module 7 essays
1. Where would you disconnect a chain?
# a) At a bolted joint. b) At a spring clip joint. c) At an riveted joint.
2. How many strokes per minute should be used with a hacksaw?
# a) 30 b) 55 c) 60
3. Unused holes in an electrical multi-pin connector should be a) fitted with pins
# b) fitted with blanks c) left open
4. How many times can a locking plate be used? a) once, then discarded
# b) indefinitely providing it is a good fit around the component to be locked c) 3 times, then discarded
5. In a front release connector the pin will be
# a) released from the front and extracted from the rear b) released from rear and extracted from the front c) released from the front and extracted from the front
6. What cable would you use where temperatures are going to exceed 200 degrees C? a) Aluminium b) Silver plated
# c) Nickel plated
7. Brinelling of a wheel bearing could be caused by
# a) heavy landing b) rotation of the outer race in the wheel housing c) overheating of the brakes
8. A hi-lock collar should be a) lubricated before fitting b) washed in solvent before fitting
# c) not lubed or washed because they are lubed at manufacture
9. A CAA issued capability list gives a) details of the scope and extent of a type rated engineer's license
# b) details of the scope and extent to which an organization's approval is granted
c) details of the operational restrictions in terms of manoeuvres (g. forces) placed on a transport category aircraft at the time of issue of a C of A.
10. Mandatory Warning Plagues and symbols
# a) must be displayed on all flights b) must be displayed in the cabin only if they are legible c) need not be displayed if they are incorporated in the flight manual
11. A chain removed for
# a) At a bolted joint. b) At a spring clip joint. c) At an riveted joint.
2. How many strokes per minute should be used with a hacksaw?
# a) 30 b) 55 c) 60
3. Unused holes in an electrical multi-pin connector should be a) fitted with pins
# b) fitted with blanks c) left open
4. How many times can a locking plate be used? a) once, then discarded
# b) indefinitely providing it is a good fit around the component to be locked c) 3 times, then discarded
5. In a front release connector the pin will be
# a) released from the front and extracted from the rear b) released from rear and extracted from the front c) released from the front and extracted from the front
6. What cable would you use where temperatures are going to exceed 200 degrees C? a) Aluminium b) Silver plated
# c) Nickel plated
7. Brinelling of a wheel bearing could be caused by
# a) heavy landing b) rotation of the outer race in the wheel housing c) overheating of the brakes
8. A hi-lock collar should be a) lubricated before fitting b) washed in solvent before fitting
# c) not lubed or washed because they are lubed at manufacture
9. A CAA issued capability list gives a) details of the scope and extent of a type rated engineer's license
# b) details of the scope and extent to which an organization's approval is granted
c) details of the operational restrictions in terms of manoeuvres (g. forces) placed on a transport category aircraft at the time of issue of a C of A.
10. Mandatory Warning Plagues and symbols
# a) must be displayed on all flights b) must be displayed in the cabin only if they are legible c) need not be displayed if they are incorporated in the flight manual
11. A chain removed for