Preview

Determination of Pka

Satisfactory Essays
Open Document
Open Document
435 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Determination of Pka
Determination of pKa

James McDuffie

ABSTRACT: In this lab, the pKa of unknown solution #4 was measured

Introduction:

This lab focused on the equilibrium constant, Ka. Ka is associated with chemical properties of acids. The equivalence point will be reached once the moles of OH- equal the moles of HA and once this point is reached, the PH changes very quickly. With the results, a titration curve should be produced.

Experimental Section

Materials and Methods: A buret with NaOH solution was used to ensure an accurate measure of NaOH could be taken. A PH recording machine was used to measure the PH. To make sure 25.0 ml of the unknown was measured, we used a 25.0 ml pipet.

The buret was primed and filled with NaOH. The measured 25.0 ml of the unknown solution was placed into a beaker and the PH was measured. At this point, different amounts of NaOH (varying from 0.5 ml to 2.0 ml) were added to the solution, each PH and new amount of NaOH being recorded until the equivalence point was reached.

Results and Discussion:

Each time completed, PH, and ml of NaOH solution left was recorded in the following table:

Time |PH |NaOH (ml) |Time |PH |NaOH (ml) |Time |PH |NaOH (ml) | |1 |3.17 |1.27 |21 |4.64 |26 |41 |5.47 |49 | |2 |3.77 |3.62 |22 |4.70 |28 |42 |5.54 |50 | |3 |3.61 |4 |23 |4.75 |30 |43 |5.64 |1 | |4 |3.64 |4.5 |24 |4.81 |32 |44 |5.71 |2 | |5 |3.70 |5 |25 |4.88 |34 |45 |5.81 |3 | |6 |3.86 |6 |26 |4.95 |36 |46 |5.94 |4 | |7 |3.95 |7 |27 |5.01 |38 |47 |6.08 |5 | |8 |4.06 |8 |28 |5.04 |39 |48 |6.21 |5.5 | |9 |4.12 |9 |29 |5.07 |40 |49 |6.32 |6 | |10 |4.19 |10 |30 |5.12 |41 |50 |6.52 |6.5 | |11 |4.20 |11 |31 |5.17 |42 |51 |6.78 |7 | |12 |4.22 |12 |32 |5.17 |42.5 |52 |8.60 |7.5 | |13 |4.29 |13 |33 |5.21 |43.5 | | | | |14 |4.30 |14 |34 |5.25 |44.5 | | | | |15 |4.31 |15 |35 |5.30 |45.5 | | | | |16 |4.38 |16 |36 |5.31 |46 | | | | |17 |4.43 |18 |37 |5.34 |46.5 | | | | |18 |4.51 |20 |38 |5.36 |47 | | | | |19 |4.56 |22 |39 |5.40 |47.5 | | | | |20

You May Also Find These Documents Helpful

  • Good Essays

    Chem Pre-Lab

    • 635 Words
    • 3 Pages

    The volume of NaOH solution used in the titration is given by the initial buret reading subtracted (0.50 mL) from the final buret reading (23.78 mL).…

    • 635 Words
    • 3 Pages
    Good Essays
  • Good Essays

    6.03 Calorimetry Lab

    • 529 Words
    • 3 Pages

    The LabQuest and the Vernier pH sensor was then hooked up and turned on to measure and graph the pH of the solution and the volume of NaOH. The Vernier pH sensor was then was placed in the solution and remained in the solution throughout the duration of the experiment.…

    • 529 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    1. Clean, rinse, and fill a buret with NaOH solution just as you did in last week's experiment. Record the molarity of the NaOH and the initial NaOH volume reading from the buret (+0.02 mL).…

    • 255 Words
    • 2 Pages
    Satisfactory Essays
  • Better Essays

    10 ml of acid was used for all the three trials to keep a constant. During the first trial it took 3.700 ml of NaOH to titrate the HCl, in the second trial it took 3.750 ml, and in the third trial it took 3.750 ml. These differences in amounts of NaOH required to titrate the acid led to different molarities being calculated for the NaOH. The first being 0.270M and the other to being 0.267M. In order to calculate the total volume of base used, the readings from the burette from before and after titration were subtracted from each other. The average of the three molarities was found to be 0.268M for NaOH (Figure 2).…

    • 2337 Words
    • 10 Pages
    Better Essays
  • Satisfactory Essays

    CHEM120 W5 Lab Template 1

    • 414 Words
    • 3 Pages

    Step 3: Fill buret with NaOH, obtain a 50 ml buret and fill with .100M NaOH solution.…

    • 414 Words
    • 3 Pages
    Satisfactory Essays
  • Good Essays

    6.03 Titration Lab

    • 573 Words
    • 3 Pages

    4.) Fill the buret with NaOH. Record the initial volume of the buret in your data table.…

    • 573 Words
    • 3 Pages
    Good Essays
  • Better Essays

    6.03 Calorimetry Lab

    • 1068 Words
    • 5 Pages

    In the experiment, standardization of NaOH with HC1 solution is carried out. Solid NaOH is hygroscopic where significant amounts of water vapor can be absorbed. Also, as NaOH is a strong base, significant amounts of atmospheric carbon dioxide can be absorbed too. It is also clear that NaOH cannot serve as a primary standard and thus it needs standardization by a primary or secondary standard. NaOH solutions can be directly titrated versus standardized HCl using phenolphthalein or methyl red indicator. In this case, methyl red is used as an indicator. The colours change from red to completely purple pink indicate the standardization is achieved. If reasonable concentrations of the acid and base are used, very sharp end points can be achieved. The…

    • 1068 Words
    • 5 Pages
    Better Essays
  • Satisfactory Essays

    6.03 Calorimetry Lab

    • 301 Words
    • 2 Pages

    Once divided by two, that value ended up being 6.815 milliliters of NaOH added at the ½ equivalence point pH. In order to estimate the pH at that volume of NaOH being added, two data points around the volume of 6.815 milliliters were…

    • 301 Words
    • 2 Pages
    Satisfactory Essays
  • Satisfactory Essays

    Chapter 15 16 Worksheet

    • 379 Words
    • 2 Pages

    (d) How many millimoles of solid NaOH must be added to 50.0 milliliters of 0.20 - molar HOCl to obtain a buffer solution that has a pH of 7.49? Assume that the addition of the solid NaOH results in a negligible change in volume. (2 points)…

    • 379 Words
    • 2 Pages
    Satisfactory Essays
  • Satisfactory Essays

    6.03 Calorimetry Lab

    • 237 Words
    • 1 Page

    Then continuing adding 0.5mL aliquots of NaOH into the unknown amino acid solution (A) till volume reaches 21.5mL with pH reading of pH 2.08. At 22mL, decided to add 1mL aliquots of NaOH into the unknown amino acid solution (A) till volume reaches 45mL. It pH reading…

    • 237 Words
    • 1 Page
    Satisfactory Essays
  • Good Essays

    ka lab report

    • 692 Words
    • 3 Pages

    We will be using the LoggerPro and LabPro in order to help us determine our data. The purpose of this experiment is to follow the changes of pH during the titration of an acid and a base in order to determine the of the weak acid, . is a constant for a given acid at a given temperature. In this experiment we determined the Ka using two different methods: 1) the measurement of the pH of a solution containing a known concentration of a weak acid, and 2) measurement of the pH at the half-neutralization point in the titration of a weak acid and a strong base.…

    • 692 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Blah

    • 1432 Words
    • 6 Pages

    Learning Objectives to understand the titration curves for the following solutions • a weak acid: acetic acid, CH3COOH. • • • • • a strong acid: hydrochloric acid, HCl. an acidic commercial cleanser. a basic commercial cleanser. to use the titration curves to calculate the percent of the active ingredients in the commercial cleansers. to determine the Ka of a weak acid. Procedure Overview • • • • after calibration of the pH electrode and determination of the flow rate for the automatic titration, a NaOH solution is standardized against HCl. a pH titration curve for acetic acid is obtained and its pKa is determined. an unknown sample of Lysol is analyzed for its HCl content using the standardized NaOH. an unknown sample of Liquid Plumr is analyzed for its NaOH and NaOCl content using HCl of known molarity.…

    • 1432 Words
    • 6 Pages
    Good Essays
  • Good Essays

    Chem Lab Project 2

    • 2646 Words
    • 6 Pages

    NaOH were added to each centrifuge tube individually and the results recorded. The contents of the…

    • 2646 Words
    • 6 Pages
    Good Essays
  • Satisfactory Essays

    Lab 1 on Ph Levels

    • 521 Words
    • 3 Pages

    Section 1: You will be testing 4 known solutions for pH levels using a standard wide-range indicator. Based off of the results obtained in the lab room, fill in the following table:…

    • 521 Words
    • 3 Pages
    Satisfactory Essays
  • Good Essays

    Transforming Copper

    • 565 Words
    • 3 Pages

    4 a. What test will you perform to determinate when you have added sufficient NaOH solution in Part II?…

    • 565 Words
    • 3 Pages
    Good Essays