerful Essays

    Below you will find the evaluation of the feasibility of implementing a RFID property management solution to improve inventory management, property visibility and property accountability.…

    • 5097 Words
    • 21 Pages
    Powerful Essays
  • Powerful Essays

    Implementation of RFID tags at the case levelreduces the need for forklift readers to count cases on the pallet during receiving at both the Metro DC as well as the Extra Store, as the case tags…

    • 1998 Words
    • 8 Pages
    Powerful Essays
  • Powerful Essays

    Lastly we would like to mention our gratitude to everyone else as well who all helped us in this educational endeavor.…

    • 3695 Words
    • 15 Pages
    Powerful Essays
  • Good Essays

    RFID Summary

    • 546 Words
    • 3 Pages

    applications of the RFID and where it comes from and where it’s heading. It tells us…

    • 546 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Trackschoolbus Case Study

    • 1284 Words
    • 6 Pages

    1. Provide real-time data regarding the school bus location by using RFID and GPS technology…

    • 1284 Words
    • 6 Pages
    Good Essays
  • Good Essays

    However, individual monitoring of resources is possible by combining the RFID technology with GPS. Passive RFID tags consume less power and can prolong tracking time. Devices which combine Smartphone technology with satellite or GPS system are also available. In short, construction supervisors and site managers can easily track all the goods which are loaded onto a vehicle or entrusted to a driver.…

    • 779 Words
    • 4 Pages
    Good Essays
  • Best Essays

    Electronic Toll Collection

    • 2555 Words
    • 11 Pages

    Tolling on roads and highways today is done mostly on a manual basis i.e. vehicles stop at a check gate and the toll is collected manually by authorized personnel. This poses a lot of problems such as traffic congestion, inefficient use of human resources, vast amount fuel and time wastage apart from, of course seeming very primitive in today’s world of automation. There are already methods in practice that attempt to automate the whole process. Systems that use installed video cameras that scan the license plates of the vehicles to identify the vehicles and initiate the tolling process are a viable solution but with their own problems in execution – the most important being the logistical diversity in the nature of vehicles which makes a universal protocol impossible. In this context, RFID puts forward a very efficient solution to the automation problem in the case of electronic toll collection. This document discusses the use of RFID in Electronic Toll Collection. It discusses the requirements of such an application and how RFID systems should be customized to meet these needs. It describes a circuit for the transceiver at frequency 2.45 GHz and its interfacing with a computer. A brief note about the specifications of the antenna used and an introduction to the transponder design are made.…

    • 2555 Words
    • 11 Pages
    Best Essays
  • Good Essays

    In this project three units are important they are RFID Card, RFID Reader and Writer. Tags are programmable and they may be read or read/write i.e. the information stored in the tag’s memory cannot be changed or can be updated as required. The reader powers the antenna to generate radio frequency waves to transmit a signal that activates the tag and allows data to come into or leave the tag’s memory. This card can be designed to hold all amount details including Name of the family head, ID number, resident address and amount has been recharged.…

    • 9042 Words
    • 37 Pages
    Good Essays
  • Good Essays

    Receipt System

    • 2156 Words
    • 9 Pages

    * 11. rfid security using mini des algorithm in deployment of bike renting system323 viewsLike…

    • 2156 Words
    • 9 Pages
    Good Essays
  • Satisfactory Essays

    room do not relate with the power switches, they are controlled only with the data…

    • 266 Words
    • 2 Pages
    Satisfactory Essays
  • Powerful Essays

    Narrative Report

    • 4726 Words
    • 19 Pages

    To my loving parents who provided moral and financial support to make this study possible and finally, to GOD ALMIGHTY for giving us strength, knowledge to be able to conduct this…

    • 4726 Words
    • 19 Pages
    Powerful Essays
  • Good Essays

    The RFID technology does not consist only one separate device, that operates standalone, but it is a whole system that enables its application in practice. This system contains several elements and probably this is one of the reasons behind the difficulties the technology has faced, especially in the past, struggling for acceptance by the industry. All this elements have different stage of development and standardization, and that makes the harmonization of all components of a system always laborious. The general elements as explained by Miles and Williams in “RFID Technology and Applications” are the tags, the readers, controller, the network system and the software system (MILES & WILLIAMS, 2008, pp. 10-27). The whole environment is depicted…

    • 921 Words
    • 4 Pages
    Good Essays

Related Topics