Preview

Biochemistry

Good Essays
Open Document
Open Document
575 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Biochemistry
Protein Quantitation using the Bradford assay and Spectrophotometry

Protein quantitation is a study which is used to determine protein concentration in an unknown sample by comparing its assay response to one which is already known. This has uses in a broad range of research topics which include protein analysis. Two bovine serum albumin (BSA) dilutions of unknown concentrations using the Bradford assay method of protein quantification were used. BSA is a fatty acid carrier protein in the blood; this is used as it stabilizes enzymes and has advantageous properties such as protection from oxidative damage and stabilization of proteins for analysis. The Bradford assay method is one which is regarded as a relatively quick and simple process, and the results helped to determine its accuracy (Bradford, M. 1976). Important aqueous solutions used throughout the experiment were distilled water, Coomassie brilliant blue G-250 (CBBG) and BSA. The acidic CBBG dye was used to stabilize the binding of this to the BSA, therefore increasing the maximum absorption from 465nm to 595nm (Spector, T. 1978). The spectrophotometer is an absorbance measuring instrument that produces light through two bulbs; the first a visible light and the second one which produces an ultra violet light. Five known substances from 0.2 mg/ml to 1.0 mg/ml, one blank sample and two unknown were used to be tested. In the beginning these solutions were already in 1.5ml microfuge tubes, the amount of stock needed for each was then calculated with the equation C1V1 = C2V2. C1 being the concentration, V1 the value of the starting solutions, C2 the desired concentration of the final stock and V2 the volume of the final stock. Using pipettes, the proportionate amounts mixed with distilled water were used and placed in separate falcon tubes. The concentrations were then mixed with a 5.0 ml of diluted dye reagent, followed by a five minute incubation period. The solutions were each pipetted into cuvettes



References: * Bradford, M.M. “A Rapid and Sensitive Method for the Quantitation of Microgram Quantities of Protein Utilizing the Principle of Dye Binding.” Analytical Biochemistry. 1976, 72, 248–254. * Spector, T. (1978). “Refinement of the Coomassie Blue Method of Protein Quantitation.” Analytical Biochemistry. 1978, 86, 142–146.

You May Also Find These Documents Helpful

  • Powerful Essays

    The purpose of this experiment was to explain how colorimetry can be used to qualitatively detect cellular chemical components; to chemically differentiate between proteins, sugars, starches, and lipids; to identify the roles of molecular components in living systems; to comprehend the value of using a systematic approach to research; and to describe why hypotheses, controls, standards, and quality control are important in scientific research (Vorndam, 2002, p. 92).…

    • 7879 Words
    • 32 Pages
    Powerful Essays
  • Good Essays

    Lab Report

    • 1398 Words
    • 6 Pages

    The homogenates provided were made by homogenizing tissues in a sucrose phosphate buffer in a 1:20 ratio. The protein concentration in bovine cells was measured by diluting the homogenate with a 1:5 ratio; 50 microliters of homogenate and 200 microliters of water. Then 5 known protein concentration samples which were 0.4, 0.8, 1.2, 1.6, 2.0 mg/ml of bovine serum were used to determine absorbance with a spectrophotometer. Two additional samples were made; one was blank and the other was for the specific homogenate sample. Then 3 microliters of bradford assay reagent, which indicates the amount of protein present by color, was added to all samples. The spectrophotometer was zeroed at 595 nm. A standard curve was made with the different absorbencies and concentrations. After the linear equation was formed, the unknown sample concentration was determined using the standard curve equation. A Gel Electrophoresis was used to perform a qualitative analysis. The use of 5 microliters of the homogenate was heated to 80 degrees Celsius. Then the homogenate was transferred to a 2-microliter-protein gel sample buffer. Samples loaded on to the gel was run at 100 v and stained with comassie blue; observations were made next lab. (Clendening 2014)…

    • 1398 Words
    • 6 Pages
    Good Essays
  • Better Essays

    Anti-Cow Serum Lab Report

    • 1052 Words
    • 5 Pages

    Western Blot is a common used technique to identify and analyze proteins according to their ability to bind to a specific antibody. It is an analytical method that protein sample was first separate based on the molecular weight using the SDS- PAGE method, and then transferred on the nitrocellulose. The specific primary enzymes labeled antibody was used to detect the transferred protein. Antibodies bind to specific sequences of amino acids, and can recognize specific proteins among a group of many because the amino acid sequences are different from protein to protein (#3…

    • 1052 Words
    • 5 Pages
    Better Essays
  • Powerful Essays

    Roe, S. (2001). _Protein Purification Techniques: A Practical Approach_ (2nd Ed.). United Kingdom: Oxford University Press…

    • 4130 Words
    • 118 Pages
    Powerful Essays
  • Powerful Essays

    The control samples have a known outcome; in this lab both positive and negative controls were used to determine the identity of the unknown solution. The macromolecules being tested in this lab were carbohydrates (monosaccharides and polysaccharides) and proteins. To identify the presence of these macromolecules in a substance, three different tests were performed. Lugol 's iodine solution was used for identification of starch and glycogen - polysaccharides - in the twelve solutions. A positive outcome of the test results in a colour change; blue-black in the presence of starch and a red-brown in the presence of glycogen. A negative outcome results in no colour change and all solutions remain a very pale yellow (Pavia, 2005). Benedict 's solution was used to identify the presence of reducing sugars; the aldehyde functional group is the part that reacts in the test. A positive indicator of the test is the formation of a coloured precipitate of the blue solution, ranging from yellow-green to red-brown (Hequet and Abidi, 2006).…

    • 1307 Words
    • 11 Pages
    Powerful Essays
  • Good Essays

    Table 1: Worktable for Coomassie Assay. Tubes two through six were created adding the amount of sample in µl to the corresponding tubes along with 1000µL of water and 1mL of coomassie dye. These tubes were mixed and the optical density was surveyed using a Mach V visual spectrophotometer at 595. Tubes seven through ten were created by adding the same amount of an unknown (UK) sample (10µl), coomassie dye (1mL) and water (1000µL). Each tubes 10µl sample varied by the amount it was diluted as shown. These tubes were also mixed and the OD was surveyed at 595. The UK protein in µg was assessed by taken the equation y=0.0259x+.0511 (Fig. 1) and solving for x where y is the OD.…

    • 640 Words
    • 3 Pages
    Good Essays
  • Better Essays

    Bradford Assay

    • 1410 Words
    • 6 Pages

    Title: Bradford Assay: Creating a Standard Curve and Determining Unknown Protein Concentrations Introduction: In biochemistry the ability to determine the quantity of a certain substance in a solution is extremely important. Often protein concentration within a biological organism is essential in determining the function or condition of that organism. If the protein concentration in an environment is increased or decreased it can have detrimental side effects. If there is a decrease in hemoglobin (a protein found within blood), oxygen will not be able to be transported throughout the body.…

    • 1410 Words
    • 6 Pages
    Better Essays
  • Good Essays

    Bean Beetle Experiment

    • 881 Words
    • 4 Pages

    Next, transferred 200 uL of the crude extract to a set of microcentrifuge tube; the blank is created by adding 200 uL of the homogenizing buffer. Then 800 uL of pre-filtered dye reagent was added to each tube and vortexed for additional 10 seconds, followed by an incubation period of 10 minutes (Course Supplement for Bio 101, p. 71). We transferred 500 uL of the solution to the cuvette and measured the absorbance to 595nm. Using the BSA stock solution (2mg/mL=2000 ug/mL), we prepared the concentration of the protein standard by carrying out serial dilution at 2x, 5x, 10x, 20x and 40x. The 2x dilution was made by mixing 250 uL of BSA and 250 of the homogenizing buffer. The solution was then vortexed for 10 seconds. A similar procedure with different concentration of BSA and stock solution was carried out to find the other diluted concentrations. After the dilutions were made, 200 uL of the BSA concentration from the diluted tubes (2x, 5x etc.) were transferred to another microcentrifuge tube and 800 uL of filtered Bradford dye reagent was added to each microcentrifuge containing the BSA standard (Course Supplement for Bio 101, p. 72). The blank solution was created by adding 200 uL of homogenizing of the buffer. Then we incubated the tubes for 10 minutes and inverted 5 times before transferring 500 uL of the solution from each tube to the corresponding spectrometer cuvette; the absorbance was measured at 595 nm. The proper procedures were followed to discard the…

    • 881 Words
    • 4 Pages
    Good Essays
  • Powerful Essays

    Combined activity/elution Profile of rGFP during washes 1-6 and elutions 1-6 in a Ni2+-agarose column. The graph shows RFU’s (left) and total protein in ug (right) for each wash and elution. Once the rGFP had been purified in the Ni2+-agarose column, a breaking buffer (10mM Tris, pH 8.0; 150mM NaCl) was used to create the washes by pipetting the buffer in 0.5ml increments and collecting each in separate tubes labeling them W1-W6. Then, an elution buffer (10mM Tris, pH 8.0; 150mM NaCl; 300mM imidazole) was collected in increments of 0.5ml and labeled E1-E6. We could measure the amount of RFU’s each sample had using 200ul of each fraction and placing them in a spectrofluorometer. E3 showed to have the greatest amount of fluorescence. Using the Bradford assay, the total protein of each sample was determined by extrapolating points from the standard BSA curve. Both values were scaled…

    • 3142 Words
    • 13 Pages
    Powerful Essays
  • Good Essays

    Thin Layer Chromatography

    • 459 Words
    • 2 Pages

    The amino acid standards used in this experiment were Alanine, Glycine, Serine, and Histidine. These standards and the unknown were separated by performing a method of chromatography. Thin layer chromatography (TLC) was performed by using a mobile phase and a stationary phase. The mobile phase was a nonpolar solvent composed of ethanol and ethyl acetate. The solid stationary phase was coated with silica gel, which is very polar. The amino acids were spotted onto two TLC plates; the plates were then placed in a chamber which contained the mobile phase. The plates were sprayed with 0.1% Ninhydrin and placed in an oven. The distance of the traveled spots and the solvent front were measured. With these values, the Rf value for each spot was calculated.…

    • 459 Words
    • 2 Pages
    Good Essays
  • Better Essays

    To determine specific proteins, Western Blotting was introduced by Towbin et al. in 1979. This technique is now commonly used as it is simple, fast and efficient (Thermo Scientific, 2010). The gel from SDS-PAGE is transferred onto a membrane using and electric field known as electrophoretic transfer. The gel is placed against the membrane eluting the proteins onto the matrix using the force of an electric field (Pokorny, 2012). Once on the membrane, it must be blocked using skim milk and treated with a primary and secondary antibody in order to identify a specific protein. The antibodies that will be used are an anti-Rubisco that will mark the chloroplast…

    • 1266 Words
    • 6 Pages
    Better Essays
  • Powerful Essays

    carried out by the protein that makes up the majority of the protein composition of the…

    • 4754 Words
    • 20 Pages
    Powerful Essays
  • Good Essays

    References: Bradford, M. M. (1976). A rapid and sensitive method for the quantitation of microgram quantities of protein utilizing the principle of protein-dye binding. Anal. Biochem. 72: 248-254.…

    • 7477 Words
    • 30 Pages
    Good Essays
  • Better Essays

    Pure proteins are not readily available for study or use. There are certain methods that should be done in order to obtain proteins from its sources. The objective of this experiment is to isolate casein from milk and albumin from egg and to identify and explain the principles behind the methods employed for protein extraction.…

    • 1067 Words
    • 4 Pages
    Better Essays
  • Powerful Essays

    Effect of Coffee

    • 4092 Words
    • 17 Pages

    Henry, R.J. 1964. Colorimetric determination of total protein. In: Clinical Chemistry. Harper and Row Publ., New York, USA.…

    • 4092 Words
    • 17 Pages
    Powerful Essays