Preview

Chemiluminescence Lab

Satisfactory Essays
Open Document
Open Document
443 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Chemiluminescence Lab
German Mejia
Period :6
Due Date: 10-6-17
Group:8
Honors Chemistry
Topic: Temperature fluctuations to chemiluminescence

The scientist’s project topic revolves around changing the environment in which chemiluminescence occurs in. Can the Fluctuation in temperature of the chemiluminescence environment affect the chemical reaction? The scientist’s independent variable is the temperature of water in degrees fahrenheit ,and their dependent variable is which glow stick wears down the fastest in hours ,some of
…show more content…
The Scientist still feels like the heat fluctuation will still have a greater effect on the duration of the chemiluminescence reaction because it will not slow it down to a point where it might just stop it. One of the most important key terms in the scientist project is chemiluminescence which means ,” a very efficient process that converts energy to light” (Keren Perles 2012). This project is very dangerous because “23% of all cases of exposure to chemiluminescent products reported to an urban poison control center” ( Robert L. Hoffman 2002). It can be a very dangerous project if the scientist doesn't know what he is doing. Glow sticks have also been a great project inducer in the marine field. Glow sticks have been a very effective bait “Glow sticks have been mentioned briefly in the literature as a means to increase capture rates of aquatic amphibians” (Kristine L. Grayson 1996). In this process of chemiluminescence what happens “in Chemiluminescent Systems wherein a hydrogen peroxide component and an oxalate ester-fluorescer component are mixed and reacted to produce light” (Victor B World

You May Also Find These Documents Helpful

  • Powerful Essays

    In reference to the collision theory, molecules act as small spheres that collide and bounce off each other, transferring energy among themselves when the collide. In order for a reaction to occur, there must be collisions between molecules. Through experimentation, factors are discovered that influence the reaction rates of chemical reactions include the concentration of reactants, temperature, surface area, the physical state of reactants, and a catalyst. This experiment regarding the factors that affect reaction rate tests the effects of increased concentration and temperature of the hydrochloric acid solution (HCl) and also the effect of increased surface area of magnesium metal (Mg). When glow sticks are immersed in a hot water bath, it is proven that they glow with greater intensity. This proves that an increased temperature has an effect on the reaction itself, allowing molecules that make up the liquid inside the glow stick to move with greater speed, resulting in more collisions. The balanced equation for this reaction would be: Mg (s) + 2 HCl (aq) = MgCl2 (aq) + H2 (g)…

    • 2334 Words
    • 8 Pages
    Powerful Essays
  • Good Essays

    Lab for Chemistry 221

    • 612 Words
    • 3 Pages

    Abstract: A 50mL (we used 100mL) volumetric flask was used to determine the amount of sugar in a can of Coke per mL in 5 different solutions. Using the calibration curve we determine the amount of sugar per mL in a can of coke. This experiment concluded that there is 43.83g of sugar in a 12oz can of Coke.…

    • 612 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Dye Lab for Chem 205

    • 2366 Words
    • 10 Pages

    During the process leading to fluorescence, a certain change could occur during the excitation of the electron, changing the spin of the electron as it gets excited. This change has to be undone as the electron goes back to its standard state. The emitting of light in this process is known as phosphorescence. The process of fluorescence is much faster than phosphorescence. This is due to the fact that in phosphorescence, the electron has to undergo an extra step of undoing its current spin. This process is thermodynamically unfavorable compared to fluorescence. 1, 2…

    • 2366 Words
    • 10 Pages
    Good Essays
  • Good Essays

    Green Light Lab Report

    • 2923 Words
    • 12 Pages

    1. Describe the mechanism by which green fluorescent protein (GFP) is able to emit fluorescent light and why ultraviolet light is required to visualise it. (5 marks) When GFP is hit with UV light, the chromophore is hit by a photon. This changes the chromophore from ground state (A) to A*, which is a highly excitable state. Due to such a highly excitable state not being able to remain so for very long, the A* state chromophore emits a proton, lowering its state to I*, the energetic I.…

    • 2923 Words
    • 12 Pages
    Good Essays
  • Good Essays

    Glow Stick Lab

    • 702 Words
    • 3 Pages

    I think the change in brightness occurred because of the energy levels the temperatures produced. The heated water produced more light because heat results and creates light and energy. As well the heat caused the glow stick particles to move more rapidly which was as well due to the increase of energy. However I think the change in brightness in the other beaker was a result of loss of energy. By putting the glow stick into the cold water you are depriving it from heat, energy and light thus a decrease in the particle movements of the glow stick which results into dimness. When particles move slower this is a result of a loss of energy, in this scenario the loss of energy caused the glow stick to dim in…

    • 702 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Chem Lab

    • 721 Words
    • 3 Pages

    Carbon copies of data tables have been attached to the back of this lap report.…

    • 721 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Chem Lab.

    • 520 Words
    • 3 Pages

    3. Determine the mass of the clean dry vial and record your mass to 2 decimal places on your lab sheet.…

    • 520 Words
    • 3 Pages
    Good Essays
  • Powerful Essays

    Chem 103 Project Lab

    • 1372 Words
    • 6 Pages

    The data gathered and calculated in the experiment accurately portrayed the way the reactions would have taken place. The chloride analysis was a little bit off from other groups due to the fact that our AgCl was in clumps, creating less surface area, thus our product took longer to burn and may not have burned correctly compared to other groups; yet there are several experimental factors that could have caused us to have different results than other groups, i.e. different measurements for samples. Our sources of error could have included eye measurement error, timing of set solutions error, measurement errors, and small calculation errors. Among other variables, the calibration of the analytical balance and spectrophotometer could have been off slightly, yet our results, like most other groups, still followed the general trend line generated by the graph using Beer’s Law. The measurement errors could have occurred due to the fact that one partner’s perspective of a measurement could be different than the others, but the lab cannot be preformed solo. When it comes to improving the lab, there aren’t to many ways to ensure accurate measurements due to the fact that in any experiment there are human and environment variables that cannot be accounted for, or even prepared for. In any experiment there will always be human error.…

    • 1372 Words
    • 6 Pages
    Powerful Essays
  • Powerful Essays

    Chem Lab

    • 570 Words
    • 3 Pages

    Purpose: To determine which mole ratio of Zinc and Copper II Sulfate produces the greatest temperature change in degrees celsius.…

    • 570 Words
    • 3 Pages
    Powerful Essays
  • Satisfactory Essays

    Lab Report #1 Che 101

    • 752 Words
    • 4 Pages

    While performing the lab experiments in the first unit, my observation included finding the appropriate tools in the kit in order to carry out the tasks. These experiments really showed me how to differentiate the types of tools we are using and understand the differences and reason for the differences in each. Touch was a big activated sense in these experiments, the heat from boiling the water and the cold ice from the temperature labs allowed for the connection between the results and the way the temperature felt.…

    • 752 Words
    • 4 Pages
    Satisfactory Essays
  • Good Essays

    Enzyme Lab Report

    • 1060 Words
    • 5 Pages

    What did the glow stick show about enzymes and different environments? How does changing the temperature affect the rate of an enzyme-controlled experiment?…

    • 1060 Words
    • 5 Pages
    Good Essays
  • Good Essays

    Flame Test

    • 865 Words
    • 4 Pages

    3. Why do the chemicals have to be heated in the flame before the coloured light is emitted?…

    • 865 Words
    • 4 Pages
    Good Essays
  • Satisfactory Essays

    chemistry lab

    • 3757 Words
    • 34 Pages

    Regents Chemistry Quarter 1 Midterm Review 1. The percent by mass of oxygen in Na2SO4 (formula mass = 142) is closest to 1) 11% 3) 45% 2) 22% 4) 64% 2. Given the unbalanced equation: __Al(s) + __O2(g) → __Al2O3(s) 3. 4.…

    • 3757 Words
    • 34 Pages
    Satisfactory Essays
  • Good Essays

    The purpose of my experiment is to determine which temperature will allow Luminol to glow at its greatest capacity. My hypothesis is that the glow will illuminate for the longest time in a cold temperature because it will take longer to dissolve. I also predict that in the warmer temperature, the glow will be at it’s brightest.…

    • 418 Words
    • 2 Pages
    Good Essays
  • Powerful Essays

    Chem Lab Report

    • 1164 Words
    • 5 Pages

    .2400 grams of the unknown compound. This is done in duplicate and purple-tinted precipitates are placed in Gooch crucibles. The precipitates are suction dried using ethyl alcohol then acetone to…

    • 1164 Words
    • 5 Pages
    Powerful Essays