Ieee 450-2002
IEEE Standards
IEEE Std 450™-2002
(Revision of IEEE Std 450-1995)
450
TM
IEEE Recommended Practice for
Maintenance, Testing, and Replacement of Vented Lead-Acid Batteries for
Stationary Applications
IEEE Power Engineering Society
Sponsored by the
PES Stationary Battery Committee
Published by
The Institute of Electrical and Electronics Engineers, Inc.
3 Park Avenue, New York, NY 10016-5997, USA
3 April 2003
Print: SH95063
PDF: SS95063
IEEE Std 450™-2002
(Revision of IEEE Std 450-1995)
IEEE Recommended Practice for
Maintenance, Testing, and Replacement of Vented Lead-Acid Batteries for
Stationary Applications
Sponsor
PES Stationary Battery Committee of the
IEEE Power Engineering Society
Approved 9 December 2002
IEEE-SA Standards Board
Abstract: Maintenance, test schedules, and testing procedures that can be used to optimize the life and performance of permanently installed, vented lead-acid storage batteries used for standby power applications are provided. This recommended practice also provides guidance to determine when batteries should be replaced. This recommended practice is applicable to full-float stationary applications where a charger maintains the battery fully charged and supplies the dc loads.
Keywords: acceptance test, battery capacity, battery installation, battery maintenance, battery replacement criteria, battery service test, battery terminal voltage, connection resistance measurements, electrolyte level, equalize charge, float voltage, modified performance test, performance test, service test, specific gravity, standby power applications, state of charge, test-discharge rate, vented lead-acid battery
The Institute of Electrical and Electronics Engineers, Inc.
3 Park Avenue, New York, NY 10016-5997, USA
Copyright © 2003 by the Institute of Electrical and Electronics Engineers, Inc.
All rights reserved. Published 3 April 2003. Printed in the United States of America
.
IEEE is a
IEEE Std 450™-2002
(Revision of IEEE Std 450-1995)
450
TM
IEEE Recommended Practice for
Maintenance, Testing, and Replacement of Vented Lead-Acid Batteries for
Stationary Applications
IEEE Power Engineering Society
Sponsored by the
PES Stationary Battery Committee
Published by
The Institute of Electrical and Electronics Engineers, Inc.
3 Park Avenue, New York, NY 10016-5997, USA
3 April 2003
Print: SH95063
PDF: SS95063
IEEE Std 450™-2002
(Revision of IEEE Std 450-1995)
IEEE Recommended Practice for
Maintenance, Testing, and Replacement of Vented Lead-Acid Batteries for
Stationary Applications
Sponsor
PES Stationary Battery Committee of the
IEEE Power Engineering Society
Approved 9 December 2002
IEEE-SA Standards Board
Abstract: Maintenance, test schedules, and testing procedures that can be used to optimize the life and performance of permanently installed, vented lead-acid storage batteries used for standby power applications are provided. This recommended practice also provides guidance to determine when batteries should be replaced. This recommended practice is applicable to full-float stationary applications where a charger maintains the battery fully charged and supplies the dc loads.
Keywords: acceptance test, battery capacity, battery installation, battery maintenance, battery replacement criteria, battery service test, battery terminal voltage, connection resistance measurements, electrolyte level, equalize charge, float voltage, modified performance test, performance test, service test, specific gravity, standby power applications, state of charge, test-discharge rate, vented lead-acid battery
The Institute of Electrical and Electronics Engineers, Inc.
3 Park Avenue, New York, NY 10016-5997, USA
Copyright © 2003 by the Institute of Electrical and Electronics Engineers, Inc.
All rights reserved. Published 3 April 2003. Printed in the United States of America
.
IEEE is a