Preview

Aggregates for Concrete Handout

Good Essays
Open Document
Open Document
882 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Aggregates for Concrete Handout
Aggregates for Concrete

Aggregates are inert granular materials such as sand, gravel, or crushed stone that, along with water and cement, are an essential ingredient in concrete.
Aggregates are the most mined materials in the world.
For a good concrete mix, aggregates need to be clean, hard, strong particles free of absorbed chemicals or coatings of clay and other fine materials that could cause the deterioration of concrete.
Aggregates, which account for 60 to 75 percent of the total volume of concrete, are divided into two distinct categories--fine and coarse.

Fine Aggregates - generally consist of natural sand or crushed stone with most particles smaller than 5 mm (0.2 in.).

Coarse Aggregates - consist of one or a combination of gravels or crushed stone with particles predominantly larger than 5 mm (0.2 in.) and generally between 9.5 mm and 37.5 mm (3⁄8 in. and 11⁄2 in.).

Some natural aggregate deposits, called pit-run gravel, consist of gravel and sand that can be readily used in concrete after minimal processing.
Natural gravel and sand are usually dug or dredged from a pit, river, lake, or seabed.
Crushed stone is produced by crushing quarry rock, boulders, cobbles, or large-size gravel.
Crushed air-cooled blast-furnace slag is also used as fine or coarse aggregate.
The aggregates are usually washed and graded at the pit or plant.
Naturally occurring concrete aggregates are a mixture of rocks and minerals. Weathering and erosion of rocks produce particles of stone, gravel, sand, silt, and clay.
Recycled concrete, or crushed waste concrete, is a feasible source of aggregates and an economic reality, especially where good aggregates are scarce.

Aggregates strongly influence concrete's freshly mixed and hardened properties, mixture proportions, and economy. Consequently, selection of aggregates is an important process. Although some variation in aggregate properties is expected, characteristics that are considered include:
grading

You May Also Find These Documents Helpful

  • Good Essays

    Sand is a naturally occurring granular material composed of finely divided rock and mineral particles. The composition of sand is highly variable, depending on the local rock sources and conditions, but the most common constituent of sand in inland continental settings and non-tropical coastal settings is silica (silicon dioxide, or SiO2), usually in the…

    • 823 Words
    • 4 Pages
    Good Essays
  • Good Essays

    Shift Em Bailey

    • 1057 Words
    • 5 Pages

    2. Inorganic (Mechanical) sedimentary rock - these are formed from the compacted remains of the broken down particles of other rocks; Sandstone and Shale are examples.…

    • 1057 Words
    • 5 Pages
    Good Essays
  • Good Essays

    Roman Roads

    • 538 Words
    • 3 Pages

    sand. The second to top layer, known as the radus, is made with fine concrete. The top layer, called the summum dorsum, is…

    • 538 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Sedimentator Lab Report

    • 1082 Words
    • 5 Pages

    These are the particles that make up sedimentary rocks. Sediments are made up of minerals.…

    • 1082 Words
    • 5 Pages
    Good Essays
  • Good Essays

    The crystals form a sort of glue that sticks or cements the pieces of rock together. This process is called cementation.…

    • 771 Words
    • 4 Pages
    Good Essays
  • Good Essays

    Mass Wasting Lab

    • 1141 Words
    • 5 Pages

    When the clay was saturated it became real sticky and even stuck to the tray. Others formed into big clumps, while the gravel resembled its dry version except for all the scattering.…

    • 1141 Words
    • 5 Pages
    Good Essays
  • Powerful Essays

    Sieve Analysis Report

    • 1237 Words
    • 5 Pages

    Fine aggregate, often called sand ( BS 882: 1992) are those granular materials having size not larger than 5mm. coarse aggregate are those granular materials having at least 5mm in size.…

    • 1237 Words
    • 5 Pages
    Powerful Essays
  • Good Essays

    Roman Pozzolanic Concrete

    • 680 Words
    • 3 Pages

    Concrete is a mixture made up of an aggregate, a binding agent and water. Typically the aggregate is gravel, sand or small stones. This is the filler that gives the final product its mass. The binding agent is what causes the mixture to set and harden. When the aggregate and binding agent are combined with water a thick mixture is created that can be poured into a form which then solidifies. In early civilization the binding agent was typically limestone powder or gypsum. The Romans discovered the use of pozzolana as a binding agent (Yegeul, n.d.). Pozzolana is a fine, sandy, volcanic ash which when used as a binding agent creates a strong durable concrete (Wikipedia, 2011, Pozzolana).…

    • 680 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Essay On Turtle Stones

    • 355 Words
    • 2 Pages

    Concretions, some of which are called turtle stones, have been geological curiosities around the world for centuries. According to Wikipedia, a concretion is a hard, compact mass of matter formed within layers of sedimentary rock such as sandstone, shale, siltstone, and limestone. Concretions form as minerals within rock beds and precipitate in cracks and cavities, or as sediment builds up in layers around a core like a pebble or a shell.…

    • 355 Words
    • 2 Pages
    Good Essays
  • Good Essays

    13.8 Compare the manner in which the aggregate particles become bonded together in clay-based mixtures during firing and in cements during setting.…

    • 618 Words
    • 2 Pages
    Good Essays
  • Powerful Essays

    For concrete is a mixture of coarse (stone or brick chips) and fine (generally sand or crushed stone) aggregates with a binder material like usually Portland cement. When mixed with a small amount of water, the cement hydrates to form microscopic opaque crystal lattices encapsulating and locking the aggregate into a rigid structure. Typical concrete mixes have high resistance to compressive stresses about 28 MPa. However, any appreciable tension (due to bending) will break the microscopic rigid lattice, resulting in cracking and separation of the concrete. For this reason, typical non-reinforced concrete must be well supported to prevent the development of tension.…

    • 7570 Words
    • 31 Pages
    Powerful Essays
  • Better Essays

    Civil Engineering

    • 10748 Words
    • 43 Pages

    Portland cement, the basic ingredient of concrete, is a closely controlled chemical combination of calcium, silicon, aluminum, iron and small amounts of other ingredients sand to which gypsum is added in the final grinding process to regulate the setting time of the concrete. Lime and silica make up about 85% of the mass. Common among the materials used in its manufacture are limestone, shells, and chalk or marl combined with shale, clay, slate or blast furnace slag, silica sand, and iron ore.…

    • 10748 Words
    • 43 Pages
    Better Essays
  • Good Essays

    Los Angeles Abrasion Test

    • 974 Words
    • 4 Pages

    The properties of aggregates used in asphalt concretes are very important to the performance of the pavements in which the asphalt concretes are used. Often pavement distress, such as stripping and rutting, can be traced directly to the aggregates used. Clearly, proper aggregate selection is necessary for attaining desired performance. The aggregate used in surface course of the highway pavements are subjected to wearing due to movement of traffic. When vehicles move on the road, the soil particles present between the pneumatic tyres and road surface cause abrasion of road aggregates. The steel reamed wheels of animal driven vehicles also cause considerable abrasion of the road surface. Therefore, the road aggregates should be hard enough to resist abrasion. Resistance to abrasion of aggregate is determined in laboratory by Los Angeles test machine.…

    • 974 Words
    • 4 Pages
    Good Essays
  • Good Essays

    Aggregate and Its Property

    • 1045 Words
    • 5 Pages

    Aggregates are defined as a combination of distinct parts gathered into a mass or a whole. They can increase stability of a structure and protect it from bad weather. In addition, aggregates can also increase quality and reduce price of the cements beacause of their greater volume stability and filling function. Therefore, it is important for civil engineers to understand properties of aggregates.…

    • 1045 Words
    • 5 Pages
    Good Essays
  • Good Essays

    Concrete mixer which is also commonly named as cement mixer is a device that homogeneously combines cement, aggregate such as sand or gravel, and water to form concrete.…

    • 550 Words
    • 3 Pages
    Good Essays