Electric Power Transmission

Topics: Electric power transmission, Electricity distribution, Electrical engineering Pages: 27 (7736 words) Published: October 28, 2011
Electric power transmission

"Electric transmission" redirects here. For vehicle transmissions, see diesel-electric transmission. [pic]
400 kV high-tension transmission lines near Madrid
Electric power transmission or "high-voltage electric transmission" is the bulk transfer of electrical energy, from generating power plants to substations located near population centers. This is distinct from the local wiring between high-voltage substations and customers, which is typically referred to as electric power distribution. Transmission lines, when interconnected with each other, become high-voltage transmission networks. In the US, these are typically referred to as "power grids" or just "the grid", while in the UK the network is known as the "national grid." North America has three major grids: The Western Interconnection; The Eastern Interconnection and the Electric Reliability Council of Texas (or ERCOT) grid. Historically, transmission and distribution lines were owned by the same company, but over the last decade or so many countries have liberalized the electricity market in ways that have led to the separation of the electricity transmission business from the distribution business.[1] Transmission lines mostly use three-phase alternating current (AC), although single phase AC is sometimes used in railway electrification systems. High-voltage direct-current (HVDC) technology is used only for very long distances (typically greater than 400 miles, or 600 km); submarine power cables (typically longer than 30 miles, or 50 km); or for connecting two AC networks that are not synchronized.[citation needed] Electricity is transmitted at high voltages (110 kV or above) to reduce the energy lost in long distance transmission. Power is usually transmitted through overhead power lines. Underground power transmission has a significantly higher cost and greater operational limitations but is sometimes used in urban areas or sensitive locations. A key limitation in the distribution of electricity is that, with minor exceptions, electrical energy cannot be stored, and therefore must be generated as needed. A sophisticated system of control is therefore required to ensure electric generation very closely matches the demand. If supply and demand are not in balance, generation plants and transmission equipment can shut down which, in the worst cases, can lead to a major regional blackout, such as occurred in the US Northeast blackouts of 1965, 1977, 1996, 2003, and the Great Blackout of 2011. To reduce the risk of such failures, electric transmission networks are interconnected into regional, national or continental wide networks thereby providing multiple redundant alternate routes for power to flow should (weather or equipment) failures occur. Much analysis is done by transmission companies to determine the maximum reliable capacity of each line (ordinarily less than its physical or thermal limit) to ensure spare capacity is available should there be any such failure in another part of the network. [pic]

Diagram of an electrical system.

|Contents | | [hide]  | |1 Overhead transmission | |2 Underground transmission | |3 History | |4 Bulk power transmission | |4.1 Grid input | |4.2 Losses | |4.3 Subtransmission | |4.4 Transmission grid exit | |5...
Continue Reading

Please join StudyMode to read the full document

You May Also Find These Documents Helpful

  • Microwave Transmission Essay
  • Power Generation Essay
  • Essay on Design the Optimum Grid and Power Sources for Sarawak
  • Power Outage Essay
  • Power Transmission Line Project Essay
  • Wireless Power Transmission Essay
  • JSB Market Research
  • India Power Sector Research Paper

Become a StudyMode Member

Sign Up - It's Free