Balloon Blocker Essay
Envy TM
Operation and adjustment instructions
Q U I C K START
01
02
BARREL
03
BARREL BLOCKER
Unpack the EnvyTM and its barrel. Screw the barrel into the front of the marker, hand tight. Take care not to strip the barrel threads or overtighten.
Have your compressed air
(HPA) or CO2 tank filled by a person who is properly trained to do so. If using an
HPA system with an on/off valve, make sure it is in the
OFF position. If using a CO2 tank or screw-in style preset
HPA system, fill it while it is removed from the marker.
Put the supplied barrel blocker over the end of the barrel, securing its cord as far back on the EnvyTM body as possible, and cinching it tight.
04
05
LOADER
Fit a paintball loader …show more content…
If the ball is difficult to blow through, the fit is too tight, which can lead to ball breakage.
VELOCITY
The velocity, or speed at which a paintball is fired from the EnvyTM, must be measured and adjusted to below the paintball field’s velocity limit immediately before each day of play (for player safety). If CO2 is used, velocity should be checked and adjusted multiple times during the day. In an area where it is safe to fire paintballs, while wearing ASTM compliant eye and face protection for paintball, fire three or four shots over a chronograph to measure the velocity at which the paint is being fired.
If velocity adjustment is necessary, Use a 5/32-inch allen wrench on the adjuster in the bottom of the vertical regulator, turn clockwise to increase the velocity/pressure, and counter-clockwise to decrease.
Take three or four shots after every adjustment to allow the gas pressure inside the EnvyTM to stabilize.
Adjust until the marker is firing consistently within the limits for the field where you are playing. For safety reasons, never adjust the EnvyTM to fire at greater than 300 feet per second (91.44 meters per second). GOGpaintball.com
07
T R I G GER
Operation and adjustment instructions
Q U I C K START
01
02
BARREL
03
BARREL BLOCKER
Unpack the EnvyTM and its barrel. Screw the barrel into the front of the marker, hand tight. Take care not to strip the barrel threads or overtighten.
Have your compressed air
(HPA) or CO2 tank filled by a person who is properly trained to do so. If using an
HPA system with an on/off valve, make sure it is in the
OFF position. If using a CO2 tank or screw-in style preset
HPA system, fill it while it is removed from the marker.
Put the supplied barrel blocker over the end of the barrel, securing its cord as far back on the EnvyTM body as possible, and cinching it tight.
04
05
LOADER
Fit a paintball loader …show more content…
If the ball is difficult to blow through, the fit is too tight, which can lead to ball breakage.
VELOCITY
The velocity, or speed at which a paintball is fired from the EnvyTM, must be measured and adjusted to below the paintball field’s velocity limit immediately before each day of play (for player safety). If CO2 is used, velocity should be checked and adjusted multiple times during the day. In an area where it is safe to fire paintballs, while wearing ASTM compliant eye and face protection for paintball, fire three or four shots over a chronograph to measure the velocity at which the paint is being fired.
If velocity adjustment is necessary, Use a 5/32-inch allen wrench on the adjuster in the bottom of the vertical regulator, turn clockwise to increase the velocity/pressure, and counter-clockwise to decrease.
Take three or four shots after every adjustment to allow the gas pressure inside the EnvyTM to stabilize.
Adjust until the marker is firing consistently within the limits for the field where you are playing. For safety reasons, never adjust the EnvyTM to fire at greater than 300 feet per second (91.44 meters per second). GOGpaintball.com
07
T R I G GER