Blue Screen of Death

Page 1 of 3

Blue Screen of Death

By | November 2012
Page 1 of 3
Blue Screen of Death Code

Stop Code: STOP 0x0000000A
Source: Faulty device drivers, or services from backup utilities or virus scanners Recommended: Remove, disable or stop the offending drivers, backup utilities or virus scanners. Stop Code: STOP 0x0000001E

Source: Some driver files causes this error.
Recommended: Remove, disable or update the offending driver-file listed in the error message. Verify new installation of hardware is correct or not.

Stop Code: STOP 0×00000024
Source: This error is generally caused due to disk corruption in the NTFS file system or third-party disk defragments. Recommended: Check S.M.A.R.T status of the hard disk or check the hard disk with a HDD diagnostic software and confirm if its working or not. Stop Code: STOP 0x0000002E

Source: Common causes are memory parity error or hardware fault or wrong configuration. Recommended: If you have added a new RAM module, remove it and check if the error still occurs. If the error still persists, disable memory caching in BIOS. Otherwise you may have to remove or repair the faulty hardware. Stop Code: STOP 0×00000050

Source: This Stop message occurs when requested data is not found in memory. The system generates a fault, which normally indicates that the system looks for data in the paging file. In this circumstance, however, the missing data is identified as being located within an area of memory that cannot be paged out to disk. The system faults, but cannot find, the data and is unable to recover. Faulty hardware, a buggy system service, antivirus software, and a corrupted NTFS volume can all generate this type of error. Recommended: This Stop message usually occurs after the installation of faulty hardware or in the event of failure of installed hardware (usually related to defective RAM, either main memory, L2 RAM cache, or video RAM). If hardware has been added to...