Preview

Introduction Spectrophotometer Is An Optical Instrument

Better Essays
Open Document
Open Document
3281 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Introduction Spectrophotometer Is An Optical Instrument
Introduction Spectrophotometer is an optical instrument that measures and shows how much light energy is transmitted by a substance in solution at different wavelengths of radiant energy. Light passes into a monochromator where only a very narrow range of wavelengths can pass through. From there, light is transmitted through a sample solution, and on to a phototube where the light energy is converted to an electric current that is registered on a meter. To measure the amount of light absorbed by the solutes in sample solution, comparison to the initial intensity of light reaching the solution is needed. Each solution with a different solute has its own characteristic absorption property or spectrum. Spectrophotometer can also be used to find out the concentration of compounds in solution because the amount of light absorbed is directly proportional to the concentration of absorbing compounds in that sample. When a solution like bromophenol blue absorbs certain wavelengths of light in the visible spectrum and transmits or reflects others, it appears coloured. However, water is a colourless solution because it absorbs only wavelength outside of the visible light spectrum. By analysing the pattern of wavelength absorbed by a given sample, spectrophotometer can be used to distinguish compounds as different compounds absorb light at different wavelength. Figure 1 shows the schematic diagram of the components in a spectrophotometer.

Figure 1. A schematic diagram of the components in a spectrophotometer. The arrows indicate the pathway of light.
The spectrophotometer consists of a light source, a prism or diffraction grating that separates the light into different wavelengths. A narrow beam of the desired wavelength passes through a slit (the incident light, I0) which is then passing through the sample solution in the cuvette. The photosensitive tube measures the transmittance or absorbance value for the sample by detecting the light that passes through the



References: A chapter from a book: Francis Rouessac and Annick Rouessac. Chemical Analysis: Modern Instrumentation Methods and Techniques 2nd edition. John Wiley & Sons. Ltd; 2007. Chapter 9, Ultraviolet and visible absorption spectroscopy; p.181-186 A chapter from a textbook: G H Jeffery, J Bassette, J Mendham, R C Denny. Vogel 's Textbook of Quantitative Chemical Analysis 5th edition. Longman Scientific and Technical; 1989. Chapter 17, colorimetry and spectrophotometry; p. 645-651 Online references: G. J. Dixon. Spectrophotometers take absorption measurements. 01 July 1997. Available from: http://www.laserfocusworld.com/articles/print/volume-33/issue-7/world-news/spectrophotometers-take-absorption-measurements.html

You May Also Find These Documents Helpful

  • Better Essays

    Bio Spectroscopy Lab

    • 1273 Words
    • 6 Pages

    The purpose of this lab is to identify the concentration of unknown 276 using absorption values obtained from the spectrophotometer. When using these absorbance values in relation to similar fast green dilution solutions, the concentration of unknown 276 was achieved by drawing a line of best fit on a scatter plot (refer to figure 2 within this lab). By using absorption values of other solutions such as fast green stock solution and chloroplast pigments, information about high absorbency wavelengths was gained. By plotting this information in an “absorption spectrum” graph, the maximum absorption was easily identified for fast green, chlorophyll A and chlorophyll B (refer to figures 1 and 4 within this lab). The graphs in general can be closely related and compared to Beer’s Law stated above. For example, when referring to figure 2 (within this lab) concentration curve for fast green, absorption is in relation to concentration, where as when the concentration of a substance is increased, higher values of light was absorbed (Jones et al., 2007).…

    • 1273 Words
    • 6 Pages
    Better Essays
  • Satisfactory Essays

    Lab Writeup

    • 237 Words
    • 2 Pages

    Purpose: To measure the amount of pigment in a solution of 40% ethanol and deionized water both containing pieces of an onion with a spectrometer.…

    • 237 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    Spinach Lab

    • 767 Words
    • 4 Pages

    First, the spectrophotometer was set to a wavelength of 605 nm. Then15 mL of pre-prepared chloroplast membrane suspension was obtained, and kept cold in a beaker containing ice to keep the chloroplast fragments from degrading. Then DCIP was retrieved in a foil wrapped test tube to keep any form of light out. Also, 15 mL of distilled water was obtained along with 7 test tubes; labeled blank and numbers 1-6. A blank was prepared by combining 5 mL of distilled water and 2.5 ml of chloroplast membrane suspension, mixing it well and producing a consistent green color. Tube 1 was set as a control for experiment three by combining .5 mL of DCIP and 2.5 mL of water. The absorbance of the first test tube was recorded initially at 0 minutes, and then placed under a light for one minute. Then the absorbance was tested again. and this process was repeated until there were five total readings. The second tube was used as a positive control against white light. The solution was produced by combining .5 mL of DCIP with 2.5 mL of CMS. Like the blank, this tube was screened for its original absorbance, and then exposed to white light for one minute until five readings were obtained. The third test tube was a negative control with no exposure to light. The tube was wrapped in a foiling casing and cap, and contained the same solution as test tube 2, .5 mL of DCIP and 2.5 mL of CMS. The…

    • 767 Words
    • 4 Pages
    Good Essays
  • Satisfactory Essays

    Cyclohexane Lab Report

    • 175 Words
    • 1 Page

    The samples were recorded using a UV-Vis spectrometer. In addition, the absorbance of the first sample was…

    • 175 Words
    • 1 Page
    Satisfactory Essays
  • Powerful Essays

    Absorption Spectrometry is the study light absorbed by molecules. In it white light is cause to pass through a sample and then through a device that breaks the light up into a spectrum. When such light is passed through a sample, under right conditions, the electrons of the sample will absorb certain wavelengths of light, and the device will read the others and compare them to the one in the beginning and that’s how the absorption is calculated. With the data obtained from absorption spectroscopy is most often evaluated using the Beer-Lambert Law. This is how absorption measurements are converted into concentration values.…

    • 1043 Words
    • 5 Pages
    Powerful Essays
  • Powerful Essays

    Reference 3: "Salter 's Advanced Chemistry: Chemical Ideas"; 3rd Ed; Heinemann Educational Publishers: 2008; pg. 157 "Using ultraviolet and visible spectra"…

    • 2329 Words
    • 10 Pages
    Powerful Essays
  • Powerful Essays

    Molarity Lab Report

    • 1392 Words
    • 6 Pages

    The wavelength was set to absorbance of 600 nm, which is the max for Cu2+. Ten small test tubes were cleaned and a piece of label tape was placed around the top of each tube. A vertical straight line was drawn on the tape to help align with the mark on the instrument sample holder. The transmittance of the Spec 20 was set to 0% using the left-hand adjustment knob while the well was empty and closed. One test tube was filled 3/4 full of a blank solution (distilled water). A Kimwipe was used to wipe off any solution on the outside of the test tube. The test tube was then placed into the empty well with both the mark on the test tube and the mark on the well aligned. The lid of the well was closed. The right-hand adjustment knob was used for setting the transmittance to…

    • 1392 Words
    • 6 Pages
    Powerful Essays
  • Best Essays

    Spectroscopy is the study of light. A spectrophotometer is a machine used to determine the absorbance of light at any given wavelength. It does this by using a source of white light through a prism, which gives multiple wavelengths that can be individually focused (Ayyagari and Nigam, 2007). Substances are put into cuvettes that are glass or quartz containers that light can easily travel through. The light that is being focused travels through the substance gets absorbed by the substance and is reflected back and read by galvanometer which had the ability to detect electric currents (Verma, R). The absorbance reading is then given, absorbance is usually between 0.0 – 2.0, any higher than 2.0 may mean not enough light is getting through to the galvanometer (Bhowmik and Bose, 2011). When using the spectrophotometer it is necessary to use a control or blank to zero or tare the machine in between every new wavelength or concentration, this control is water (Ayyagari and Nigam, 2007). The correlation between the numbers acquired through spectroscopy can be seen using the Beer- Lambert Law. The Beer- Lambert law states that the amount of light absorbed at a certain wavelength is proportional to the concentration of the absorbing substance (Fankhauser, 2007).…

    • 2210 Words
    • 9 Pages
    Best Essays
  • Best Essays

    11) Ashraf Essa (2009). Making standard solutions- Introduction to Spectrophotometry. University of Bedfordshire (Luton). BHS006-1.…

    • 990 Words
    • 4 Pages
    Best Essays
  • Good Essays

    A spectrophotometer is an instrument used to help determine the absorption spectrum of chemicals. It does this by reading the absorbance of the chemical at different wavelengths. All chemicals absorb light in their own distinct way. This distinction helps to identify unknown chemicals. The absorption of light within a chemical is also very important because that amount of light is used to perform work within its system. To help find the absorption of a chemical, the Beer-Lambert law is used. The law states that A=e × c × l; A standing for absorbance, e for the molar extinction coefficient, c for concentration,…

    • 889 Words
    • 4 Pages
    Good Essays
  • Satisfactory Essays

    This lab will teach me how to use a spectrophotometer. The use of the spectrophotometer is to measure the concentration of solute. The solute being measured must be colored and is determined based on the adsorption of light photons on a wavelength. The spectrophotometer uses a beam of light that strikes the diffraction grating that basically forms of prism of light. Then only a specific wavelength of light shines through the spectrophotometer and interacts with the solute. The light that continues past the solute hits the phototube. The spectrophotometer then digitally shows the amount of units that have been absorbed or transmitted. Transmittance is the amount of light that gets through the sample. This is shown as a percent of all the possible light that could’ve gotten through. Absorbance is the opposite of transmittance and the reciprocal of it. This shows how much light got trapped in the solute. In this lab we will use a few different solutions in the spectrophotometer to get a basic feel on how it works. We will record the absorbance as well as do calculations using mean and standard deviation. We will then graph our results and compare them with the class values of the three unknown Methylene blue samples. At the end of the lab the actual concentrations of each unknown will be shared. We will then compare how accurate and precise our results are with the actual.This lab will teach me how to use a spectrophotometer. The use of the spectrophotometer is to measure the concentration of solute. The solute being measured must be colored and is determined based on the adsorption of light photons on a wavelength. The spectrophotometer uses a beam of light that strikes the diffraction grating that basically forms of prism of light. Then only a specific wavelength of light shines through the spectrophotometer and interacts with the solute. The light that continues past the solute hits the phototube. The spectrophotometer…

    • 1420 Words
    • 6 Pages
    Satisfactory Essays
  • Powerful Essays

    A solution is composed of a solute dissolved into a solvent. The most common solvent is water. Determining the components and concentrations of solutes in a solution is carried out through a variety of techniques known as spectroscopy. Spectroscopy is the analysis of spectra, typically light or mass spectra, where the spectrum of a source is used to determine the composition of a substance. There are many different spectroscopic methods including circular dichroism, mass spectrometry, Raman, spectroscopy, nuclear magnetic resonance (NMR) spectroscopy, and ultraviolet-visible spectroscopy. A UV-Vis spectrophotometer measures absorbance, which is related to the transmittance of light through a solution. Absorbance is the measure of light intensity that is absorbed by a sample. A=log Io/I is the calculation. Beer’s law mathematically expresses the relationship between absorbance and sample concentration. Absorbance and concentration are directly are proportional. A Beer’s law plot is a graph showing the linear relationship between absorbance and concentration that can be fit to a straight line from which the concentration of an unknown sample can be calculated. A colorimeter is a type of…

    • 1297 Words
    • 8 Pages
    Powerful Essays
  • Best Essays

    [14] Skoog, D.A., West, D.M., et al., Introduction to Analytical Chemistry, 8th edition, Cengage Learning Asia Pte Ltd., 2012, p…

    • 2156 Words
    • 8 Pages
    Best Essays
  • Powerful Essays

    Spectrophotometry is a method to measure how much a chemical substance absorbs light by measuring the intensity of light as a beam of light passes through sample solution. The basic principle is that each compound absorbs or transmits light over a certain range of wavelength. This measurement can also be used to measure the amount of a known chemical substance. Spectrophotometry is one of the most useful methods of quantitative analysis in various fields such as chemistry, physics, biochemistry, material and chemical engineering and clinical applications.…

    • 1686 Words
    • 7 Pages
    Powerful Essays
  • Better Essays

    References: Skoog, Douglas A., Donald M. West, and F. James. Holler. Fundamentals of Analytical Chemistry, 8th ed. Fort Worth: Saunders College Pub., 1996. Print.…

    • 2693 Words
    • 11 Pages
    Better Essays