Preview

Interpretation of Reaction by Le Chatelier's Principle

Satisfactory Essays
Open Document
Open Document
587 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Interpretation of Reaction by Le Chatelier's Principle
Experiment 11

Date: 28-3-2011

Title: Interpretation of reaction by the Le Chatelier’s principle

Objective: To determine the factors that affecting the equilibrium position

Introduction:
Le Chatelier’s principle states that if a system in equilibrium is subjected to a change, the equilibrium position of the system will shift in a direction to minimize the effect of the change.

Iron(III) ions and thiocyanate ions (NCS-) react in solution to produce thiocyanatoiron(III) (FeNCS2+), a complex ion, according to the equation:

Fe3+(aq) + NCS-(aq) à FeNCS2+(aq)
Yellow colourless blood red

The colour produced by the complex ion indicates the position of equilibrium.
In this experiment, iron(III) chloride solution, potassium thiocyanate solution and solid ammonium chloride were added to the mixture solution to find out the factors the affecting the equilibrium position.

Procedure:
Two drops of iron(III) chloride solution and potassium thiocyanate solution were mixed together in a test-tube and then 5cm³ of deionized water was added to form a pale orange-brown solution. After that, the solution was divided into four equal partsin four aliquots in four test-tubes. A drop of iron(III) chloride solution and potassium thiocyanate solution were added to the first test-tube and the second test-tube respectively. A spatula-measure of solid ammonium chloride was then added to the third test-tube and was stirred well. The colour of the solution was compared with the untouched tube.

Result:



Data Analysis:
Fe3+(aq) + NCS-(aq) à FeNCS2+(aq)
Yellow colourless blood red
The untouched tube was a pale orange-brown colur, which was representative of an equilibrium between both sides.

The colour of the solution in the test-tube which a drop of iron(III) chloride solution was added was darker than the untouched tube. When the concentration of Fe3+ ion s was increased, according to Le Chatelier’s principle, the equilibrium

You May Also Find These Documents Helpful

  • Satisfactory Essays

    Restoring Balance Lab

    • 415 Words
    • 2 Pages

    2. Co(H2O)62+ ion was favored by the addition of water as it is pink colored and when we added water to the cobalt chloride solution, it became pink. This was because the amount of Co(H2O)62+ ions went up(more pink) to compensate or even out the change. Adding more products resulted in the position of the equilibrium to shift towards the reactant side making it favor the Co(H2O)62+ ions.…

    • 415 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    Equilibrium Reaction

    • 615 Words
    • 3 Pages

    In this experiment, equilibrium will be examines in the reaction beteween the iron (III) ion and the thiocyanate ion:…

    • 615 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    Add 1/2 drop of 0.1 M potassium ferricyanide solution to tube 2. A deep blue precipitate will form with the iron (III) sulfate. In this reaction, the ferricyanide ions oxidize iron (II) to iron (III), forming ferrocyanide…

    • 351 Words
    • 2 Pages
    Satisfactory Essays
  • Satisfactory Essays

    1. Give the balanced net ionic equation for the reaction between Fe2+ and Ag+. What is the chemical formula of the gray precipitate?…

    • 1220 Words
    • 5 Pages
    Satisfactory Essays
  • Good Essays

    post lab of cucl2

    • 732 Words
    • 3 Pages

    II. Purpose: The purpose of this lab is to see how iron reacts with a copper (II) chloride solution.…

    • 732 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    Chemistry 116 lab review

    • 289 Words
    • 2 Pages

    The first step is to calibrate the colorimeter with0.20 M Fe(NO3)3and set the absorbance at 470 nm since it is known to keep an acidic solution throughout the entirety of the experiment. It was important to do this right at the beginning of the lab since the zeroed value of the acid was the calibration number for all of the other solutions. A total of seven solutions with different dilutions were used throughout the lab to conduct the equilibrium constant. The first step was adding 5 mL of 0.200 M Fe(NO3)3to each of the 5 test tubes. Once this was done, 0.00200 M NCS was added to the test tubes, each receiving a different amount; test tube one received 1 mL NCS-and with each test tube the amount of NCS-would increase by 1 mL, test tube 5 received 5 mL of NCS. . The next step was adding HNO3 to each test tube in different volumes; Test tube one received 10 mL of HNO3 and with each test tube the amount of HNO3 decreased by 1 mL, test tube five had no HNO3 added to it. The addition of these solutions formed five test tubes of different dilutions, but of equal volume, 10 mL each. After all of the previous trials had been completed the final step was to take each test tube and pour it into a different cuvette and measure the absorbance for each. Once the initial concentration was calculated of Fe3+, NCS and FeNCS2+ in molarity. The absorbency values were recorded and used to calculate the formation constant, K f The reference table containing volumes used in each solution is provided below…

    • 289 Words
    • 2 Pages
    Satisfactory Essays
  • Satisfactory Essays

    4 Carefully pour the iron(iii) nitrate solution into the sodium thiosulfate solution and start the timer.…

    • 735 Words
    • 4 Pages
    Satisfactory Essays
  • Satisfactory Essays

    4.5 hw chwm

    • 458 Words
    • 2 Pages

    Fill a small test tube halfway with copper (II) sulfate solution. Add a 2.0 gram iron rod to the solution and observe the reaction.…

    • 458 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    An ionic Iron solution with a known concentration of 4.047x10-3 M was obtained. A 250-mL sample of a 10-fold dilution of this ionic iron solution and 5 drops of concentrated HNO3 was made. This solution served as the source of ionic Iron for the remainder of the lab and was labeled “stock ionic Iron solution.” Next, a 50-mL aqueous ionic Iron and FerroZine® complex solution was prepared by adding 5.00mL stock ionic Iron, 3-mL of acetic acid buffer, 2-mL of 5% hydroxylamine hydrochloride, allowing five minutes for hydroxylamine to reduce Fe3+ to Fe2+, adding 2.5-mL of 0.01 M FerroZine® solution, and mixing well. A single beam Agilent technologies CARY60-UV-Vis Spectrophotometer was then employed to determine the optimum wavelength in the visible spectrum of the ionic Iron and FerroZine® complex.…

    • 458 Words
    • 2 Pages
    Good Essays
  • Good Essays

    To better understand the effect of temperature on equilibrium, one must look at heat as a product or reactant.2 Chatelier expresses that if a reaction mixture is heated an endothermic reaction is more favored, while if the mixture is cooled then an exothermic reaction is favored. Based on that, the principle predicts the equilibrium position will move depending on if the reaction will consume more head or produce more…

    • 634 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Iron and Cupric Sulfate

    • 851 Words
    • 3 Pages

    Iron powder will react with cupric sulfate in a one­to­one ratio (1 mole to 1 mole). The…

    • 851 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    white powder analysis

    • 602 Words
    • 2 Pages

    The cation(s) present in the unknown sample are silver and iron. I know this because the precipitates and the colors of the elements precipitates matched therefore making the unknowns identifiable.…

    • 602 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    Chem Lab 19A

    • 531 Words
    • 3 Pages

    2) When you add 6.0M NaOH into the iron (III) thiocyanate ion equilibrium system, the concentration of Fe3+ ion decreases. This causes the equilibrium system to shift to the left (reactant) side. This is why the solution becomes lighter yellow. Fe(OH)3 is also formed during the experiment.…

    • 531 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    3. When salicylic acid is added to a neutral solution such as iron chloride it turns intense pink colour. ( presence of a phenol- OH attached to a benzene ring )…

    • 439 Words
    • 2 Pages
    Satisfactory Essays
  • Better Essays

    Anions Lab

    • 1345 Words
    • 6 Pages

    Purpose: The purpose of this lab is to identify the presence of cations and anions in four unknown solutions by identifying whether they are copper, silver, iron, or chloride ions which is done by adding sodium hydroxide, solid copper, silver nitrate, and potassium thiocyanate to the solutions and analyzing the chemical reactions.…

    • 1345 Words
    • 6 Pages
    Better Essays

Related Topics