Refer to the exhibit. The network administrator has just added VLAN 50 to Switch1 and Switch2 and assigned hosts on the IP addresses of the VLAN in the 10.1.50.0/24 subnet range. Computer A can communicate with computer B, but not with computer C or computer D. What is the most likely cause of this problem? *VLAN 50 is not allowed to entering the trunk between Switch1 and Switch2. Refer to the exhibit. The exhibited configurations do not allow the switches to form a trunk. What is the most likely cause of this problem? *The trunk cannot be negotiated with both ends set to auto.
Refer to the exhibit. Which two conclusions can be drawn regarding the switch that produced the output shown? (Choose two.) *The command switchport access vlan 20 was entered in interface configuration mode for Fast Ethernet interface 0/1. Devices attached to ports fa0/5 through fa0/8 cannot communicate with devices attached to ports fa0/9 through fa0/12 without the use of a Layer 3 device. What statements describe how hosts on VLANs communicate?
*Hosts on different VLANs communicate through routers.
Switch port fa0/1 was manually configured as a trunk, but now it will be used to connect a host to the network. How should the network administrator reconfigure switch port Fa0/1? *Enter the switchport mode access command in interface configuration mode. Refer to the exhibit. SW1 and SW2 are new switches being installed in the topology shown in the exhibit. Interface Fa0/1 on switch SW1 has been configured with trunk mode “on”. Which statement is true about forming a trunk link between the switches SW1 and SW2? *Interface Fa0/2 on switch SW2 will negotiate to become a trunk link if it supports DTP. The network administrator wants to separate hosts in Building A into two VLANs numbered 20 and 30. Which two statements are true concerning VLAN configuration? (Choose two.) *The VLANs may be named.
The network administrator may create the VLANs in either global configuration mode or VLAN...
Please join StudyMode to read the full document