Abstract. This report is about how to standardize a Sodium Hydroxide (NaOH) solution by titrating it with pure sample of Potassium acid Phthalate (KHC8H4O4). This experiment has two sections. The first section is to standardize the Sodium Hydroxide by titration. Three sample of 0.7 – 0.9 g of solid KHP are place into each of the three numbered Erlenmeyer flasks. 50 ml of distilled water are added to each three of it from graduated cylinder and constantly shake it until the KHP solution are completely
Premium Sodium hydroxide Titration
12-STANDARDIZATION OF SODIUM HYDROXIDE Standard solutions for titrations are especially pure mixtures with exactly known concentrations. Primary standards are very pure solids. They have the advantage that they can be weighed (the analytical balance is normally the most accurate instrument in the laboratory) and they are stable under laboratory conditions. In this experiment‚ the primary standard is oxalic acid dihydrate‚ H2C2O4 ( 2H2O. It will be used to standardize a solution of sodium
Premium Sodium hydroxide Titration Water
Preparation and Standardization of a Sodium Hydroxide Solution Objective/Purpose: The objective of this experiment will be the standardization of sodium hydroxide using potassium hydrogen phthalate by the titration method. Introduction: The concentration of solutions can be reported in terms of molarity and normality. Molarity is equal to: HCL‚ HBR‚ H2SO4‚ HNO3 M = mol Solute (mol) (Monoprotic) (Diprotic) _______________ V(L)g solutions (L) M =
Premium Sodium hydroxide Acid Titration
Oxalic Acid Lab Aim: Use acid base titration to determine the number of water molecules in hydrated hydrochloric acid. Apparatus required: Oxalic acid solution 250 cm3 Weighing bottle Digital balance Beaker (250 cm3) Distilled Water Volumetric Flask 250cm3 Filter funnel Pipette Burette 50cm3 Retort Stand Beakers 100cm3 Standardized sodium hydroxide solution 0.1M Pipette filter Conical flasks 250cm3 Phenolphthalein Indicator Procedure 1) Rinse the burette with distilled
Premium Sodium hydroxide Titration Laboratory glassware
Standardisation of a Solution of Sodium Hydroxide: Introduction: In a lot of cases it isn’t possible to prepare a solution by accurate weighing of the solute‚ dissolving in water and diluting to volume. There are many possible reasons for this‚ but in the case of sodium hydroxide‚ the solid absorbs moisture from the air‚ and also reacts with carbon dioxide from the air. In that case‚ it cannot be accurately weighed in air. In an experiment like this‚ a solution of the approximate required concentration
Premium Titration
Analysis of acid by titration with sodium hydroxide Ms. Hoang November 2012 Introduction: The purpose of this experiment is to demonstrate an example of how to determine the unknown molarity of hydrochloric acid by titration with a base (sodium hydroxide). Titration is a common laboratory method of quantitative chemical analysis that is used to determine the unknown concentration of an identified analyte (wekipedia). The first step will be measuring and combining water and acid (Hydrochloric
Premium PH PH indicator Chemistry
Sodium hydroxide‚ also known as caustic soda‚[2][3] or lye‚ is an inorganic compound with the chemical formula NaOH (also written as NaHO). It is a white solid‚ and is a highly caustic metallic base and alkali salt. It is available in pellets‚ flakes‚ granules‚ and as a 50% saturated solution.[citation needed] Sodium hydroxide is soluble in water‚ ethanol and methanol. This alkali is deliquescent and readily absorbs moisture and carbon dioxide in air. Sodium hydroxide is used in many industries
Premium Sodium hydroxide
Standardization of hydrochloric acid by sodium carbonate Concentrated hydrochloric acid is roughly 11 M. Pour out into a measuring cylinder about 2 cm3 of concentrated hydrochloric acid. Transfer it to a 250 cm3 flask and make up to the mark with water. Shake well. Put some pure sodium hydrogen carbonate or anhydrous sodium carbonate into an evaporating dish and heat gently over a low flame for about fifteen minutes‚ stirring continuously. Take care not to heat the mass too strongly or fusion
Premium Sodium carbonate Carbon dioxide Sodium bicarbonate
Chemistry Lab Report on standardization of acid and bases. Purpose: To prepare standardize solution of sodium hydroxide and to determine the concentration of unknown sulfuric acid solution. Data and Calculations: This experiment is divided into two parts (Part A and Part B). In the first part of experiment‚ the standardize solution of sodium hydroxide is prepared by titrating it with base Potassium hydrogen phthalate (KHP). The indicator Phenolphthalein is used to determine that whether titration
Premium Sodium hydroxide
PRACTICAL REPORT EXPT 2: Standardization and Determination of Concentration of Hydrochloric Acid in a Given Solution by ARAKA BRAMWEL MBOGO EN251-0221/2010 TITLE: STANDARDIZATION and DETERMINATION OF THE CONCENTRATION OF HYDROCHLORIC ACID PRESENT IN A GIVEN SOLUTION Aims: To be able to standardize Sodium Hydroxide (NaOH) solution using a standard solution of Oxalic acid. To be able to prepare standard solutions. To determine the strength of a given solution of Hydrochloric acid (HCl)
Premium Titration Sodium hydroxide Chlorine