# Circuit Board Fabricators

Topics: Printed circuit board, Manufacturing, Drill Pages: 6 (1972 words) Published: August 5, 2007
CBF has hired you to help determine why they are not able to produce the 1,000 boards per day.

1.What type of process flow structure is CBF using?

The company is using a batch shop process flow structure. CBF, Inc. bases its board fabrication process on the average job size or on its typical order. This means that the company proceeds with the manufacturing process in batches so as to meet the specific requirements per order. The typical contract that the company currently gets is 60 boards per order. However, due to persisting factory defects, they manufacture a total of 75 boards per batch in order to compensate for 20% of the boards that they typically reject during the process.

2.Diagram the process in a manner similar to exhibit 6.7.

According to the book, the diagram is an operation and route sheet that specifies operations and process routing for a particular part. It conveys such information as the type of equipment, tooling and operations required to complete the particular part.

The "Setup Hr." is derived from dividing the setup (minutes per job, as illustrated in exhibit 6.9) by 60 minutes. Likewise, the hourly capacity of each operation (Rate Pc. Hr.) is solved by dividing 60 minutes by the run (minutes per part, as shown in exhibit 6.9).

3.Analyze the capacity of the process.

The first thing to consider is the process of cleaning and coating of the boards. This particular process involves the set-up of the machines, the loading of the boards, and the actual cleaning and coating of the said boards by the machines.

From the computations above, it is clearly illustrated that there is a disparity between the loading of the boards into the machines and the output of the cleaning and the coating machines. The loading rate exceeds that of the cleaning and coating capacities.

There are 5 exposure machines, with a person attending to each one's operation, loading and unloading. This exposure machine involves a set up time, as illustrated below.

Again, the capacity of the exposure machine, which is 1,138 board, exceeds its preceding process, which only churns out 900 boards per shift.

In this part of the manufacturing process, a person is in charge of loading the boards into the machine. From the previous computation (in the part of coating and cleaning), the average loading rate per day is 1,019.

It can be seen here that the developing capacity of the machine far exceeds the number of boards that are loaded into it. Again, there is disparity between the processes.

Two people are stationed at the inspection part of the process where each board is picked from the conveyor as it comes from the developer. Moreover, the inspection machine optically checks the boards.

The inspection can go through 120 boards per hour. However, this is the part in the process where rejects are picked out. Historically, 15% of those that go through inspection do not pass. This means that out of the 120 boards that are churned out of inspection in an hour, 18 of them are did not pass. Therefore, in a full shift which ideally would inspect 1,800 boards, only 1,530 boards will make it to the next process, which is baking. The capacity of the bake oven is computed below.

If 1,530 boards passed the inspection and are passed on to the bake oven, only 1,365 of them are accomplished. Again, there is a deficit in capacity of the bake oven as compared to its preceding process output.

After baking, the boards are manually unloaded and placed on the cart to be moved to the drilling machines. Before drilling, there is a set-up required, and the capacity of this process is computed as follows.

The drilling machine can well accommodate the number of boards that are transferred to it because it exceeds the capacity of its precedent, which is baking.

After drilling, the boards are transferred for copper plating. Each board is manually loaded on a conveyor that passes through the plating bath....

Please join StudyMode to read the full document