Preview

Cool Blue Gatorade Concentration Lab Report

Satisfactory Essays
Open Document
Open Document
133 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Cool Blue Gatorade Concentration Lab Report
Claim: The concentration for Cool Blue Gatorade is 1.19E-06, and the Glacier Frost’s concentration is 2.78E-07.

Error: In our experiment, there was a source of error because in the Concentration vs. Absorbance graph’s line of best fit, there was a y-intercept, but there isn’t suppose to be one since the concentration is 0, the absorbance should be 0. There are no particles in the solution, distilled water, so nothing should be absorbed. This error could have been caused by the leaving the diluted solution out too long, so the water in the solution could have evaporated, leaving only the blue dye. It is not a diluted solution if there is just dye left in the beaker because it would go be a higher concentration than the actual solution’s concentration

You May Also Find These Documents Helpful

  • Good Essays

    Nahco3 Hydrochloric Acid

    • 1247 Words
    • 5 Pages

    From my results I can see that the accurate result was 0.98 and our estimated was 0.1M but I rounded up my answer to 1 decimal places to see so there was not that much of a difference. Overall my experiment went well because I have followed instruction and I archived my hypothesis because I calculate that the chemical will have more concentration because it is a hydrochloric acid which will react with a methyl orange indicator solution and cause colour change from yellow to pink in my experiment I could clearly see the change of the colour. Form my results table I can see that my results were close to 0.1M which means that I have used the accurate amount of standard solution in my experiment If I was to improve my experiment I could attempt to read the burette to the bottom or top of the meniscus by doing this it might give me accurate results for my experiment. Another way of improving my experiment could be that I use volumetric pipettes for measuring.…

    • 1247 Words
    • 5 Pages
    Good Essays
  • Satisfactory Essays

    Chemistry 116 lab review

    • 289 Words
    • 2 Pages

    The first step is to calibrate the colorimeter with0.20 M Fe(NO3)3and set the absorbance at 470 nm since it is known to keep an acidic solution throughout the entirety of the experiment. It was important to do this right at the beginning of the lab since the zeroed value of the acid was the calibration number for all of the other solutions. A total of seven solutions with different dilutions were used throughout the lab to conduct the equilibrium constant. The first step was adding 5 mL of 0.200 M Fe(NO3)3to each of the 5 test tubes. Once this was done, 0.00200 M NCS was added to the test tubes, each receiving a different amount; test tube one received 1 mL NCS-and with each test tube the amount of NCS-would increase by 1 mL, test tube 5 received 5 mL of NCS. . The next step was adding HNO3 to each test tube in different volumes; Test tube one received 10 mL of HNO3 and with each test tube the amount of HNO3 decreased by 1 mL, test tube five had no HNO3 added to it. The addition of these solutions formed five test tubes of different dilutions, but of equal volume, 10 mL each. After all of the previous trials had been completed the final step was to take each test tube and pour it into a different cuvette and measure the absorbance for each. Once the initial concentration was calculated of Fe3+, NCS and FeNCS2+ in molarity. The absorbency values were recorded and used to calculate the formation constant, K f The reference table containing volumes used in each solution is provided below…

    • 289 Words
    • 2 Pages
    Satisfactory Essays
  • Satisfactory Essays

    Blue Hydrate Lab Report

    • 153 Words
    • 1 Page

    Conclusion: The purpose of this lab was to visually see the chemical change that was taking place when hydrates gain and lose water.The formula for blue hydrate is anhydrous copper (ii) sulfate (CuSO4). The percent error for the mass of water is -94.40%. The effect of the hydrate not being heated long enough would result in water still being in the hydrate. If the test tube was not dried completely prior to the initial measurement it would cause the data to follow that incorrect measurement to be false and it would also add more water into the hydrate than what was initially projected. If the anhydride was allowed to sit over before the final mass measurement was taken it would result in more water loss from the hydrate. The moles of CuSO4…

    • 153 Words
    • 1 Page
    Satisfactory Essays
  • Good Essays

    This experiment consisted of two parts. First, the absorption of each dye was evaluated by diluting (1 mg/mL standard) 2.0 mL of dye to 100 mL. The absorbance of each dye standard was measured and documented. The absorbance of the Gatorade was then measured by diluting the solution and pipetting 5.0 mL into a 25.0 mL volumetric flask. The absorption spectrum of the chosen drink was measured. Next, the purple Gatorade extraction procedure was carried out, beginning with pipetting 1 mL of 70% isopropanol (IPA) and 1 mL of saturated salt water into test tube 1 (solution 1).…

    • 749 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Tube 2 Lab Report

    • 603 Words
    • 3 Pages

    As indicated by the figure, the high concentration correlated to having the highest amount of absorbance (1.006 at 300 seconds). This was followed by the medium-high concentration (0.555) and medium concentration (0.540). It can be noted that the medium concentration started off with a higher absorbance than the medium-high concentration, but the medium-high concentration had a faster increase of absorbance over time. Thus, surpassing the absorbance of the medium concentration from 270 and 300 seconds. The low concentration had the lowest amount of absorbance, with a final absorbance rate of 0.204, and did not substantially increase over the period of…

    • 603 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Light Blue Lab Report

    • 2120 Words
    • 9 Pages

    The group first designed the materials to create and hold the .75 agarose gel and experiment. Everything except the comb was made of ¼ inch Acrylic Plexiglass. The glass helped the group see what was going on in the experiment. The comb was 3D printed to be more accurate. One material was a casting tray which held the Gel in future steps. The casting tray had to hold at least 50 mL of liquid. They didn’t want the casting tray to hold much more than 50mL or else they’d be wasting materials. The group sealed two sides of the casting tray to the base with Bostik All Weather Sealant. The…

    • 2120 Words
    • 9 Pages
    Good Essays
  • Powerful Essays

    Red 40 Lab

    • 2090 Words
    • 9 Pages

    Determining Red 40 Concentrations Using Absorption with Beer’s Law Introduction I like color and enjoyed learning about wavelengths and the spectrum of light, so I considered incorporating something related to that into my Internal Assessment. We also had just used concentrations in our Group 4 Project, so when I found an experiment that dealt with both of these I thought it was a great idea. This experiment is not completely original; the basic concept has been used multiple times. It uses Beer’s Law: · A is light absorbance · is “molar absorptivity with units of L mol-1 cm-1” · l is the length of the cuvette in centimeters · c is the concentration of the solution in mol L-1…

    • 2090 Words
    • 9 Pages
    Powerful Essays
  • Good Essays

    Food Dyes Lab

    • 671 Words
    • 3 Pages

    The initial step to determine the concentration of the dyes previously found was to prepare a set of serial dilutions at 20%/40%/60%/80%/100% dye concentration. To prepare the 20% dilution 1mL of red 40/blue 1 was combined with 4mL of DI water. This method was used to produce the remaining dilutions with 2mL/3mL, 3mL/2mL, 4mL/1mL, and 5mL/0mL (mL dye / mL DI water). Each of the previous dilutions was tested in the spectrometer and data was recorded. Using the data obtained two Beer Law plots were plotted for both dyes and trendlines were added. The slope of the trendline was found and used to calculate the actual (mol/L) and percent concentrations…

    • 671 Words
    • 3 Pages
    Good Essays
  • Good Essays

    There were six sucrose solutions: 0.0 M (distilled water), 0.2 M, 0.4 M, 0.6 M, 0.8 M, and 1.0 M. The dependent variable was the mass of the cores of apple tissue. Changes in the dependent variable were measured by weighing the mass of each set of apple cores before and after its submerging in sucrose solution. The initial mass was then subtracted from the final mass and divided by the initial mass to calculate the percent change of each set. Changes in the dependent variable were analyzed in the form of percent change of mass rather than change in mass in grams because each set of apple cylinders had a different initial weight, so calculating percent change helped standardize the data. The control of the experiment was the distilled water because it has a molarity of 0.0 M, meaning that no sucrose is added to it. Several variables were held constant. It was attempted to keep the size of each core of apple tissue constant. Other constants include the ruler and scale used to measure the apple cores, as well as the knife used to cut the…

    • 1050 Words
    • 5 Pages
    Good Essays
  • Satisfactory Essays

    The purpose of this lab is to find the amount of blue dye #1 in the blueberry pomegranate gatorade.…

    • 796 Words
    • 4 Pages
    Satisfactory Essays
  • Satisfactory Essays

    Antifreeze Lab

    • 400 Words
    • 2 Pages

    The purpose of this experiment is to determine the freezing points of water, 10% antifreeze, and 20% antifreeze utilizing an ice bath and a really cool thermometer.…

    • 400 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    In this lab using the bag of FD&C dyes, bag of M&M’s, 2 packs of Kool-Aid , and a pack of Clover Valley store brand food coloring I am going to place a drop of each dye at the bottom of the chromatography paper. For the experiment with the rubbing alcohol I also placed a drop of each dye, but used a paper coffee filter. In order to get the dye color extracted from the M&M’s and Kool-Aid I added a little additional water.…

    • 599 Words
    • 3 Pages
    Good Essays
  • Powerful Essays

    Gatorade is the manufacturer of sports-themed beverages and food products, built mainly around its signature line of sports drinks. Gatorade is currently manufactured in over 80 countries. Does anybody know how Gatorade’s name originated? Gatorade was first developed in 1965 by a team of researchers at the University of Florida, to replenish the combination of water, carbohydrates, and electrolytes that the school's student-athletes lost in sweat during rigorous sport activities. Within the United States, Gatorade accounts for approximately 75 percent market share in the sports drink category. I will be analysing the changes over time in Gatorade’s TV advertising. I will also note similarities and common trends seen over 40 years of Gatorade…

    • 1255 Words
    • 6 Pages
    Powerful Essays
  • Powerful Essays

    In the summer of 1965, a university football coach began to question why his players were suffering from heat related illnesses. They were drinking plenty of water. University researchers soon discovered that players were losing electrolytes and fluids through their sweat, and water couldn’t replace what they were losing. The researchers took their findings into their lab and began to create a drink that would help the Florida Gators feel rehydrated, replenished, and refueled during their most intense athletic events. That’s exactly what the product now guarantees to achieve-rehydration, replenishment, and refueling. They called this new drink ‘Gatorade’. By 1969, Gatorade was named the official drink of the NFL (History…

    • 4101 Words
    • 17 Pages
    Powerful Essays
  • Good Essays

    What Makes Gatorade Work

    • 538 Words
    • 3 Pages

    Millions of people drink sports drinks like Gatorade everyday, But very few people actually know what ingredients make up their favorite sports drink. Gatorade was thought up in 1965 by an assistant coach of the Florida Gators at the University of Florida and his team of physicians who wanted to create something to help his players deal with the heat of the Florida sun. They created a concoction they deemed “Gatorade”, named after the team of course. The beverage set out to replenish not only the fluids they lost on the field but the carbohydrates and electrolytes. After they instituted this drink the team began out doing their opponents in the heat and ended the season 7-3, But the question here is not “Does gatorade work?”…

    • 538 Words
    • 3 Pages
    Good Essays